Kenmore / Sears Range Endcap Parts

Color: White

This cap fits over the appliance housing connection to protect and seal the joint, helping prevent leaks and contamination. It restores a finished appearance and helps keep internal components clean and functioning properly. What it does:

• Covers and protects a connection point or fitting from dirt and debris
• Provides a simple seal to help reduce minor leaks or drips at the joint
• Helps secure a hose or fitting in place and prevents loosening from vibration
• Common symptom: visible crack, missing cap, or water weep/soiling near the connection

• Disconnect power and shut off the water supply before replacing parts on refrigerated appliances.
• Verify the cap matches the connection shape and snaps or slides fully into place.
• Use basic hand tools only; avoid forcing the cap to prevent damage.
• Inspect surrounding seals or fittings and replace if damaged.

Black right endcap for ranges. Covers and protects the end of the control panel or trim. Replace if cracked, broken, discolored, or missing.

Endcap for electric ranges. Covers and protects the end of a trim or component. Replace if cracked, broken, or missing to restore appearance.

Endcap panel that covers and finishes exposed edges of range control or cabinet panels. Replace if cracked, broken, or missing to restore appearance.

Replace the right side endcap on your range. This exterior trim piece covers the end of the appliance. Order a new endcap if yours is cracked or missing.

Left side end plate for ranges. Replaces cracked, broken, or missing endcap trim. Installs on the left exterior side panel to complete appearance.

This left-side bisque end cap finishes and protects the refrigerator door edge, restoring a clean appearance and helping keep the door trim secure. It's a direct-fit replacement for worn, cracked, or broken end caps. What it does:

• Covers and protects the outer edge of the refrigerator door trim on the left side
• Restores a finished appearance when original trim is cracked, broken, or missing
• Helps keep door components and seals neatly aligned and supported
• Compatible with factory door trim to maintain proper fit and gap

• Read the appliance manual before beginning; unplug the appliance or turn off power to the unit when instructed by the manufacturer
• Remove any damaged trim carefully to avoid scratching the door finish
• Align the end cap with the door edge and snap or fasten per factory attachment points; use gentle pressure to avoid cracking
• If clips or screws are required, reuse original hardware or replace with OEM-specified fasteners