Samsung Motor

Replaced fan motor, temperature sensor and defrost thermostat. Note: I had to replace connector on new defrost thermostat. Connector on new part did not fit mating connector in refrigerator.. spliced in old connector for new one. Read more

• Will not agitate
• won't spin

My washer would not spin. This fixed my problem only took me 5 minutes to uninstall and install. Read more

Diagnosed the problem by seeing the lower fan was not turning. Didn't have any squeaks or sounds as a warning sign... It just stopped working. Went to AppliancePartsPros.com typed in my make & model number (Samsung NE58F9710WS). The web site pulled up the parts schematic, I navigated to the part on the schematic (Assembly #8 - Assy Motor Convection-Re DG96-00110B / AP5580897) and ordered it "Express Shipping" because I need the oven for Thanksgiving. When the part arrived, it looked identical... Read more

After watching the how to video twice I decided to embark on dismantling my dryer and attempting to replace my motor. After realizing that the main tool needed was a Phillips screwdriver I was sure I could handle this repair. One by one I took apart the dryer and spread out the parts throughout my mud room. 1.5 hrs later and I have a working dryer, and most of all a happy wife. Thanks for the speedy part delivery and the great how to video. Read more

• Fridge too warm
• Doesn't shut off
• Noisy

The blower motor that circulates air through the refrigerator was broken. I had to remove all the shelving and drawers from the refrigerator. Then I had to remove the plastic light cover from the center of the fridge. Then I removed all visible screws to uncover the evaporator/radiator. I then unplugged the light bulb and motor wires. Luckily all wiring is keyed so that it can be plugged in again without error. I removed the motor by opening the motor housing. The housing has 1 screw and... Read more

Replaced the evaporator cover asy.. Read more

I took all the items out of the refrigerator. Removed the screws that hold the cover over the evaporator motor. Than for three hours used a hair drier to remove ice. The panel was frozen on if you pull on it it will break. Soaked up all the water removed the panel and took the fan blade off. That was difficult because it looks like a regular screw head however, you need to push in that which will cause it to release the blades and than push it onto the new motor. Than replace the panel put the... Read more

Ordered the two motors plus ordered the fan blades since I was afraid one might break during replacement. Changed out without breaking Freezer and both ice makers now working fine Read more

Removed refrigerator panel, disconnected light and fan power. Removed fan assembly and replaced motor, grommets and fan attachment spring. Unit had adhesive on spring to help hold the spring. Chatted with customer service and clarified that spring and fan would easily pull off motor shaft. Adhesive probably was extra measure used during original build of the fridge. Noise was due to fan rubbing on housing. New fan position set to avoid any rubbing. Read more

• Oven not heating evenly
• temperature not accurate

First I did a search for my model stove, I read the discriptions of what it was doing and came to the conclusion it was the fan motor. I then called an appliance dealer in my local area to find out that the fan motor cost all most double what I could get it online. I called to see how much it would cost to have a repair man come out and fix it, which would have cost 260 dollars. So in one of the suggested comments that someone previously left it stated that it could be done in about 20... Read more

I bought the defrost-clip (clip-drain-evap), but once I took the refrigerator apart--the large plastic "back" had frozen to the rest and left the insulation in pieces when I tried to pull it apart. I was able to replace the clip-drain-evap piece with little trouble once the ice had melted, but I was unhappy with the looks of the "back". So I ended up ordering a new "back"(Yassy cover-evap) that included the new insulation as it's made in one unit. Once it arrived, replacing the new "back"... Read more

• tripping breaker

Starting circuit in motor bad. Replaced motor works fine. Read more

• Will not agitate
• won't spin

Actually, I am returning your parts. THERE IS NOTHING WRONG WITH THEM! My wife actually found out that we had a warranty on our washer that we didn't know about. But, I can comment that I did chat with your customer service and you guys were very helpful. Read more

Replaced the fan that circulates the air. Read more

I replaced motor assembly Read more

• Doesn't shut off
• Noisy

This repair was likely compounded by a second failed component after several unplug attempts. The first failure occurred after the freezer door had been left ajar. The freezer temp wouldn't drop but inside it still felt cold. I did several panel resets and the 'unplug for 12 hours' trick, neither changed indications. Checking behind the condenser cover revealed that it was still cold and appeared to be function, but the evap fan did not appear to be working. At some point during one of the... Read more