Parts for Kitchenaid KEBC167MSS02: 01 - Oven Parts

Left side trim panel for electric wall ovens. Replaces cracked, broken, or missing stainless steel trim. Installs on left edge of oven cavity.

Right side decorative trim panel for electric wall ovens. Replaces cracked, scratched, or missing stainless steel trim. Secures with screws to rails.

Left side hinge receiver bracket for wall oven doors. Mounts inside the oven frame to hold the door hinge in place. Replace if cracked or deformed.

Door hinge receiver for wall ovens. Mounts inside the oven frame to hold the door hinge in place. Replace if cracked, deformed, or causing door alignment issues.

Small cushioning bumper that installs on range doors or panels. Replaces worn, cracked, or missing bumpers to reduce noise and ensure quiet closing.

Black screw that secures the refrigerator side trim or finish panel. Replace if screw is missing, stripped, or damaged to restore a snug fit and clean look.

Vent tube for wall ovens and ranges. Directs hot air from the oven cavity through the exhaust opening. Replace if cracked, damaged, or missing.

Light assembly illuminates your oven cavity during cooking. Replace if light stays off, lens cracks, or wire connection breaks. Verify fit by model number.

Illuminates oven cavity for monitoring food while cooking. Replace when bulb burns out or oven interior is dim. Verify fit with your model number.

Restores a tight seal between your oven door and cavity to maintain proper temperatures. Replace if you notice heat escaping or uneven cooking. Confirm fit with your model number.

Missing or damaged ground screw can prevent proper electrical bonding. This 8-32 thread screw restores chassis grounding during installation or service.

Replacement mounting screw for securing range panels, brackets, and internal components. Replace missing, stripped, or rusted screws to restore fit.

Size: 8-18 x 3/8 inch.

Replacement spacer cap for ovens and ranges. Installs to maintain proper spacing between components. Order a new cap if your original is cracked or missing.

Right side rail trim for electric wall ovens. Replaces cracked, broken, or missing side rail trim panels. Structural support component for oven cavity.

Left side rail trim for ovens and ranges. Replaces damaged, cracked, or missing side rails along the interior oven cavity wall. Essential cosmetic part.

If your oven door won't lock, stays locked after self-clean, or shows door lock errors, this door lock motor and switch assembly often solves the issue.

Heating element not working? This mounting screw securely fastens the heating element in place. A simple DIY repair that takes about 20 minutes to complete.

Mounting bracket that secures the bottom trim vent on your wall oven. Replace if the bracket is bent, broken, or missing to properly secure trim pieces.

Right and left hand side.

Mounting screw for securing trim, hinges, drawer guides, and interior components. Replace if missing, stripped, or broken during repair or maintenance.

Oven won't heat properly or overheats? A faulty temperature sensor may be the cause. Simple 15-minute DIY repair with basic tools and our video guide.

Secures washer door handles to the outer panel. Replace if stripped, missing, or damaged to restore a tight handle fit and prevent loosening.

Oven won't heat after self-clean cycle? A blown thermal fuse cuts power when temps spike. Easy DIY fix—disconnect power, test with multimeter, replace.

Secures the oven door gasket for a tight seal, preventing heat loss. Replace if gasket is loose or heat escapes. Confirm fit with your model number.

Replace a damaged or missing back cover panel that exposes internal components. This rear access panel protects wiring and controls from debris.

Replacement mounting screw for securing panels, brackets, covers, and trim pieces in appliances. Restores fit when hardware is missing, stripped, or lost.

Secures and stabilizes oven panels and internal assemblies. Replace if cracked, bent, or missing to restore proper alignment and prevent sagging or vibration.