Kenmore Refrigerator 363.69965991 (36369965991, 363 69965991) Parts

The front wheel assembly replacement (WRXO2X12454) was straightforward and easy to do. Took maybe 30 minutes start to finish. The rear wheel assembly (wheel WRO2X10695 and axle WRO1X10604) that was more involved as the original wheel axle is actually a rivet that you have to cut out. 1. I used a vibrating multitool with a carbide blade to cut the axle out. Had to use a pair of vise grips to hold the rivet to keep it from spinning while cutting it. 2. The new axle I drilled a 2mm hole thru the... Read more

Replaced both end caps. Read more

It was a challenge...the shelf unit consists of two plastic end brackets and a long metal shelf. I possessed one original end cap while the metal shelf was inadvertently discarded years ago along with the other broken end bracket. For a few years some white duct tape was pressed into service as a "temporary" bottom shelf. Anyway, I searched for the necessary parts online and found and ordered a new end cap on AppliancePartsPros.com and a new metal shelf from another online vendor. The new end... Read more

I removed the drawers and old rails, and screwed in the new ones. It was very straightforward. Read more

Was replaced. Read more

Replaced motor took 15 minutes, it was great saved 370 dollars. Read more

Did some research on Appliance Parts Pros site. Took a chance and ordered the parts I thought were needed. They came in three days. Suspicions confirmed. Relatively easy fix. All went well. Repair videos were especially helpful. Appreciate ease of repair and help from App Parts. Thanks Read more

This is in a 15 year old Built-in Monogram that had the compressor replaced a few years ago. Before discovering the motor failure I replaced the main board since a Refrigeration Contractor I know said that if it wasn't bad it would be soon since those parts typically only last around eight years. The motor replacement is pretty simple; more time is spent getting to the motor and re-assembling everything than actually changing the motor. The trickiest part is getting the fan set correctly on... Read more

Installed it. Read more

I replaced the Evaporator Fan Motor the brackets were rusty so I ordered them. Read more

Purchased new slides and screws and replaced them both. Read more

Ordered the part from you using your clear part diagram, arrived two days later and crisper was fixed! Read more

I ordered a clip retainer which hold the compressor in place. First, I discovered there are four clips and the one which I could easily move or turn by hand I ordered a replacement. The part came fast. In less than two minutes I had completed the repair. Read more