Range Bracket & Flange

This support bracket secures and stabilizes appliance components, restoring proper alignment and stopping movement. It's a simple replacement that helps reduce rattling and prevents panels or assemblies from shifting during use. What it does:

• Provides a rigid mounting point to hold panels, trim, or internal assemblies in place
• Restores proper alignment when a worn or broken bracket causes gaps or looseness
• Reduces vibration and rattling caused by a damaged or missing support
• Keeps connected parts from shifting, which can prevent further wear or damage

• Disconnect power to the appliance before beginning any repair
• Verify the bracket orientation and fit against the mating surface before fastening
• Use the factory screw locations and hardware; tighten screws securely but avoid over-torquing

This mounting bracket secures internal panels or components to the appliance frame, restoring stable support and alignment for proper operation. Use when a bracket is bent, broken or missing to reduce rattling and keep parts positioned correctly. What it does:

• Anchors panels or components to the cabinet/frame to prevent movement and vibration
• Restores proper alignment of doors, panels or internal assemblies
• Stops rattling or buzzing caused by loose or damaged support hardware
• Helps maintain safe clearance between parts and wiring or moving components

• Disconnect power to the appliance before starting any repair
• Basic hand tools typically required; follow OEM instructions for correct fastener locations
• Inspect adjacent fasteners and mounting surfaces; replace any damaged screws or clips
• If bracket is corroded or severely deformed, replace rather than re-bend to ensure proper fit

This mounting bracket provides a secure support point for the appliance assembly where it attaches to the cabinet or adjacent components, helping maintain proper alignment and stable operation. What it does

• Secures panels or components to the appliance frame to prevent movement or sagging
• Keeps aligned parts properly positioned to reduce noise and wear
• Helps restore fit and finish after repair or component replacement
• Common symptom: loose, misaligned, or rattling panels near the mounting location

• Installation requires basic hand tools; disconnect power before servicing appliances with electrical components
• Retain original fasteners when possible; replace any stripped or damaged screws
• Inspect mating surfaces for damage or corrosion and clean before installing the bracket

A circular lug designed to join a stripped wire to a threaded terminal for a secure electrical connection. Helps restore reliable contact at terminals and reduces the chance of intermittent power or arcing at connection points. What it does:

• Provides a strong mechanical and electrical connection between a wire and a screw or bolt terminal.
• Helps prevent loose connections that can cause intermittent operation, sparking, or overheating.
• Commonly used where a ring-style termination is required for safe, stable wiring.
• Works with properly sized wire and fasteners to maintain consistent conductivity.

• Always disconnect power to the appliance before inspecting or replacing electrical parts.
• Use the correct lug size and gauge for the wire and terminal; crimp or solder per manufacturer recommendations.
• Tighten terminal hardware to the appliance manufacturer's specified torque; avoid over-tightening which can damage the lug or terminal.
• If wiring insulation or the terminal is damaged or corroded, replace the affected components rather than reusing them.

This glass support bracket secures the oven door glass panel to the door frame, keeping the glass aligned and stable for safe use. Replace a worn or damaged bracket to reduce rattling and restore proper door fit. What it does:

• Supports and anchors the oven door glass to the door assembly
• Keeps the glass aligned to prevent movement and vibration during operation
• Helps eliminate rattling, clanking, or loose-feeling door panels
• Contributes to a proper door seal and consistent closing action

• Disconnect power to the appliance before beginning any repair.
• Handle glass panels carefully—wear cut-resistant gloves and eye protection.
• Keep fasteners and mounting positions consistent; tighten fasteners securely but do not overtighten.