Kenmore Dishwasher 665.13863K601 (66513863K601, 665 13863K601) Parts

This upper rack adjuster sets and secures the dishwasher's top rack height so dishes clear the spray arms and load properly. When the adjuster wears or breaks, the rack can become uneven or stuck, leading to poor cleaning and loading issues.

• Provides the mechanism to raise/lower and lock the upper dishrack height
• Keeps the top rack level and secured to the rail during operation
• Common symptoms of failure: rack drops on one side, won't adjust, feels loose, or comes off the track
• Contribute to poor wash results when the rack can't be positioned correctly

• Disconnect power and water supply before servicing
• Remove upper rack end caps/stops and slide the rack out to access the adjuster
• Release or unfasten the old adjuster, transfer any reusable clips/wheels if applicable, and install the new adjuster
• Set both sides of the rack to the same height; reinstall rack and confirm smooth travel and secure locking

Fix a dishwasher motor that hums or won't start. This run capacitor provides the phase shift needed for smooth motor operation. DIY repair in 30-45 min.

Insulation pad that fits behind dishwasher panels to restore thermal protection and reduce noise. Replace if damaged, missing, or rattling occurs.

Dishwasher door seal prevents water leaks between the console and door. Replace if you notice leaking during cycles or visible wear. Confirm fit with model.

This is a rubber gasket that seals around the door vent opening on a dishwasher, preventing steam and moisture from escaping into areas where they can cause damage. It fits between the vent assembly and the inner door panel. Replace this gasket if you notice moisture or steam leaking from around the vent area, water dripping down the front of the door, or if the gasket appears cracked, warped, or deteriorated.

Fix a dishwasher that won't fill properly or overfills with this overflow switch lever. Restores water level detection. DIY-friendly repair.

Filters lint and debris from wash water before reaching the drain pump. Replace if cracked or clogged to restore proper draining. Confirm fit by model.

Color: Biscuit. Screw for lower toe panel. For black screw use WP302868, for white screw use WP3400836.

Color: White. Size: 1 qt. can. Acrylic appliance paint.

This mounting kit secures your dishwasher's tall tub to the floor, preventing movement and vibration during operation. It replaces worn or missing floor mounting hardware that can cause your dishwasher to rock or shift during wash cycles.

Flat washer for dishwasher fasteners. Distributes load and prevents loosening at mounting points. Replace when worn or missing to reduce vibration. Confirm fit with your model number.

Access panel covers the base of your dishwasher, concealing wiring and mechanisms. Replace if cracked, broken, or missing after installation.

This dishwasher rack repair kit contains touch-up paint to restore damaged or chipped dish rack coating. It prevents rust and maintains the protective finish on wire racks. Use it to repair small chips or worn spots that could snag dishes or spread rust.

Shield for dishwashers. Protects internal components from heat and water damage. Replace if cracked, broken, or missing to maintain proper coverage.

Protective cover that installs over your dishwasher's capacitor. Replace if cracked, broken, or missing to shield the capacitor from debris and contact.