Kenmore Dishwasher 665.17282401 (66517282401, 665 17282401) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3385088
Replacement dishwasher dishrack wheel installs on the upper or lower rack to restore smooth gliding. Replace worn, broken, or missing wheels to fix jamming.
Do-It-Yourself Stories from Customers like You
Upper tray roller failure Michael S. • Atascadero , CA • February 28, 2022
Ordered replacement parts and installed them. A lot less expensive than having a dealership fix it.
Read more
More
$12.95
- Compare At:
-
$15.28
- You Save:
-
$2.33
Genuine Whirlpool part
By: Whirlpool
Part Number: W10871196
Black access panel kit for dishwasher lower front area. Replaces missing, cracked, or damaged toe panel assembly. Secures under cabinet for finished look.
Do-It-Yourself Stories from Customers like You
I needed a toe kick panel for my maytag dishwasher Jeffrey C. • Plymouth , MN • May 02, 2016
I found the part number, double checked it, and ordered the part, which arrived as promised. However, the part was just placed in a folded cardboard tube and was damaged by the shipper. I figured it was only a toe-kick, so I bent the part as best I could and installed it in 3 minutes.
Read more
More
$87.95
- Compare At:
-
$104.56
- You Save:
-
$16.61
Genuine Whirlpool part
By: Whirlpool
Part Number: W10877094
This power cord connects your appliance to a household outlet. Replacing a worn or damaged cord restores safe, reliable power and can help resolve no-power or intermittent power issues caused by a compromised lead.
- Delivers electrical power from the outlet to the appliance
- Replaces cords with cracked, frayed, or heat-damaged insulation or a damaged plug
- Helps when the unit won't power on or loses power when the cord is moved
- Addresses visible scorching, arcing, or melting on the cord or plug
What's included: 1 power cord Install notes:
- Disconnect power before servicing; verify no voltage is present
- Note wire positions or take a photo before removal; match to the same terminals on install
- Use the proper strain relief/clamp and route away from sharp edges, moving parts, and heat sources
- Confirm the ground connection is secure; do not modify the plug
Do-It-Yourself Stories from Customers like You
Replace insulation Candace B. • N Chelmsford , MA • March 07, 2018
Awesome company! Very quick, good price and the right parts. Would order again no question.
Read more
More
$100.95
- Compare At:
-
$121.14
- You Save:
-
$20.19
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10358302
Drain hose connects dishwasher pump to exterior drain. Replace if cracked, leaking, chewed by rodents, or when check valve fails. Includes elbow connector.
Do-It-Yourself Stories from Customers like You
Dishwashwer was only partially draining James M. • Barre , MA • November 07, 2016
I figured out that it was probably a plugged pump hose, since the pump would run, it somtimes it drained and sometimes it didn't. Your video helped with how to take the dishwasher out and replace the hose. I replaced the hose and everything is now working fine. It turned out to be a broken check valve in the old hose that caused the problem. It took 90 mins to do the repair.
Read more
More
$59.48
- Compare At:
-
$70.78
- You Save:
-
$11.30
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10477552
Fix dishwasher not heating or melted terminals with this heater terminal nut. Secures the heating element wire connection to prevent arcing and leaks.
Do-It-Yourself Stories from Customers like You
Stopped running after rinse cycle and the clean light was flashed 3 times Clyde Y. • Turtle Creek , PA • August 29, 2015
Replaced the heating element as shown in the video. Repaired a bad connector on the wire leading to the heating element. The clean light still flashed 3 times. Determined that the thermal fuse also needed to be replaced. Replaced the thermal fuse as shown in the video. The clean light now flashed 7 times which I discovered meant that the control panel needed to be reset. I then reset the control panel by pressing the buttons: normal, heated dry, normal, heated dry. It now works perfectly.
Read more
More
$9.63
- Compare At:
-
$11.36
- You Save:
-
$1.73
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8268909
Dishwasher overflowing or not filling properly? The water level switch controls fill amount. DIY-friendly repair, typically 20 minutes with video guide.
Do-It-Yourself Stories from Customers like You
Washer would not fill with water Ty J. • Hillsboro , OR • July 08, 2018
Replaced float switch and also replaced intake valve. Worked like a charm and the process was as easy as the YouTube video I followed made it seem.
Read more
More
$50.57
- Compare At:
-
$60.18
- You Save:
-
$9.61
Genuine Whirlpool part
By: Whirlpool
Part Number: W11631670
This factory-specified screw secures panels, brackets, and internal components in your appliance. Replacing worn or missing hardware restores a tight fit to help reduce vibration, noise, and premature wear.
- Fastens sheet metal, brackets, or plastic parts as designed by the manufacturer
- Helps maintain alignment and reduce vibration/rattling
- Direct replacement for stripped, corroded, or missing screws
- Common signs: loose panels or trim, shifting components, screw won't tighten
What's included: One screw Install notes:
- Disconnect power; shut off water or gas supply if applicable
- Use the correct driver to avoid stripping the head
- Start threads by hand to prevent cross-threading; tighten snugly without overtightening
- Replace one-for-one in the original location per service information
Do-It-Yourself Stories from Customers like You
Some accessories were worn. Wayne C. • Massapeqau Park , NY • April 15, 2020
My son fixed the issue of some wear and tear.
Read more
More
$9.95
- Compare At:
-
$11.74
- You Save:
-
$1.79
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8268895
Fix dishwasher overflows and leaks with a new float assembly. Controls water level to prevent overfilling. Moderate DIY repair with video guide.
Do-It-Yourself Stories from Customers like You
Kitchenaid dishwasher kudp02frss2 leak at float switch at front right of unit Richard B. • Mahwah , NJ • December 02, 2016
Removed bottom cover, located leak at float switch, removed and replaced float switch kit.
The toughest part of the repair was removing the Float & Retainer Assembly (in the interior of the machine tank) which broke when I pushed it back and pulled it straight up as suggested in the service manual. The Float Switch Kit (attached to, and below the float, below and outside the tank) has a folding plastic cover which fastens with plastic clips. If you open the switch kit before removing the...
Read more
More
$54.25
- Compare At:
-
$64.56
- You Save:
-
$10.31
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8281156
This replacement screw fastens appliance components such as panels, brackets, or trim. Use it to replace a missing, stripped, or rusty fastener and restore a secure, rattle-free fit in your appliance assemblies.
- Secures panels, brackets, or hardware to maintain proper alignment
- Helps eliminate vibration, rattling, or loose-feeling parts
- Replaces fasteners that are missing, corroded, or cross-threaded
- Typical signs you need it: loose handle or panel, gaps, or hardware that won't stay tight
What's included: One screw. Install notes:
- Disconnect power (and shut off gas, if applicable) before servicing
- Match thread type and length to the original fastener for proper fit
- Start threads by hand to avoid cross-threading; do not overtighten
- Reuse any original washers or clips if present
Do-It-Yourself Stories from Customers like You
Screw on one of the roller on upper tray broke Tim J. • Bend , OR • December 28, 2014
Replaced complete roller- screw,wheel and axel. Easy job
Just recently I had to replace upper spray arm. I ordered assembly from you and was completely satisfied with your service and price, that was over 1/2 of what local appliance repair dealer wanted. Very satified with how to do video on this project
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8531857
Standing water or dirty dishes? A clogged or damaged pump inlet screen blocks debris from the wash system. Simple DIY fix restores drainage and cleaning.
Do-It-Yourself Stories from Customers like You
Clogged at the chopper assembly strange noisehopper assembly broken Thomas H. • Idaho Falls , ID • July 07, 2015
Looked at Dishwasher. Scratched head and armpit. Told wife I would fix, not repariman. Wife skeptical - shook head. Found schematic on web. Found YouTube video of guy repairing same DW model. Disassembled. Diagnosed problem. Chopper assembly welded in place by water scale -broke removing. Potty mouth. Ordered parts. Waited for parts. Washed dishes by hand. Wife doing ok. Parts arrived (in only a day or two!!! Fed Ex for 7 bucks!! Great deal). Put on nasty t-shirt, baggy shorts. ...
Read more
More
$78.48
- Compare At:
-
$93.95
- You Save:
-
$15.47
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8539190
Gray plastic pivot clip for dishwasher upper rack tine rows. Replaces broken, cracked, or missing pivots that prevent tines from adjusting properly.
Do-It-Yourself Stories from Customers like You
2 broken "wheel and mount assemblies" (same side) and a few misc upper basket plastic part were broken Michael B. • Wellington , FL • December 29, 2015
With the basket out of the dishwasher, the plastic parts basically snap on and off... popped the broken parts off and the new parts on. The 2 wheel and mount assemblies were a little more complicated. The video on the website advises to disconnect the supply line and drain line... I didn't have to do this. I just pulled the dishwasher out of its cabinet a little over a foot and removed the 2 screws holding each assembly in place and removed them. The previous gaskets (2 PER ASSEMBLY)...
Read more
More
$48.46
- Compare At:
-
$57.67
- You Save:
-
$9.21
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8268349
Anchors the door balance spring to the dishwasher frame. Replace this hanger if worn, broken, or missing to restore proper spring tension and support.
Do-It-Yourself Stories from Customers like You
Upper basket wheel hubs had broken away Mark F. • Tigard , OR • February 25, 2022
Found a great extensive list of available parts for our dishwasher model on the website. Reference to videos made the repair steps very clear and easy to follow.
Read more
More
$6.95
- Compare At:
-
$8.27
- You Save:
-
$1.32
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8268713
Replaces damaged dishwasher dishrack wheel assembly. Installs on upper or lower rack for smooth rolling. Needed when wheels crack or tabs break.
Do-It-Yourself Stories from Customers like You
Whirlpool dishwasher lower rack wheel assembly. Gregory Z. • Missoula , MT • March 01, 2019
Ordered wheel assembly. Received in a couple of days. Easy FIT project. Problem solved.
Read more
More
$52.68
- Compare At:
-
$62.69
- You Save:
-
$10.01
Genuine Whirlpool part
By: Whirlpool
Part Number: 72032
Bottle with brush. Color: Black. Size: 0.6 fl.oz.
Do-It-Yourself Stories from Customers like You
Leaking diaphragm Herbert S. • Monroe Township , NJ • January 03, 2015
Replaced It With New One
Read more
More
$17.95
- Compare At:
-
$21.36
- You Save:
-
$3.41
Genuine Whirlpool part
By: Whirlpool
Part Number: WP489069
Size: 1/4 inch hex head, 10-12 x 1/2 inch.
Do-It-Yourself Stories from Customers like You
Broken handle foot pedal and missing parts Donald M. • Lake Arrowhead , CA • April 05, 2015
This trash compactor is in our vacation home. We never use it and now we are selling the house. When I looked to replace it I was amazed at how expensive a new compactor would cost. I found the serial number on the current compact entered it and your web site came up. Your schematics were excellent and made the repair very easy!
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10323423
Adjustable manifold that connects the upper rack to the rear water feed tube. Replace if cracked, punctured, corroded, or missing the seal probe.
Do-It-Yourself Stories from Customers like You
Glasses were coming out with particles in them, manifold had corroded through in several areas. Ethan G. • Moorestown , NJ • April 19, 2020
Replace the entire assembly, manifold, spray arm with seal and water probe. Took 5 minutes. Problem solved!
Read more
More
$55.95
- Compare At:
-
$67.04
- You Save:
-
$11.09