Dave July 03, 2015 for Model Number KUDI01ILBL6 I was frequently getting the flashing light error. At your suggestion I replaced the control panel but I still get the error occasionally. What do you suggest next :the logic board?
1 Answer Hello Dave. Check the door switches and if good, then the board would be next in the unit. Read More...
Davet May 15, 2015 for Model Number KUDI01ILBL6 Does the control panel (8531816) come with the screws used to attach it to the dishwasher door?
Dave T. May 15, 2015 for Model Number KUDI01ILBL6 Does the control panel (8531816) come with the screws used to attach it to the dishwasher door? In your experience when we get the two flashing green light error is it caused by a faultly control panel or logic board? Thanks
Terry June 07, 2014 for Model Number KUDI01ILBL6 Issue my KitchenAid dishwasher, unit will not run. The Heavy and Normal Cycle green lights are both flashing at the same time along with the Cancel green light flashing. I've tried resetting the control panel with no luck. Is this problem related to the control panel possibly being bad?
Sram May 22, 2014 for Model Number KITCHENAID KUDI01ILBL5 DISH WASHER Hello Appliance Pros, On the same kitchenaid dishwasher on which I replaced the control panel(See my question from a couple of months back) I now have a new problem. .. The dishwasher wont or is not drying the utensils at all. I have absolutely no idea what could be wrong Rgds, SRam
1 Answer Sram, First check and make sure the water temperature in the bottom of the tub is at least 120dgrs.F. on the first fill of a wash cycle. Use a meter and test the heater element for 10 to 35 ohms resistance, with the wires disconnected, and then test the Hi Limit thermostat for a "closed" circuit at room temperature. If all checks are OK, you'll need to check for a broken or damaged wire to the thermostat and heater element. Read More...
Sram August 15, 2013 for Model Number KITCHENAID KUDI01ILBL5 Hello, I have a kitchenaid dishwasher, model # KUDI01ILBL5 Yesterday I loaded the dishwasher and when I pressed the normal button, the the light on top of that button started to blink. When I pressed Cancel the light on the top of cancel. I read some online forums and they advised that the the panel may be shorted. Can you please assist. SRAM
1 Answer Hello Sram. Check the door switches. If good, you will need to replace the control panel on the unit. Read More...
Micheal G. July 25, 2013 for Model Number KUDI01ILWH6 Kitchen Aide Dishwasher will not come on when you push start. I have it in HEAVY HIGHTEMP SCRUB - ENERGY SAVER DRY. When you push cancel it will run for a few minutes and then go off.
1 Answer Hello Micheal. Based on the information you provided, it sounds like the control panel WP8531816 is bad and will need to be replaced on the unit. Read More...
Earl March 12, 2013 for Model Number Kudi01ilbl5 Hi. Does the electronic Ctrl panel come with the outer Ctrl panel? Or do u have to buy both? Thank you very much.
1 Answer Earl, the control panel WP8531816 does not include the control board WP8564543. Thanks! Read More...
Ljrcjp March 07, 2013 for Model Number kudi01ilbl6 What is the cost and procedure in returning a part to appliancepartpros?
1 Answer Hello ljrcjp. Here is a link to our return policy. http://www.appliancepartspros.com/customerservice/returns.aspx Read More...
Ljrcjp March 07, 2013 for Model Number kudi01ilbl6 Does the ribbon cable come with the control panel?