Parts for Kenmore 665.15867990 (66515867990, 665 15867990): Inner Door Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Fix a detergent dispenser that won't open or close properly with this latch kit. Includes all components for secure closure. 10-15 minute repair.

Detergent cup dispenser actuator assembly.

Fix rinse aid leaking from your dishwasher dispenser with this wet agent dispenser assembly. Moderate DIY repair requires inner door panel removal.

The Dispenser Lid is an OEM replacement part for Whirlpool dishwashers. Located at the top of the dishwasher door, it provides access to add detergent and rinse aid to the internal dispenser compartment below.  This dishwasher soap dispenser lid is included in the dispenser cover kit 4387043.

Causes of a bad dispenser lid can include wear and tear of hinge points from years of repeated openings. Cracks may also arise in the plastic material.

Symptoms of a bad Dispenser Lid include:

• Difficulty fully opening or closing the lid securely
• Leaks or spills occurring from around the sealing edges
• Potential cracks that compromise lid integrity or function
• Hinges that are loose or fail to support the lid in position

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Amana, and some Kenmore models.

Fix a detergent lid that won't stay closed or open properly with this dispenser lid pin. Simple repair with video guide—most DIYers complete in minutes.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This vent screen covers the dishwasher door vent, allowing steam to escape while blocking food particles and debris. Replacing a damaged or missing screen helps maintain proper airflow and can reduce moisture and odors around the vent area.

• Screens the door vent to keep debris out of the vent duct and fan path
• Maintains airflow for venting steam during the dry cycle
• A clogged, cracked, or missing screen may lead to moisture at the vent, odors, or reduced drying performance
• Replace if warped, broken, or lost during service

• Disconnect power to the dishwasher at the breaker before servicing
• Open the door and remove inner-door screws to access the vent assembly
• Remove the old screen, seat the new screen fully and evenly, then reassemble without overtightening
• Run a short cycle and check the vent area for proper airflow and moisture

Covers the rinse aid dispenser compartment on your dishwasher door. Replace if cracked, broken, missing, or won't stay threaded properly.

This replacement screw secures appliance panels and components so they stay tight and aligned. Replace a missing, rusty, or stripped fastener to restore a solid hold and reduce vibration or rattling during operation. What it does:

• Fastens and secures panels, brackets, trim, or internal components as specified for your model
• Replaces missing, corroded, or stripped hardware to restore a proper fit
• Helps prevent vibration, rattling, and misalignment caused by loose fasteners
• Addresses issues like a loose panel/handle or a screw head that's rounded off

• 1 screw

• Disconnect power; if applicable, shut off gas and water before servicing
• Use the correct driver size; start by hand to avoid cross-threading
• Tighten snugly—do not overtighten into plastic or thin sheet metal
• Keep track of original screw locations and lengths during reassembly

Comes with seal.

Felt seal that fits around your dishwasher's door vent to contain steam and moisture. Replace if you notice condensation or minor leaks during cycles.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.