Kenmore / Sears Microwave Parts

Mounting screw for microwave assembly. Secures internal or external components. Replace if stripped, missing, or damaged during repair or installation.

This coffee maker assembly replaces a faulty built-in coffee brewing unit to restore brewing and dispensing in compatible refrigerators. It installs into the fridge's beverage area and returns normal coffee brewing operation when the original fails. What it does

• Replaces the refrigerator's internal coffee brewing unit to allow normal brew cycles.
• Restores proper water flow and heating when the existing coffee maker is not brewing.
• Stops intermittent brewing or complete failure to dispense brewed coffee.
• Helps address leaks or pooling under the brew area when the internal unit is cracked or damaged.

• One coffee maker assembly

• Disconnect power and shut off water supply before starting work.
• Remove the refrigerator beverage panel per service manual to access the unit.
• Handle the assembly and fragile fittings with care to avoid damage to tubes and connectors.

Replacement mounting screw for microwaves. Secures panels, brackets, and interior trim to the frame. Needed when original screws are stripped or missing.

This fuse holder secures and connects a replaceable inline fuse to the appliance's electrical circuit, restoring overcurrent protection and helping prevent damage from short circuits or power surges. What it does:

• Holds and connects a replaceable fuse in the appliance's electrical circuit
• Completes the fuse's electrical connection so current flows through the protective element
• Replaces a cracked, burnt, or loose holder that causes intermittent power or blown fuses
• Helps restore proper overcurrent protection when the fuse itself is intact

• Disconnect power to the appliance before inspecting or replacing electrical parts.
• Inspect nearby wiring and connectors; replace any damaged components to ensure a secure connection.

Support plate for microwave installations. Mounts inside the cabinet or chassis to provide structural reinforcement. Replace if cracked, broken, or missing.

Leveling leg that installs at the base of your range to provide stable, adjustable support. Replace if the foot is cracked, broken, or missing.

Replacement foot for countertop microwaves. Installs on the bottom to support and level the unit. Order if your original foot is cracked, broken, or missing.

This is a replacement screw used to secure appliance components and panels so assemblies stay stable and aligned. It provides a straightforward fix when a mounting fastener is missing, stripped, or damaged. What it does

• Secures panels, brackets, or trim to prevent movement and vibration
• Stops rattling or loose parts caused by missing or damaged screws
• Restores proper fit and alignment of the affected assembly
• Works wherever the OEM-designated screw of this size and thread is required

• Turn power off or unplug the appliance before working on electrical areas
• Use the proper-size driver to avoid stripping the head
• Start threads by hand, then tighten until snug — do not overtighten
• If the original screw is corroded or the hole is damaged, inspect mating parts for repair before installing

This assembly combines a humidity sensor and thermostat used in over-the-range microwaves to detect moisture and temperature levels during cooking. The humidity sensor enables auto-cook and auto-reheat features by sensing steam released from food, while the thermostat monitors internal temperature for safety. Replace this part if your microwave no longer accurately auto-cooks or auto-reheats food, runs too long or shuts off too early, or if you get error codes related to sensor functions.

Prevents magnetron overheating in your microwave. This cavity over-temperature thermostat shuts off power when temperatures exceed safe limits.

Replacement mounting screw secures exterior panels, trim, or internal components. Needed when original fastener is missing, stripped, or damaged.