Need Help?
Call or text
Fix burners that won't light or spark continuously with this gas range burner igniter electrode. Solves clicking, weak spark, or no-ignition issues.
We replaced both front orifice holders. Very easy to bend and break. If it has a deep bend in it, It will slow down the gas flow to the burner. if you have a low gas flow your burner will burn low So check your small silver gas lines and if you smell gas check your lines Read more
Oven won't turn on after self-clean cycle? A blown thermal fuse is the likely cause. This safety part cuts power when overheated. Moderate DIY repair.
Replaced fuse. It took much longer to get the oven out of the wall to access the fuse and replace the front panel than to do the repair. This fuse failed at the end of the cleaning cycle for the bottom oven and left the door locked because the open fuse removed the 120v power from the control board. The locked door made it impossible to remove one of the screws holding the wall oven in place. However, after I ground off the head of the screw behind the edge of the locked door I was able to... Read more
Burner stuck on high heat or won't regulate temperature? This infinite switch restores precise control. Straightforward DIY repair with a screwdriver.
Took out the old part and installed the new one. Read more
Outer door glass panel for range ovens. Replaces cracked, shattered, or broken exterior oven door glass. Restores door appearance and visibility.
Using the parts I ordered, I replaced the glass myself following the very helpful video on your web site. Read more
Burner orifice controls gas and air flow to cooktop burners. Replace if cracked, corroded, or when converting between natural gas and propane fuel types.
Found the parts I needed ordered them from your site Received them and installed in a few minuets and was done Read more
Replacement gas burner for ranges and cooktops. Restores even flame distribution when original is clogged, damaged, or worn from boilovers and daily use.
Replaced the part and it works great. Thanks! Read more
Oven won't heat or takes too long to preheat? A failed bake element is the most common cause. This lower heating coil restores proper baking temperature.
Replaced bake element to no avail, seeking help with live chat. FYI, order process and delivery time was top notch. Read more
Replace your burned-out range light bulb to restore interior illumination. Swap in when bulb fails to see contents clearly. Verify fit by model number.
I just plugged in a replacement light bulb. Couldn't find one anywhere else but from you folks. Read more
Fix a broiler that won't light or clicks but doesn't ignite. This spark igniter initiates combustion for the upper burner. DIY repair in 10 minutes.
Called a repairman and he told us we needed to change a bunch of parts and would cost over $400! Decided to do some research online and found suggestions to replace the spark igniter. Decided to give it a try. Took about 10min to replace and oven is now working perfectly, for a total of $30! Read more
Adjustable leveling leg installs on the front or rear corners of your range. Replace if broken, cracked, or worn to stabilize and level your appliance.
Installed it according to video watched. Read more
Traps grease particles to prevent buildup on blower and internal components. Replace when clogged or discolored. Verify fit with your model number.
I was just replacing my filter,on my vent. Read more
Replace your cracked or damaged gas range ultra rapid burner head assembly. Installs on the cooktop. Includes ignitor. Ideal for worn or broken burners.
Replaced burners, saved $350, easy and it worked! Read more
Leveling leg assembly installs at the front corners of your range. Replace if broken, rusted, missing, or no longer adjusts to level your appliance.
Bought new leveling leg. Took longer to lay the appliance on the side and pick back up, than to install leg. Read more
Gas burners won't ignite or igniter clicks continuously? The spark module generates the electrical spark to light burners. Direct plug-in repair.
Replaced the ignitor module ( a plug in direct replacement) a monkey could have performed this repair Read more
Microwave won't heat or shows F1E5 error? The inverter regulates power to the magnetron. Intermediate repair, 1-2 hours with full disassembly required.
Replaced numerous items including this Inverter and two control boards but the Magnetron was the ultimate solution. The tip was clearly burned through when I removed the original. Read more
Replace this ignitor orifice assembly if the electrode is cracked, broken, or worn. Installs on gas range surface burners to restore spark ignition.
Installed a new ignitor/orifice assembly. Read more