Kenmore Dryer 110.7208350 (1107208350, 110 7208350) Parts

Replaced ignitor with a new one. Should have tested old one before installing. New one did not work either. Traced problem back to defective thermo fuse by testing with a multimeter and found circuit open. Bought a new fuse and replaced. Ignitor cycling as designed now. Apparently fuse failed due to excessive heat. I will also replaced dryer vent hose and and clean out vent line. Read more

I took it apart and cleaned and lubricated the rear support rollers and the belt pulley roller. I think the squealing was coming from the pulley roller. I then replaced the rear felt as it was badly deteriorated. The dryer now runs much more smoothly and quietly. Read more

I undid the top with a putty knife, took out two screws and took off the front. I replaced the drum rollers and put the new belt on the drum, looped the belt on the idler and then onto the motor pulley. I also put on two new top hold down clips as the old ones broke because they were plastic, the new ones were metal. I took off the back panel and replaced the heating element. The hardest part was cleaning up all of the lint and dirt that had accumulated over the years. It was not difficult,... Read more

After shopping for a new Whirlpool Thin Twin Stack, Found appliance parts pros online and decided to take it apart to see if repair was a possibility. APPro's online instructions were easy to follow, in a couple hours it was apart, and I placed the order. Reg ground took a week from NY, so the laundry piled up that week. The parts arrived on Monday morrning, by afternoon the machine was running like new! The cause was the belt tensioner pulley had frozen. Replaced it, drum wheels,snap... Read more

I ordered two replacement baffles and screws, then lifted the top of the dryer to access the drum and installed the two new baffles. Read more

I looked inside and saw the teeth were worn off the "dogs" so I purchased the Cam Agitator repair kit and a new bolt. Getting the old bolt out was the hardest part since it was worn and rusted. I ended up having to buy a set of socket extensions and a set of stripped bolt sockets so $45 in tools and it took me an hour to get the old bolt out but putting everything back together was a breeze. I was very proud of myself, as a woman, that I fixed this problem myself and didnt have to pay a repair... Read more

Replaced lid switch Read more

• Noisy

Replaced the motor, blower, rear drum felt seal, and drive belt. Vacuumed up the lint everywhere, cleaned extra lint out of the chute, around the blower, and rear vents. Read more

Our 19 year old Whirlpool dryer quit heating. After checking the thermal fuse, I found the ignitor electrically open. I bought an ignitor at a local store as there was a national holiday the next day and I did not want the dryer inoperative waiting several days for shipping. I can say AppliancePartsPros is MUCH cheaper for the identical Whirlpool genuine part. While changing the ignitor, I noticed there was an excessive amount of lint in the dryer, which was caused by worn drum seals. I ordered... Read more

Replace parts worn i repair appliance for60 years i am79 Read more

Completely removed dryer drum cleaned surfaces ready for paint applied paint acquired from you it did a wonderful job with one can of paint will use for a while and acquire another can of paint for second coat thank you so much for your help the whirlpool dryer drum paint was exactly what it said it would do Read more