Refrigerator Lever Parts

• Not dispensing water

Parts where perfect. piece of cake.my wife was very impressed. Read more

Shopped online and found your great website, read reviews and based diagnostics on similarities I saw in other peoples stories. So I was able to choose correctly when replacing the circuit board. As far as the water switch in door, and drawer parts I just replaced them because I was tired of gluing them, and knew that with everything working good again and looking good, that it would be like a Tune up for our refrigerator. Read more

Replaced plastic housing for $100. Recommend buying the whole assembly though. Cost a bit more but you would be done in 15min. When you just replace the housing, you have to disassemble the old one very carefully to reuse several parts that do not come with the housing. A lot of fragile plastics. Plus, make sure you have GooGone and 3M thin tape handy; you will absolutely need it. Again, buy the whole assembly and save time and headache. Read more

My refrigerator is 13 yrs old and began to build up frost in the ice cube shoot and the water tube began to freeze up over night. The flapper door was not closing completely. I simply removed the control panel by pulling up and out on the bottom edge, the edge is only about 1/8 inch thick, so don't reach in to far. You should be able to feel a small division line between the control panel and the refrigerator. No screw driver was needed to expose the 4 mounting screws of the inner dispenser... Read more

Replaced two drawers, one shelf front, and the grille base Read more

New knobs Read more

It was super easy with the diagrams on the site to find the parts that I needed. Everything was shipped within a day and fit perfectly. I save myself about $400 from having a professional come out to do it. Read more

Replaced upper and lower thimble's, lever arm, cam closure. Door stop was not the problem, but ordered it and replaced it too. The door of course has to come off, remove the top hinge, and lift it away. Lubricated moving parts with silicone spray. Be sure and put the door back in the open position, so the lever arm and cam closure can properly interact, then close the door. Remove the plastic grate at the bottom to get at the lever arm. Presto. Problem gone. Don't put excessive weight... Read more

Replaced the actuator pad on the Whirlpool Gold Series, releasing the electronic menu pad to get to the water activator pad was the biggest hurdle. The release tabs are underneath the menu pad and you may feel as if you may break them when releasing them. They did not break but I did hold by breath. Read more

Ordered new parts Read more

Just replaced the part (snap it in...abc....123...no problem) Read more

Removed complete housing, including the actuator to dispense ice; plastic cemented, with reinforcing strips of cloth to reinforce repair on left hand side of assembly. Then installed new actuator part from Appliance Parts, plugged in wires, then had to plastic cement the pack on back of the new actuator back on, as it had come loose. Reassembled all, and finally managed to get the water discharge tube back through the hole, than replaced the flat strip connector & replaced all screws. Works... Read more

• Not dispensing water

I watched a video on YouTube that walked me step by step through the repair. Read more

Replaced it Read more

• Light not working
• Not dispensing water
• Ice maker not making ice

Ordered 2 light switches and replaced them. Read more

I replaced the lever asm. and spring Read more