Kenmore / Sears Freezer Parts

Replaced the control panel and evaporator fan. Read more

I originally ordered the Fan motor from a appliance dealer. I waited for 5 days for it to arrive. In the meantime I scavenge a motor from a junk refrigerator from the dump. It worked while I waited for the motor from the appliance dealer. When I picked it up 5 days later it was the "wrong" part. I was fuming mad. I went online and found you guys and ordered the correct parts in 5 minutes. It arrived in 1 day and a half, "COOL" ! The repair went quick and smooth and now the refrigerator runs... Read more

• Ice maker won't dispense ice
• Ice maker not making ice
• Leaking

After about three months of returning to my youth, filling ice cube trays, I decided to venture into the freezer and yank the old ice maker from its mounting. Since this was the third time this very ice maker had decided to stop functioning, it was time to get a replacement. I suspected the heating element was open and the motor was screaming trying to push the little frozen blocks of ice from their form, with distortion occurring. I ordered a replacement from this very company, received it... Read more

• No hot or cold water
• Will not fill with water
• Will not stop filling with water
• Noisy

1. Sleeve for input, Injector valve, nozzle and seal for input fixed this problem. Probably the main part that was the trouble was a deformed Injector Valve which is a rubber tube with an internal retention groove at the wide part that grips the Nozzle. The Sleeve and the Nozzle are hard plastic parts that basically looked fine, but I replaced them anyway while I was in there. Additionally I replaced the rubber Seal for Input which seals the plastic input fitting to the tub just to make sure... Read more

REPLACED THE LIGHT/LAMP SWITCH. Read more

• Noisy
• Freezer section too warm
• Fridge too warm

Replace evaporator fan motor located in freezer compartment Read more

Replaced both The electrical board I found under the fridge was very easy to replace. The fan motor took a minute to bed puns and the biggest challenge was taking off/on the back panel to get to it. (By the way it was located in the freezer section. take drawers out to get to it. Read more

Purchased new gasket from your site. Watched the video for how to change it.Took about 15 min. to remove the old one and install the new one. Read more

Ordered a new seal, and replaced it with a new one freezer works great now. Read more

I ordered a replacement handle and screws. The process was very easy with the help of one of your "pros" who found all the parts needed and took my order. I didn't realize I was getting both a refrigerator door handle and a freezer door handle in one set, but now we have the freezer handle if we need it. Removing the old handle and installing the replacement was very easy. It looks great, in fact the replacement is metal, whereas the original was plastic, so it looks better than it ever did! Read more

Replaced It With New One Read more

In short - I replaced the evaporator fan motor and the evaporator fan blade. The Appliance Parts Pros website was extremely helpful to me. Here's how. 1. The site helped me identify that even though my Freezer says it's a Frigidaire, it's actually an Electrolux. 2. The site identified the potential screech causing parts. (I didn't take a chance, I bought all three) It was a worthwhile investment. My freezer is 20 years old so it deserved some help. 3. The site provided guidance videos (not... Read more

• Frost buildup

Arrived on time and was a good fit. no problems at all thank you Read more

• Freezer too cold
• Freezer not defrosting
• Fridge runs too long
• Fridge too cold

My Frigidaire side by side refrigerator/freezer suffered a catastrophic failure. The symptoms were as follows: 1) Frig not cold 2) No Ice being made in the freezer section 3) Items at the back of the freezer were frozen but items on the door shelves would not freeze. The back of the freezer was cold but the closer you got to the door the warmer it got. After removing everything from the unit I saw that there was substantial ice buildup on back of the freeze, specifically around the vents,... Read more

I look on the internet i came a cross appliance parts pros i didnt no what i was looking for so i call the phone number talk to someone gave him the info he ask for they has what i was looking for in stock the guy was very nice he say i will get the part in two days and i got it in two days if i need a part for anything else i will ckeck out appliance parts pros when the door gasket came my grandson put it on in a flash Read more

Repair took 20 minutes - 1 minute to set the new, non-broken shelf in place, and then 19 minutes teasing my spouse about the fragility of glass and multiple repetitions of the phrase "This is why we can't have nice things!" Probably worthwhile to program in 10 additional minutes to allow you to apologize to your spouse for ridiculing them for an honest mistake:) Read more