Room Air Conditioner Touch Pad

This is the main printed wiring board (control board) for a room air conditioner. It manages the unit's core functions including compressor operation, fan speed, and temperature regulation. Replace this board if the air conditioner fails to turn on, does not respond to controls, cycles erratically, or displays error codes.

This Main PWB-K is the refrigerator's primary electronic control board that manages temperature, defrost, and user-interface functions so your appliance responds correctly to settings and cycles. Replacing a failed board restores normal control operation. What it does

• Receives input from the user interface and sensors to control compressor, fans, and defrost cycles
• Manages timing and relay signals for cooling and defrost sequences
• Can stop appliance response when the board fails—symptoms include blank or unresponsive controls, erratic cooling, or constant defrost/recirculation activity
• Works with the appliance's harness and connectors to pass commands to subsystems

• One Main PWB-K electronic control board

• Disconnect power to the appliance before starting; take photos of wiring for reassembly
• Handle the board carefully; avoid static discharge and damage to connectors
• Verify replacement PN and connector fit before installation; do not force connectors

This compact replacement overlay restores the control surface and button graphics on compatible Frigidaire appliances, improving appearance and making controls readable again. It's a direct-fit cosmetic/control surface replacement for the compact control area. What it does:

• Replaces a cracked, faded, or worn control panel overlay so button labels and icons are visible.
• Protects the underlying control board and switches from spills and everyday wear.
• Helps restore proper alignment of button cutouts and touchpoints for reliable use.
• Addresses symptoms such as peeling graphics, illegible labels, or cosmetic damage to the control area.

• Disconnect power to the appliance before beginning; follow lockout/tagout practices.
• Remove the control housing or bezel fasteners to access the old overlay; keep screws and clips for reassembly.
• Align the overlay carefully over button openings and press into place without forcing; ensure any retaining clips seat properly.