Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Replacement spring for dishwasher detergent cup door assembly. Provides tension to keep cup door latched closed. Replace if broken, stretched, or lost.
First replaced the latch, spring, and lever, but no improvement. Then I saw the lever arm on the other half of the door, which by position had to be the way that the timer interacts with the soap dispenser. After turning off the power to the dishwasher, I removed the switch cover (not obvious how -- a video would help: on the left, I slid the narrow rectangular plastic wire cover a little to one side and gently opened it on its little hinge, which is near the left side of the door, and then... Read more
Water leaking from bottom of fridge? Cracked evaporator drip tray lets defrost water escape. Moderate DIY repair, about 45-60 minutes with our guide.
The drain pan (Tray-Evaporator Pan) was cracked in 2 places. We had to remove the front panel. Loosen the bracket that holds the water filter. Take off the back panel and disconnect the bracket that holds the selenoid. It was not necessary to unhook the water lines, just the bracket. It was not easy to remove the old pan and get the new one in, but holding the water filter, with the bracket intact, as far to the left side of the refrigerator as possible gave us the room to get the pan in. ... Read more
Secures the handle end cap to the center of your refrigerator door. Replace if missing, stripped, or lost during handle repairs. 8-18 x 1/2 inch size.
This was actually one of the easiest fixes I’ve done. All that was required was to remove 3 screws to remove the broken part. I used a pair of pliers to remove the moisture sensors from the broken part to the new one. Read more
Fix an ice maker that stopped working or leaks water into the bin. This ice mold tray replacement takes about 10-20 minutes with our step-by-step video.
I have a Whirlpool Side-by-side Model ED22PWXBW01. A year ago, the ice cubes started freezing together in the rear of the ice bin for no apparent reason. Although the problem started off small, it gradually grew much worse, and finally I could see water dripping out of the ice mold and into the bin during the fill cycle. Re-levelling the refrig didn’t help, nor did adjusting the cube size / fill level. With guidance from the video, I removed the icemaker from the wall of the freezer. The... Read more
Ice maker not filling or water leaking? The water inlet valve controls water flow to your ice maker. Common DIY repair, typically 15-20 minutes.
Ordered water inlet valve, watched repair video and installed it very quickly. Totally solved problem. Defrosted freezer and working great now. Read more
Stores and chills water before dispensing. Replace if cracked, leaking, or causing slime/film buildup in dispensed water. Installs inside refrigerator.
After watching installation videos on each felt I could pull it off and ordered and received replacement water reservoir and water dispenser tube assembly. Reservoir installation went off without a hitch outside of the added step of the need to remove the entire main in waterline assy in order to access the connectors which also were not as represented in video, in that they were not the press-to-release type but standard threaded compression types. Water Dispenser tube/spout assembly was much... Read more
Replacement door bin for refrigerator door storage. Installs on the inside of the refrigerator door. Replace if cracked, broken, or missing.
Thanks to the testimony of others on the site, I knew exactly which parts to order. The triangular holder which keeps the ice storage container was cracked so I replaced it. I also ordered a new Auger Motor Drive Shaft which makes the curvy metal piece in the bin turn. Mine had worn down and would not turn the curvy metal piece anymore. Replacing these pieces worked like a charm. My kids were amazed that ice now comes out of the door after 2 months of having to reach inside. Read more
Freezer icing up or refrigerator too warm? This defrost control board coordinates defrost cycles to prevent frost buildup. DIY-friendly 15-30 min repair.
Tried to put refrigerator in defrost mode and defrost would not initiate. Checked the bi-metal and heater, both tested good. Replaced the ADC board and refrigerator went in to defrost. problem solved. Read more
Ice not dispensing? A worn auger drive bar with stripped threads prevents ice from moving through the chute. Moderate DIY repair with video guidance.
I replaced the auger motor. You have to remove complete ice maker. Everything is just like help video to do except yoke dispenser. I watched video several times. Yoke will not just tap loose, after 30 minutes of tapping, I was using screwdriver to brace. I used a Dremel tool to cut part of shaft, came off easy then. After that, the repair went great. I have ice, I noticed motor I received was stronger. Parts came on time stated and worked great. I will order again on other repairs. Read more
Fix a loose or wobbly dispenser paddle with this strain relief. Cushions the dispenser arm connection to prevent wear. Easy 5-minute repair with video guide.
With the help of the fantastic videos provided on the web site for each replacement part, it was extremely easy to complete the repair Read more
Creates an airtight seal around your refrigerator door perimeter to maintain proper cooling. Replace if cracked, torn, or no longer sealing. Confirm fit by model.
Orders and replaced door seal. The delivery was Fast!! The How-To video walked us right thru it! A relatively easy fix. Then I found out it wasn't the door seal, it was the door Cam...I got the part and that video was also a great walk thru. I will return to your site! Thanks, Dave Read more
Refrigerator warm but freezer cold? Noisy evaporator fan? This mounting grommet reduces vibration and noise. Takes about 1 hour to replace with video guide.
I noticed Ice maker Quit for the third time in 15 years so I decided to buy another Ice maker, I installed it and NO ice still?? Well I went after the other problem thinking if it does not get cold enough maybe ice maker won’t work. I ordered Defrost Switch, Heater and Evaporator Fan just to be safe. I replaced all three, the fan was noisy, the heater OHM’d ok but I replaced it as did the defrost switch, I put it back together, the Freezer got to 0 degrees and the frig got to 38 degrees so I... Read more
Forms an airtight seal around your refrigerator door to maintain temperature and efficiency. Replace when torn, cracked, or no longer sealing properly.
Order part and done. you guys are amazing I was expecting my part in 7 to 10 days and got it less then 24 hours after I order. thank you.... Read more
Fix dishwasher leaking from pump housing with this impeller & seal kit. Repairs worn seals causing water leaks. DIY-friendly, typically 30 minutes.
Replaced pump impeller. Read more
Fix a dishwasher that won't advance through cycles or gets stuck mid-wash with this timer cam. Regulates wash cycle timing via internal camshaft design.
Accidently threw away EVERYTING that was attached to the timer, but Appliance Parts Pros had what I needed, except the screws, but I was able to figure out what screws I needed. Hardest part was figuring out where the off position was on the timer. Read more
Fix a dishwasher that won't drain completely with this filter ball. Sits in the sump track to prevent debris backflow. Easy 30-minute DIY repair.
Replaced sump and related pieces. Also replaced door baffles that were getting bad. The hardest part of job was removing the dishwasher from the its spot in cabinets. The info on site made replacing parts easy. Read more