Range Gas Conv Kit Parts

Finding the proper conversion kit was a snap. I just plugged in the model number and Appliance Parts Pros sent the proper conversion kit. Read more

We ordered the parts we needed, and received it with-in a week. My husband was able to covert the stove in one evening. Read more

Ordered new Ignitor / Orifice and screws Mike was a great resource, he helped me thru the project. Read more

• Won't start

Replaced igniter and orifice assembly, and replaced spark module. Used the video for help, but the video doesn't show the top cover piece that needs to be taken off first. Also the screws for the igniter set were stuck from old grease or something and had to be drilled out. Overall the project was well worth my time for the cost vs replacement decision. AppliancePartsPros.com makes it so easy to choose a part and guesstimate the probably of choosing the right one. Read more

Once I watched the video on your site about gas line install, it became apparent why the line bent when I raised the lid.. also discovered those two rods have nest to go into and the lid/top now sets down tight as designed ( and as an added bonus, gas smell disappeared during oven use) I ordered the gas lines with the model number, ordered all four …. it was a bit of a chore one came up when site opened I picked it, but did not know if it was the RH or LH etc.. so reading some of your answers... Read more

Found the parts I needed ordered them from your site Received them and installed in a few minuets and was done Read more

My 18+ year old Jennair cooktop, PN CCG2520W was in need of a rebuild b/c of a welded venturi tube on the right front [RF] burner. In order to remove the glass top cover, you MUST remove the venturi tube. To do this you have to DRILL-OUT the venturi tube which requires a new venturi and orifice holder. The repair was difficult b/c most of the parts are no longer available. But then I found a ray-of-hope. I was able to find some Jennair (Maytag) parts but they are scarce. Later I found... Read more

REPLACED ORIFICES TO BURNERS VERY EASY JOB. Read more

Removed natural gas jets, replaced with propane I purchased from you. Read more

Found the parts I needed ordered them from your site Received them and installed in a few minuets and was done Read more

This fitting is a 3/8 nut driver and an adjustable wrench. Read more

Installed a new ignitor/orifice assembly. Read more

Ordered new burner tubes and it was a easy install. Read more

I purchased a burner and a oven orifice replacement kit from Appliance Parts Pros. I downloaded an installation manual from Whirlpool and followed the instructions. It was pretty easy. The front burner orifices could be replaced by just taking off the burner cover. The back ones required removing the burner diffuser. You will need to reattach the back burner bottom assembies after you remove the diffuser before you unscrew the orifice or it might bend the burner piping causing it to not line up... Read more

Changing out the stovetop orifices from natural gas to propane- First thing, turn off the gas. On this model stove, there are five burners-two burners in the front, two in the back and one in the middle. The front two burners are different than the other three, they are the largest burners. You can use a 11/32 socket with an extension to go down the middle hole of the burner and screw-out the natural gas orifices. Taking the orifices out was easy. Putting the new orifices in is a different... Read more