Samsung Parts

Replaced orifices. Read more

2 year old dishwasher- "LE" leak sensor - found tinny leak in the shorh drain hose in - upon removing it this hose was found to be BRITTLE - VERY BRITTLE - main drain hose is fine - samsung says that this isnt a problem but have read quite a few complaints - easy fix unce unit is turned upsidedown. Read more

Found water in the bottom pan causing the the error code. Took off the side panel and turn the unit on and saw the hose leaking water. The hose material is cheap material so no surprise it leaks. Read more

New assembly. Read more

• Not drying dishes properly
• lights flashing or blinking

Replaced the heating element in the dishwasher. Read more

• Won't start

First I checked the breaker and outlet and both were good...then I unplugged the machine, took the top off, and removed the control panel. I check the wiring to see if there were any loose plug ins, etc...This is where I figured the panel was bad (or possibly the power cord) so I ordered both. The parts arrived the next day. (incredibly fast shipping) Since I wasn't expecting them til after the weekend I left everything disassembled and went on a mini vacation for a couple of days. Upon... Read more

• Touchpad does not respond
• Won't start

Here's what the problem was: Started the 'Normal' cycle... I closed the door... it calls for water, water fills, ECS sensor doesn't kick it to the next segment of the cycle (wash), so the water over-fills and reaches the over-fill sensor. So many other are replacing the plastic 'case-brake,' main board, and the ECS sensor. I, however, was able to get by with just the ECS sensor replacement, which is known to be a faulty design by Samsung, supposedly. The idea is replace the (1) most common... Read more

• Fridge too cold
• Fridge too warm

First off I unplugged the refrigerator. I removed the meat tray, and the three screws on either side. The screws hold the meat tray drawer guides. I then removed the vegetable drawer, the fruit drawer, and the shelf above the two drawers, these did not have screws. Removed the one screw that held the damper motor housing. I then unplugged the motor from the refrigerator along with a sensor. I put the motor housing on my bench and removed the Styrofoam housing that holds the damper motor. I... Read more

Got the wrong part. Need to return Read more

Converted from natural gas to lp Read more

Remove unit, remove about 12 screw holding the top to the unit switch the tops reverse steps and done Read more

Ordered the Heater Metal Sheath (DA47-00244Q) and it worked, it is up and running. Thanks! Read more

Watched video and followed instructions. Easy installation. Read more