Ikea Wall Oven Parts

Ordered two gas tubes and replaced them . Read more

I was able to clean the Oven Temp Sensor with 99% alcohol. Then replaced All switches (after breaker was isolated). Put it all back the way I found it. Turned on breaker. Tested all functions and had no reports of Fan Code re-appearing since. Read more

• Door won't open after self cleaning cycle

I knew the door latch was suppose to lock for self clean and it wasn't, so I took the back off and after tracing out wires and the linkage to the door latch, determined that it was a faulty motor on the latch lock. I got on line and Appliance Parts Pros was the first place that I found the part. I was surprised that it wasn't real expensive, but I kept looking for a cheaper price only to come back to order it from APP. I order it around 9:00 on a Thursday night and it was on my front porch... Read more

Found web site. Called the 800 number. Placed the order. 2 days later, they were at my door. Read more

I called a rpair service. The men came to the house, torn apart the stove top and advised Replacement of the wire harness. The trip charge of $100 would be deducted from a repair bill of $350, thus they needed an additional $150 for parts and $100 for labor after paying the trip charge. I bought the harness for $60, and the star bits I needed for my drill for $10. My son and I installed the new harness in about 30 minutes, which included a thorough cleanup, saving us $180. Read more

I ordered the burner cap set. Read more

What you will need: * replacement parts * small and regular Phillips screwdrivers * small wrench * soapy water in a spray bottle or leak detection spray Take apart the top of the stove control unit 1) turn off the gas to the stove, in my case I cannot get to the shutoff valve easily so I ended up turning off the electricity to the stove at the fuse box as that forces an emergency shutdown of the gas supply internally of the stove. 2) remove all 5 knobs, the grates at the top and open the oven... Read more

I had my worker replace the Handle & put the missing foot on! Read more

Looked up the part number for replacing the burner dgrates in the 465 gas oven owner / parts manual. Plugged in the number in your easy to use website. Read over a few FAQs on the part I was ordering that answered my question of yes this is for a set of four. That was very helpful by the way. Ordered the parts and two days later they arrived to my door step. Read more

So initial thought was bad bake igniter. I'bve replaced this before so I replaced it again and it wouldn't glow. Checked broil igniter and same thing, no glow. Checked voltage at molex connector for bake igniter and it went from 6.6v to 3.4v when triggered to glow -- well below the 120v expected. Ordered new clock/controller and overlay -- it shipped the next business day! Removed a handful of screws from the back panel to expose the clock/controller and removed/ replaced it with new... Read more

In an attempt to clean the range from the grease-gunk build-up, I had to remove the burner heads. Unfortunately, the 2 most used burner heads had immovable screws that locked them into the orifices underneath. After numerous hours in attempts to salvage the old burner heads and orifices attempting to remove the immovable screws, I gave up. Checked Maytag's website for parts and found nothing. Turned to AppliancePartsPros.com and found the correct parts for reasonable price in a matter of... Read more

Replaced ignitor. Watch the u-tube videos for removing and replacing the board and ignitor. Read more

Took apart the top of the stove and replaced ignitor Read more