Parts for Electrolux EWMGD65HTS0: 09 - Motor Parts

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic

Replacement screw for securing dryer trim, panels, and interior components. Needed when original fastener is lost, stripped, or damaged during repair.

Dryer won't start or shuts off mid-cycle? This thermal fuse cuts power when overheating occurs. Common fix for E63, E66 errors. DIY repair under 1 hour.

Dryer not drying or taking too long? A worn blower wheel reduces airflow, causing poor drying performance. Moderate DIY repair in 30-45 minutes.

Fix dryer heating issues with this thermistor temperature sensor. Solves intermittent heat, cycle errors, and poor drying. Easy DIY repair.

Threaded fastener that secures and spaces dryer components. Replace if the original spacer screw is missing, stripped, or damaged during repairs.

Transfers motor power to rotate the drum. Replace if dryer hums but won't spin or makes squealing sounds. Verify fit with your model number.

Secures the dryer motor in proper position for stable operation. Replace if motor shifts, buzzes, or clamp strips out. Confirm fit with your model number.

Dryer won't spin or makes loud buzzing noise? This drive motor rotates the belt to spin the drum. Moderate DIY repair with basic tools needed.

Mounting bracket that secures panels and internal assemblies in your dryer. Replace if cracked, broken, or missing to restore proper fit and alignment.

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic

Replacement mounting nut for dryer assemblies. Secures components and panels in place. Order a new nut if yours is stripped, missing, or damaged.