Kenmore Refrigerator 363.79262991 (36379262991, 363 79262991) Parts

The front wheel assembly replacement (WRXO2X12454) was straightforward and easy to do. Took maybe 30 minutes start to finish. The rear wheel assembly (wheel WRO2X10695 and axle WRO1X10604) that was more involved as the original wheel axle is actually a rivet that you have to cut out. 1. I used a vibrating multitool with a carbide blade to cut the axle out. Had to use a pair of vise grips to hold the rivet to keep it from spinning while cutting it. 2. The new axle I drilled a 2mm hole thru the... Read more

So slick! Removed the nasty bungee cord he had used for a temporary (Ha ha!) fix months before. Checked the model number inside the frig. Googled "Kenmore parts." Scroll-enlarged the nifty diagram. Said, "A hah." Ordered the parts online. Answered the door the next day. Stopped dancing my little jig. Used the heel of my hand to knock the end caps onto the metal shelf, clicked it back in place on the door, and filled that shelf with beer. Ta dah! Thank you for clear instructions and easy... Read more

It was a challenge...the shelf unit consists of two plastic end brackets and a long metal shelf. I possessed one original end cap while the metal shelf was inadvertently discarded years ago along with the other broken end bracket. For a few years some white duct tape was pressed into service as a "temporary" bottom shelf. Anyway, I searched for the necessary parts online and found and ordered a new end cap on AppliancePartsPros.com and a new metal shelf from another online vendor. The new end... Read more

Was replaced. Read more

I removed the drawers and old rails, and screwed in the new ones. It was very straightforward. Read more

It was fairly simple. The blade just slides onto the post of the condenser. Thanks to Appliance Pros, we should not have this problem again. We were offered to buy a special 28" long brush made to clean the refrigerator coils, and it works great! :) Read more

This is in a 15 year old Built-in Monogram that had the compressor replaced a few years ago. Before discovering the motor failure I replaced the main board since a Refrigeration Contractor I know said that if it wasn't bad it would be soon since those parts typically only last around eight years. The motor replacement is pretty simple; more time is spent getting to the motor and re-assembling everything than actually changing the motor. The trickiest part is getting the fan set correctly on... Read more

Did some research on Appliance Parts Pros site. Took a chance and ordered the parts I thought were needed. They came in three days. Suspicions confirmed. Relatively easy fix. All went well. Repair videos were especially helpful. Appreciate ease of repair and help from App Parts. Thanks Read more

Found that piece of auger was broken up front. Ordered auger and several other parts associated with ice maker just to be sure. Also replaced condenser motor which was making noise. Read more

Ordered the part from you using your clear part diagram, arrived two days later and crisper was fixed! Read more

Determined from the schematic on the inside of the cover of the icemaker that the likely problem was the "stop" micro switch.... Took the whole thing apart and confirmed the switch was defective. Replaced it with a standard DPDT switch - for a temporary fix. Went on line to find replacement. Bought it from APP Parts Pros. replaced DPDT switch with micro.. all is well.... saved at least $150 by not having a repair person come to the house - felling good about this..... Read more