Parts for Viking Range VDSC365: Outer Oven Cavity (Top And Bottom) Parts

This thermo-disc bracket secures the thermo-disc/thermal cutoff assembly so the temperature sensor stays properly positioned for reliable oven temperature sensing and safety. It's a direct-fit replacement bracket for affected VDSC assemblies. What it does

• Holds the thermo-disc or thermal cutoff in the correct position so it senses oven temperature accurately
• Keeps the sensing device stable to prevent false trips or intermittent temperature control
• Helps maintain proper operation of temperature-limiting safety components
• Can be replaced when bent, cracked, or corroded to restore secure mounting

• Disconnect power to the appliance before starting any repair
• Handle the thermo-disc/thermal cutoff carefully—avoid damaging the sensor element or leads
• Basic tools are typically required; alignment and secure mounting are important for correct sensing

This door latch secures the oven/door in the closed position so the appliance can operate safely and maintain temperature. It replaces a worn or broken latch to restore proper door closure and reliable oven use. What it does:

• Secures the oven door closed so the appliance can complete cooking cycles
• Stops the door from popping open or failing to stay latched
• Resolves issues where the oven won't start or complete cycles due to an unlatched door
• Replaces a damaged, bent, or broken latch that prevents proper closure

• Disconnect power (and gas if applicable) before starting any repair
• Handle door and any glass parts carefully; remove the oven door if needed for access
• Verify latch alignment and striker engagement when installing; adjust as required

Light bulb socket assembly includes: Light bulb socket, light bulb and light lens.

This main bottom assembly is the lower interior panel that supports components and helps channel airflow and drainage for proper appliance operation. Replacing a damaged panel restores structural support and corrects related functional issues. What it does:

• Provides the lower support and mounting surface for internal components
• Directs internal airflow and helps manage drainage paths
• Prevents debris from contacting electronics and burners
• Can stop rattling, sagging, or moisture-related issues when damaged

• One main bottom assembly

• Disconnect power and gas before beginning service
• Follow OEM disassembly steps; access typically requires removing lower access panels
• Handle sheet metal edges carefully and use proper fasteners per manufacturer guidance

This 1/2" x 1/4" rubber bumper cushions contact points to reduce noise and prevent damage on appliance doors, drawers, and panels. It restores proper cushioning for smoother, quieter operation and helps maintain a snug fit. What it does:

• Absorbs shock where panels or doors meet to reduce rattling and clapping noises
• Prevents metal-to-metal contact that can cause chipping, scratching, or wear
• Helps doors and drawers close more evenly by restoring original spacing
• Commonly used where small, press-fit bumpers have worn, flattened, or fallen off

• One 1/2" x 1/4" rubber bumper

• Press-fit replacement; remove old bumper and press new bumper into the same hole until flush
• No special tools required; use a flat pick or small screwdriver to remove old bumper if needed
• Avoid installing on hot surfaces or near heating elements; let appliance cool before service
• Replace matching bumpers in the same area if others show wear for even performance