James February 02, 2012 for Model Number Frigidaire, FRS26ZRGB9 Ice dispencer motor is new,it won't turn auger. Could the problem be the micro switch on the picture? If that might be the problem,give me the part number of the micro switch. Thank you, James
1 Answer Hello James. Yes, if the micro switch 218479900 is bad, it will prevent the motor from working. Hope this helps. Read More...
Gary January 27, 2012 for Model Number frs23hf5aw4 What would cause my ice dispenser to continuously dispense ice? I removed everything in front of fridge to thaw some ice in water line, and when I put everything back together, and applied power, the ice dispenser began dispensing ice continuously. I eliminated the actuator switch by removing the wires. However, when I unplugged the wiring harness to the touch pad the ice dispenser stopped.So, how would I know if it's the power control board, or the touch pad sensor board?
1 Answer Gary, If the issue was solved when you unplugged the control board(dispenser harness) from the power control board, your issue is in the dispenser board 241700103.One of the buttons is stuck, or the circuit has shorted. Good Luck and Thanks Read More...
Mike November 28, 2011 for Model Number frs26r4ab6 Water continues to leak out of my water dispenser when not in use. What do I do to solve this?
1 Answer Hello Mike. If the dispenser is leaking, you will need to replace the water valve 242252702 on the unit. Make sure there is no air in the lines. If not, replace the valve. Hope this helps. Read More...
Ray October 10, 2011 for Model Number PLHS69EGSS5 Our ice dispenser is stuck in the crushed ice setting. It won't dispense whole cubes no matter which buttons we push. I took out the unit, melted any ice buildup, and cleaned it. It didn't help. Any ideas? Thanks
1 Answer Hi Ray. Shut off ice maker. Tape the freezer inner door sw. closed.Hold the dispenser arm for ice and see if the solenoid changes up and down as you switch between cube and crush. Remove the ice bin. remove the 2-lower screws holding in the bin- rail assy. and lift off.Unhook the elect. connector holding auger and solenoids. Back in beside the auger motor is a crush/cube solenoids. The solonoid lifts the crush/cube teeth rod to allow either choice. If this has failed ,replace it with part # 241675704. Thank you. Read More...
Donna October 02, 2011 for Model Number frs26h5asb3 Ice dispenser is stuck on. How do we know if we need a switch or a panel?
1 Answer Hi Donna. The actuator pad has a switch behind it. It is part # 241689106. Possibly shorted. Remember to repair any burn't switch connections. Thank you. Read More...