Maytag Dryer Parts

This genuine replacement wheel helps support and guide the dryer drum so it spins smoothly and quietly. Restores stable drum rotation to reduce rubbing, wobble, and noise from worn or damaged support hardware. What it does:

• Supports the dryer drum at the rear or front bearing to maintain proper alignment
• Helps the drum rotate smoothly to prevent scraping and uneven wear
• Reduces vibration and squealing caused by a worn or broken wheel
• Works with the dryer's axle/shaft and housing to stabilize drum movement

• One wheel as shown

• Disconnect power before starting any repair to avoid electrical shock
• Remove the dryer front or rear panel per the service manual to access the wheel
• Inspect related parts (axle, bearing, clips) and replace if damaged for best results
• Use hand tools and avoid forcing parts; follow the manufacturer's instructions

Molded elbow connector that redirects dryer exhaust to your home vent duct. Replace if cracked, loose, or leaking to restore a secure connection.

Adjustable periscope vent for dryers with limited clearance. Installs between dryer exhaust and wall port. Replace if cracked, damaged, or missing.

Dryer rack holds delicate items flat inside the drum for air-drying without tumbling. Replace your cracked, broken, or missing rack to safely dry shoes, sweaters, and toys.

Retaining clip secures panels and assemblies in dishwashers, dryers, and laundry centers. Replaces worn, broken, or missing clips to restore fit.

Non-corrosive silicone adhesive sealant for appliance repairs. Replace cracked or missing seals on door panels, trim strips, and interior edges.

Sealer for refrigerant line insulation.

Replace a cracked, broken, or missing drum baffle inside your dryer. This lifter installs on the drum wall to help clothes tumble evenly during cycles.

Replaces the cabinet back panel on your dryer. Needed when the original is cracked, damaged, or missing. Covers internal components and restores enclosure.

Adjustable periscope vent for tight dryer installations. Extends 18-29 inches to connect 4-inch dryer vent to wall exhaust in close quarters.

This drum hole plug seals an unused or service access hole in the dryer drum to help prevent clothing snags and reduce interior airflow leaks. Simple replacement restores the drum surface and helps keep items from catching. What it does:

• Covers a drum access/service hole to provide a smooth interior surface
• Prevents fabric from catching or tearing on open drum holes
• Reduces unwanted air leakage through the drum
• Helps maintain normal drum rotation contact points by keeping openings closed

• One drum hole plug

• Disconnect power to the appliance before starting any repairs
• Inspect the drum area and remove any debris before installing the plug
• Press or snap the plug into the hole until fully seated; replace if damaged or deformed

Touch-up paint kit for dryers and washers. Restores painted finish on chipped, scratched, or scuffed surfaces. Blends repaired areas seamlessly.

Replaces the front bulkhead section of your dryer drum. Needed when the drum front is cracked, dented, warped, or damaged, affecting tumbling performance.

The Bulkhead is an OEM component for Whirlpool dryers. As a structural panel, it secures the rear of the appliance while enabling airflow behind sliding doors. 

Formed from durable composite, the lightweight bulkhead installs easily into precise slotted tracks inside the chassis. This allows full retraction during maintenance without removing additional panels. 

Causes of a faulty bulkhead can include cracked welds or screws stripping their anchors from extreme force vibration over many years of use.

Causes of a bad bulkhead can include:

• Noisy rattling and resonance as the dryer operates  
• Restricted door movement from misalignment
• Inability to fully access internal components  
• Excessive ducting leaks from gasket compression failure

Replace yours with this genuine Whirlpool bulkhead to restore smooth, tight operation. Compatible with Kenmore, Maytag, and KitchenAid dryers.

Color: Citrine white. Size: 0.6 fl.oz. Bottle with brush.