Mtd String Trimmer Parts

Trimmer won't start or pull cord doesn't retract? This recoil starter assembly drives the engine's combustion process for hand starting your trimmer.

Ignition coil module for gas line trimmers. Mounts to engine block to generate high-voltage pulses for spark plug. Replace if cracked or damaged.

Ignition coil module assembly for gas string trimmers. Mounts to engine block and connects to spark plug. Replace if cracked, damaged, or contacts are worn.

Ignition module for gas leaf blowers and line trimmers. Mounts to the engine to control spark timing. Replace if cracked, damaged, or missing.

This short block assembly is a genuine MTD part, sold individually. This short block assembly can be used as a replacement part for a string trimmer, a tiller, or an edger. The short block includes the crankshaft, piston, rod, camshaft, valves, and governor. A short block assembly might be necessary if there is damage to a wide range of parts in the equipment's engine. Check for frequent stalling, misfires, or an inability to power on. Remember to always wear gloves when handling, repairing, and operating outdoor equipment. This is an OEM part sourced directly from the manufacturer, and it is sold individually. This short block assembly is compatible with the following brands: MTD, Craftsman, and Cub Cadet.

Complete carburetor assembly for gas string trimmers. Mixes air and fuel for engine combustion. Replace if cracked, corroded, or leaking fuel.

Replacement fuel cap for lawn tractors, trimmers, blowers, and tillers. Prevents fuel leaks and evaporation. Replace if cracked, broken, or missing.

Inner spool reel for gas line trimmers. Holds and feeds trimmer line during operation. Replace if cracked, worn, or damaged to restore proper line feeding.

Replacement throttle trigger spring for gas line trimmers. Installs inside the throttle trigger assembly. Needed when original spring is broken or missing.

Rope won't retract after pulling? This recoil starter spring restores proper rope tension in lawn equipment engines. Essential starter assembly component.

This is a bushing made from black plastic with a cleft down the middle to provide enough flex for easy insertion. It has a flanged design, which means it won’t easily pop out after installation, even under stress from constant vibration. The bushing’s primary purpose is to protect wires and cables from damage as they pass through a channel. As such, the material is fairly durable and does not need to be replaced under ordinary circumstances. That said, there are some situations in which it can become damaged. For one thing, it’s easy to damage while repairing the wires or cables that run through the bushing. If the bushing does need to be replaced, it requires disconnecting any cables or wires that run through the bushing. Pop out the old bushing with a rubber mallet, install the new bushing the same way, reconnect the wires, and the repair is complete. This is an OEM part sourced directly from MTD, and it is sold individually. It was initially used on snowblowers but has also been used on lawnmowers and lawn tractors.

Reel spool assembly for gas line trimmers. Holds and feeds trimmer line during operation. Replace if spool is cracked, worn, or missing components.

Idler bracket assembly for gas line trimmers. Supports the idler arm and maintains proper belt tension. Replace if bent, cracked, or broken.

Replace this carburetor-to-muffler gasket when you notice exhaust leaks or loss of engine performance. Confirm fit with your tiller model number.

Replace a damaged or worn control cable for your wheeled gas line trimmer. Installs to enable forward propulsion and stopping control functions.