Parts for Kitchenaid KDFE104HBS0: Inner Door Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This factory screw secures panels, brackets, or components within your appliance. Using the correct OEM fastener helps ensure a snug fit and prevents loosening, rattling, or misalignment over time.

• Fastens metal or plastic components to maintain proper alignment
• Helps prevent vibration, noise, and loosened parts
• Common wear item that can strip, rust, or go missing
• Replaces damaged or missing hardware to restore secure mounting

• Disconnect power and shut off water or gas before service
• Note original screw location and orientation for proper reassembly
• Start threads by hand to avoid cross-threading; do not overtighten
• If threads are damaged, inspect the mating hole or clip before reuse

Stainless steel screw that secures the back panel to the side panel of your dryer cabinet. Replace if screw is stripped, missing, or corroded.

Replace your dishwasher's damaged or cracked inner door panel. This structural component forms the interior surface of your door assembly. Essential when worn.

Seals the bottom of your dishwasher door to prevent leaks during wash cycles. Replace if water pools on floor or seal appears flat or worn. Confirm fit.

Prevents water leaks around your dishwasher door during wash cycles. Replace if you notice moisture, dripping, or pooling water at the base of the door.

Dishwasher not dispensing soap or dispenser door won't open? This detergent dispenser fixes dispensing failures. Moderate DIY repair, about 30-45 minutes.

Fix your dishwasher that won't start or has no power with this wire harness assembly. Restores electrical connections between control and components.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.