Parts for Viking Range VDSC365: Rear Panel (Top And Bottom) Parts

Range won't heat or cycles incorrectly? This double-pole control relay switches two circuits to restore heating and control operation in your oven.

Secures thermal cutoff sensor for accurate oven temperature control. Replaces broken or damaged brackets that allow sensor to shift position.

Oven won't heat after self-clean or overheats during cleaning? This auto-reset safety thermostat limits heat during the cycle and restores power automatically.

This control board operates the oven's self-clean cycle and timer functions, restoring reliable control of cleaning, timed cook settings, and related control signals. Replaces a failed electronic module to return normal oven control behavior. What it does:

• Manages the oven self-clean sequence and related safety interlocks
• Controls clock and timer functions used for delayed or timed cooking
• Sends/receives control signals to the oven's temperature and door systems
• Commonly replaces a board that causes self-clean to fail, timers to not run, or control errors to appear

• Disconnect power at the breaker before starting; this is an electrical/ESD-sensitive module
• Handle the board by edges and avoid static discharge; wear an anti-static strap if available
• Installation typically requires removing the console or rear panel and reconnecting wiring harnesses exactly as found

This 1/2" x 1/4" rubber bumper cushions contact points to reduce noise and prevent damage on appliance doors, drawers, and panels. It restores proper cushioning for smoother, quieter operation and helps maintain a snug fit. What it does:

• Absorbs shock where panels or doors meet to reduce rattling and clapping noises
• Prevents metal-to-metal contact that can cause chipping, scratching, or wear
• Helps doors and drawers close more evenly by restoring original spacing
• Commonly used where small, press-fit bumpers have worn, flattened, or fallen off

• One 1/2" x 1/4" rubber bumper

• Press-fit replacement; remove old bumper and press new bumper into the same hole until flush
• No special tools required; use a flat pick or small screwdriver to remove old bumper if needed
• Avoid installing on hot surfaces or near heating elements; let appliance cool before service
• Replace matching bumpers in the same area if others show wear for even performance