Gss25watass Parts

Replaced upper and lower thimble's, lever arm, cam closure. Door stop was not the problem, but ordered it and replaced it too. The door of course has to come off, remove the top hinge, and lift it away. Lubricated moving parts with silicone spray. Be sure and put the door back in the open position, so the lever arm and cam closure can properly interact, then close the door. Remove the plastic grate at the bottom to get at the lever arm. Presto. Problem gone. Don't put excessive weight... Read more

First I ordered a new ice door seal, spring, and crank, figuring the condensation in freezer and door was caused by ice door not sealing. Turns out the solenoid for the ice door was completely rusted and was the primary cause, if it had been replaced early, it would have saved the dispenser board. What then happened was the moisture in the freezer door damaged the control board rendering dispenser controls inoperative as well as the heater around the dispenser. Now the freezer door is dripping... Read more

Replaced the stripper and fill cup - turns out that the fill cup came with the locking tab broken off. The stripper had a missing paddle, and ice cubes would jam and shut down the ice maker periodically. Let the ice maker warm up after you remove it so the plastic is not so brittle. You have to pry the old stripper out. Make sure the new one locks all across the front. My refrigerator has the ice maker mount toe the side instead of from the hangers in back. I wasn't sure how to remove it,... Read more

I thought I would have to buy a whole new refrigerator, but I looked online at AppliancePartsPros.com. I put in my model number of the refrigerator and the whole diagram came up. This made it so much easier to choose the parts I need to replace. I received the order in a few days so I was able to fix the problem quickly. The assembly was easy and the video helped also. Read more

Used the schematic provided to select the parts needing replacement and placed the order. Parts arrived and swapping new for old was simple. For the most part it was a matter of taking out the old and putting in the new. There were a few screws with wheels to replace but that was easy as well. Before purchase I searched several different sites and found all the parts needed. I compared prices of each item as well as shipping cost. Prices for each item were nearly identical between sites... Read more

Ordered new parts Read more

This fridge has had a problem of ice building up around evaporator coil in fresh food side. Wife (she HATES this thing) says it's done this from day one; 10 years. GE guy says all these models do this and there's no fix for it, so we have clean out the ice periodically... Like the 1940s pre auto defrost. Now with the issue of FF side temp too highi assumed the ice had built up around FF evaporator coil preventing proper cooling, but AppliancePartsPros.com suggested the FF temp thermistor may... Read more

Watched an online repair video first. Then removed hex head screws on bottom of door. Replaced broken part. Read more

I replaced the supply line to the fridge - no change in taste. I replaced the MWF manifold and tubes, the water inlet valve and the water storage line. That did it, good tasting water again! The ice still has a bad taste, so I'll replace the supply tube from the valve to the ice maker. Overall, replacing these parts was easy and the videos from Appliance Parts Pros helped. Read more

Pulled down the existing drain tube and installed new one. Tight area so it requires two hands to push up and attach the new tube. The short rubber tubing attached to the new drain tube has to fit snug onto the plastic tube connection that hangs down. Replacing the water dispenser tray is simple and no explanation needed, Read more

Check compressor with my Hotwire kit I made when I worked for GE. When removing the compressor relay it broke in pieces. Ordered and replaced new relay, overload & run capacitor. Still did not work. Check if there’s power to compressor and found no voltage. Took control board out and found a component burnt. Ordered and replaced control board. Everything is back to normal. Love your service. Parts was supposed to come in 3-5 days but came next day instead. I am very very impressed and grateful.... Read more

Used the schematic provided to select the parts needing replacement and placed the order. Parts arrived and swapping new for old was simple. For the most part it was a matter of taking out the old and putting in the new. There were a few screws with wheels to replace but that was easy as well. Before purchase I searched several different sites and found all the parts needed. I compared prices of each item as well as shipping cost. Prices for each item were nearly identical between sites... Read more

I replaced the lever asm. and spring Read more

It was very simple, took longer to unload freezer than to install glides Read more

Replaced water line from valve to ice maker Read more

We bought a used fridge and forgot to get the hardware to mount the doors. Looked up the model on your website. Using the pictures I was able to order just the parts I needed and not to duplicate anything (or leave anything out!). The parts arrived and because I watched the "how to" video I knew to use the "trick" to hold the doors up while attaching the hardware. Had the doors mounted in less than 15 minutes!.. Thanks Read more