Kenmore Refrigerator 106.58716803 (10658716803, 106 58716803) Parts

A YouTube video: https://www.youtube.com/watch?v=jIdtNdDXFDk , by a professional appliance repair company described replacement of the freezer drain pipe with Kenmore's (by Whirlpool) revised drain pipe. Ice buildup inside the freezer was caused by warm air beneath the freezer contacting cold air from inside the freezer the resulting condensation freezing and blocking the drain, causing the ice buildup inside. The revised drain tube functions as a p-trap to prevent cold/warm air interaction.... Read more

I replaced the pads on my Kitchenaid side-by-side. I was able to order ones that looked exactly like the old ones. It was even easier than what I had seen in a YouTube video. Read more

Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on... Read more

I replaced the driveshaft and the latch on the ice bin as well as the washer that prevents moisture and water from getting down the driveshaft and into the motor. It was an easy job, especially with the video. Read more

Replaced tired motor and chute door seal plate... Through outside of unit door - I have worked in the appliance repair field for years Read more

I decided if one needed replacing I might as well both two--made sense to me. None were available locally so I ordered them on-line. Surprisingly they came sooner than I expected. I also found a video on the internet that clearly showed the procedure. The actual repairs took 15 minutes or less. One good suggestion from the video was to run the screw in and out of the wheel bracket before final mounting. The video also suggested putting something under the corner to eliminate tipping. The... Read more

Put the new hinges on the doors fyi you need to tell what size the screws are for the hinge kits would help a lot Read more

Rather than fighting the set screw, I ordered a new handle and extra parts to fix it. My father taught me to use anti seize which I used on all the threaded materials. Appliance parts and all the parts listed easy to see and Order Read more

I had to remove a metal panel at the bottom back of the freezer as well as a couple of shelf slides in order to get at a drain pan in the back. It was frozen solid, so I stabbed at it with an ice pick until I broke through, followed up by poking a coat hanger in the drain hole to clear as much as I could, then poured a little boiling water over it to follow up. After screwing it all back together, the ice maker surprisingly was working again in less than 20 minutes. I also replaced a broken... Read more

Replaced both sets of door cams on my Kenmore Elite Refrigerator. The most important thing to know is that you DO NOT have to remove the doors from the refrigerator to replace BOTH sets of cams. You just have to remove the lower grill which is a snap fit (I also turned off the water and unplugged the unit). My fridge has an ice and water dispenser where the water and electrical lines go through the cams on the left side. Be sure to order the correct parts as the cam holes on the freezer side... Read more

• Light not working

We actually were able to determine that one of the freezer switches was bad and taped it down for about 3 days. The beeping stopped. Our fridge has two freezer switches and one fridge side switch. I ordered all three from these guys. They were cheaper than Whirlpool by about $20 for parts and about $15 for shipping. The part numbers had superseded too many times to count, usually that doesn't matter but in this case it did. The new parts were just slightly bigger than the old parts AND... Read more

By replacing the ice maker after trying the electronic boards and water infill valve first. Your people were incredibly helpful. Read more

The video was great - followed the instructions - replaced the parts - icemaker is working like new now. Read more

Replaced bad condenser motor Read more

Ordered new Evaporator part and Drier from Appliance Pros. The part arrived earlier than expected and was properly packaged. I had both parts installed by a professional as they required a level of expertise above my capabilities. Works perfectly. Read more