Kenmore / Sears Wall Oven Terminal Block, Receptacle Parts

This kit includes a surface element receptacle block and wiring harness that connects a burner element to the range's electrical system. It transfers power from the terminal block to the heating element on the cooktop. Replace this kit if your surface burner heats intermittently, fails to heat at all, or you see scorching or burn marks around the receptacle connections.

Replacement wiring harness that connects control electronics to internal components, restoring proper electrical connections and reliable operation. Use when factory wiring is damaged, loose, or causing intermittent component failures. What it does:

• Routes power and signal between the appliance control board and internal components.
• Restores continuity when broken, frayed, or corroded wires cause intermittent or no operation.
• Can resolve symptoms such as non-responsive controls, lights or fans not running, or intermittent component operation.
• Keeps wiring neat and secured along original routing to prevent rubbing and stress.

• Always disconnect power (unplug or shut off breaker) before starting any repair.
• Match connector shapes and pin counts; route harness along original clips and pathways to avoid pinch points.
• Inspect mating connectors and terminals for damage or corrosion before reconnecting.

The Terminal Block is an OEM part for GE electric ranges. It serves as a critical junction point where the range's wiring connects to the heating elements, ensuring proper electrical flow and operation of the oven and cooktop. This component is essential for the safe and efficient functioning of your appliance.

Causes of a bad terminal block can include overheating due to electrical surges, corrosion from prolonged exposure to heat and moisture, or physical damage from improper installation or handling.

Symptoms of a bad terminal block include:

• The oven or burners not heating properly
• Visible signs of burn marks or corrosion on the block
• Electrical arcing or sparking
• Intermittent or no power to the heating elements

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Burner not heating or works intermittently? This receptacle block connects the heating element to power. Typical DIY repair takes about 1 hour.

Burner not heating or heating intermittently? This surface element wire harness connects switches to heating elements. DIY repair takes about 30 minutes.

Fixes arcing, intermittent power, or complete failure caused by a damaged terminal block. Restores safe electrical connections in your cooktop or range.

This fuse holder secures and connects a replaceable inline fuse to the appliance's electrical circuit, restoring overcurrent protection and helping prevent damage from short circuits or power surges. What it does:

• Holds and connects a replaceable fuse in the appliance's electrical circuit
• Completes the fuse's electrical connection so current flows through the protective element
• Replaces a cracked, burnt, or loose holder that causes intermittent power or blown fuses
• Helps restore proper overcurrent protection when the fuse itself is intact

• Disconnect power to the appliance before inspecting or replacing electrical parts.
• Inspect nearby wiring and connectors; replace any damaged components to ensure a secure connection.

Fix a range that won't power on or has intermittent electrical issues with this terminal block receptacle. Connects power cord to range circuitry.

Fixes no power or intermittent operation caused by loose electrical connections. This internal power receptacle restores secure contact in your oven or microwave.

This receptacle is the appliance electrical connector that provides a secure plug-in point for a wiring harness or component, helping restore reliable power transfer and proper operation. What it does

• Provides a secure electrical connection between a wiring harness and the component it serves
• Restores a solid plug-in interface when a connector is cracked, loose, or corroded
• Can cause intermittent power, component failure, or no power when worn or damaged
• Designed to mate with the matching harness or component socket for a stable connection

• Disconnect power to the appliance before inspecting or replacing the receptacle.
• Handle wiring and terminals carefully; avoid bending or damaging pins during installation.
• Ensure the mating connector is fully seated and any retaining clips or fasteners are engaged.