Lg Refrigerator Dispenser Parts

Unplug refrigerator. Use non marring (plastic trim stick) tool to gently pry loose the plastic assembly containing the PCB display beginning at the lower edge and proceeding around the outer edge. Disconnect all connectors and note the routing of each wire harness and connector (take pictures on cellphone as necessary). Remove two screws holding inner PCB mount bracket in place to expose actuator, flapper door and linkage. Replace actuator (three mounting screws) and ensure that actuator... Read more

Ordered the entire control panel. Took only 30 minutes to replace. Once I received the new part, it was obvious how easy it would be to replace. A thin putty knife and a little care not to damage the surrounding surface was all that was needed. Read more

Very helpful video from a link on your website (https://www.youtube.com/watch?v=EBIv0bxEhkE), and saved me a major repair bill. My journey started with an effort to replace just the water dispenser button, which failed because the fifth post on the back side of the button (not the four posts which hold the button in place--it's the extra rectangular piece visible near the repairman's pinkie finger at 3:04) had broken off, and it is this piece which reaches and moves the actuator for the water... Read more

The ice chute flap wasnt closing. 1. I turned off power 2, Pulled off facia around controls on freezer door,, you have to pull out the bottom part of the chute first , its clipped in 3. Disconnected the front panel 4. Unscrewed the next panel to allow access to the chute flap 5. Removed 1 screw holding complete flap and mechanism and replaced with new 6. Re installed all parts in reverse Problem was the chute flap had worn and was folding over on top edge when opened and then wouldnt return... Read more