Parts for Kenmore 665.13402N413 (66513402N413, 665 13402N413): Inner Door Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

The Hex-Head Screw is an OEM replacement part for use in Whirlpool dishwashers. This metal screw measures approximately ¾ inch long. Its primary purpose is to secure the dispenser bracket in place, ensuring stable operation. This hex-head screw is designed for use with compatible hexagonal tools. This makes installation and removal straightforward. This part is sold individually and is guaranteed to fit your dishwasher door panel. This screw is compatible with select Whirlpool brand models including Amana, Crosley, Estate, Inglis, Jenn Air, Kenmore, Kitchen Aid, and Maytag.

Seals the bottom of your dishwasher door to prevent leaks during wash cycles. Replace if water pools on floor or seal appears flat or worn. Confirm fit.

Replace your dishwasher's damaged or cracked inner door panel. Restores the interior door surface when the original is broken, warped, or worn.

Directs steam and moisture out during the drying cycle. Replace if dishes stay wet or water drips from vent. Confirm fit with your model number.

Steam escaping from door or dishes not drying? The vent assembly expels heat and moisture during cycles. Moderate DIY repair, takes about 15 minutes.

Replace your dishwasher's inner door seal to stop leaks and contain wash water. Installs between door liner and panel. Confirm fit with your model number.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Trim piece that frames the vent opening on your dishwasher door. Replace if the original bezel is cracked, loose, or missing to restore a finished look.

Soap not dispensing or lid won't open during cycle? This dishwasher dispenser assembly releases detergent and rinse aid at the right time. Moderate DIY.

This wire harness routes power and control signals between the appliance's control board and internal components, restoring reliable electrical connections for responsive operation and proper control function. What it does:

• Transfers power and low-voltage signals between the control board and motors, sensors, valves, lights, or switches
• Replaces damaged or corroded wiring that can cause intermittent or no power to components
• Commonly used when controls, lights, or certain functions stop responding or behave erratically
• Helps prevent shorts and poor connections from causing faults or error codes

• One replacement wire harness

• Disconnect power at the breaker or unplug the appliance before starting
• Document wire locations or take photos before disconnecting to ensure correct reconnection
• Route harness to avoid pinching, sharp edges, or heat sources; secure with existing clips or ties
• If exposed wires or connector damage is found at both ends, inspect mating components for damage before powering up

Fixes loose panels, rattling doors, or wobbly components caused by stripped or missing screws. Secures brackets, covers, and mounting hardware. Easy DIY.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.