Cary August 07, 2018 for Model Number LFX25974ST Have a block of ice forming under the auger motor. Looks like water is dripping out of the ice tray maybe. Put the icemaker in test mode but when it went to dump the ice there was no cracking sound like usual. Could all the ice not be dumping and then it refills and overflows.
1 Answer Cary,It is very possible the ice tray could be damaged or cracked and not twisting to dump the ice.You will need to verify the wire connector from your ice maker to see if its a 6 wire or 3 wire.I'm sure there are videos for removal on the internet to help.Paer # AEQ73110205 is the 6 wire and part # AEQ73110203 is the 3 wire. Read More...
Steve July 19, 2018 for Model Number Kenmore Elite 795.72053.110 Ice Maker stopped dumping ice. Replaced the unit and still not dumping ice. Had service technician come out and said the new ice maker was defective and everything else was good. Ordered and installed the 2nd new unit and still not dumping ice. What are the odds that both of the 2 replacement units are bad? Should I try a 3rd new unit or is there something else that could be wrong (controller board)? Very frustrating and expensive and still no dumping ice. Any insight would be appreciated. Original and replacement units were AEQ73110205.
1 Answer Steve, It is highly unlikely that 2 icemakers would come in faulty. If the icemaker is filling with water but not dumping the ice then this will most likely be an issue with the control board on the unit. Read More...
Todd July 16, 2018 for Model Number LFX21976ST03 This is a french door LG. Ice clumps in the bin, like it's melting. We are emptying it into the freezer almost daily. Both refrigerator and freezer temperature seem fine. From what I can tell, it's not overfilling--I've replaced many water inlet valves and this doesn't seem to have those symptoms. I'll check it every 6-12 hours and I just don't see any excess water. Running a manual reset seems OK too. Is the next step to replace the entire assembly, or is there something cheaper I should try. Thanks for your thoughts!
1 Answer Todd, You will want to check to make sure that the ice door is closing all the way as this would be the most likely cause for this issue. Air migration into the ice compartment. If the door is closing all the way then check for a deteriorating ice mold and if there is deterioration of the mold then you would need to replace the icemaker. Read More...
Jackie Again May 20, 2018 for Model Number LFX25976SB I asked the recent question about the ice cubes being made but not being dumped into the bin. When I press the test button it dumps fine and refills with water again. About the same time this started happening, I noticed the bread in my freezer is not frozen on that top drawer of the bottom drawer freezer, but it seems as if most everything else is still frozen. Also if I put ice in a bucket on the top drawer, it stays frozen. Do you think there is more wrong with the fridge/freezer than just the ice maker. I'm wondering if the ice maker works but is just not sensing that it is frozen enough to dump it out yet, due to the slightly warmer freezer.
1 Answer Jackie, It does not sound like there is nothing else wrong with the unit and just sounds likely that the icemaker is faulty and would need to be replaced. Just make sure also that none of the air ducts are blocked. Read More...
Jackie May 16, 2018 for Model Number LFX25976SB My ice maker makes ice but does not dump them out. The test button it seems to work just fine and the water will refill again. I have cleaned the sensors but I think they still are the problem. Do I need to replace the entire ice maker or can I just replace the sensors? Will the ice not dump because it thinks the bucket is full?
1 Answer Jackie, The icemaker assembly on this will need to be replaced for this issue. The icemaker part number for this will be AEQ73110205. Read More...
Kurt S May 16, 2018 for Model Number LFX25991ST/05 What is the correct part number for a replacement ice maker?
Rick March 28, 2018 for Model Number LMXS30776S/00 My icemaker stop making ice, it is not being refilled with water. Icemaker cycles with the test button pushed. Water dispenses from the door only. What my be the cause?
1 Answer Rick, If the icemaker does not refill with water then you will want to check to see if there is voltage getting to the water valve. If there is no voltage then the valve would be faulty and need replaced. Read More...
Carlo February 12, 2018 for Model Number LG LFX25978ST/01 What is the part number for a replacement ice maker for this refrigerator?
1 Answer Hello Carlo. Based on the model number you provided, you will need to order and install AEQ72910409 into the unit. Thank you. Read More...
Tommie January 08, 2018 Where can I obtain assembly instructions and diagram for a Ice Storage Caddie, for my Kenmore Elite, model# 795.71053.010? A screw which holds the parts (teeth, spacers) backed out, and all came tumbling down (out in this case). I have not been able to locate desired information on line, which usually means..... Product owner, want to sale new assembly, or the next higher assembly.
1 Answer Tommie, Unfortunately there is no diagram or instructions for installing the components back into the ice bin assembly. The manufacturer does not provide any information on this and they do not provide parts other than the complete bin. Read More...
Bill K December 28, 2017 for Model Number LMXS28626 Ice Maker not making enough ice, only about 18 cubes in a 24 hour span. I cannot determine what is the sensor? I've only turned the ON/OFF button thus far 24 hours ago. I went through manual, but as I said, I cannot figure out what to do, as i have no idea what or where the sensor is?
1 Answer Bill, The sensor will be part of the icemaker kit and cannot be gotten separately. The icemaker would be the most likely cause for this issue. Read More...