Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Carries defrost water from evaporator to drain pan in your refrigerator. Replace if cracked, brittle, clogged, or missing to prevent leaks and puddles.
Replaced the drain pan below the evaporator coil (it was rusted to the point had a hole in it) and decided to replace both drain tubes since I had to open up the back panel. The video on the website was very helpful. Thanks!! Read more
The recess door retainer secures the dispenser's ice chute flapper in the refrigerator door. Replacing a cracked or missing retainer restores proper flapper pivot and sealing to help reduce frost buildup and air leaks around the dispenser.
Replaced springs, flapper assembly and ice door retainer as described in videos and it was easy. So far so good..water dispenses. Read more
Protects the freezer light bulb from damage while maintaining visibility. Replace if cracked, yellowed, or broken. Confirm fit with your model number.
Replace solenoid, flapper door and recess spring. Really only needed solenoid, but other parts were so inexpensive and I knew I would already be in there. Read more
Plastic water line that runs from the water valve to the icemaker fill tube. Replace if cracked, brittle, broken, or leaking at connection points.
Thanks to the AppliancePartsPro, I ordered it online and received it quickly. I even used the step by step directions on how to replace the tube from the AppliancePartsPro website. Just be very careful and review the instructions first. Couple of important things: 1. Take a picture of the existing wiring and tubes before you take them apart. 2. *if* you remove the wires ( red and white plugs) from the valve, make sure you plug them back in correctly. 3. Do not pull or push the tubes hard. Use... Read more
Fix a light that won't turn on or flickers in your refrigerator. This E12 socket replacement is straightforward with our step-by-step video guide.
When diagnosing the problem, I discovered that the ice door was not properly sealing and that the solenoid had appeared to rust/corrode forcing the door open. I replaced most of the ice dispenser internals (solenoid, crank, door, and spring) following the video. The door will now open when dispensing ice (which it does!), and will oddly stay open for a few seconds once I am finished, but does seal properly and the chute/container no longer frosts over. Read more
Ice won't dispense or drive spins freely? This auger drive coupler connects the motor to the ice bucket. Moderately difficult repair with basic tools.
The auger in ice bucket was frozen and locked in place (some how liquid water must have spilled inside and froze the shaft and bushing). When the motor was activated to deliver ice, the jam caused the motor shaft to strip the threads. With the threads stripped, there is no way (that I could find) to get the drive auger off of the shaft (btw, it is left-hand threaded). Apparently the Drive Auger is made of stainless steel - a harder metal then the motor shaft. To repair it, I removed the... Read more
Replacement chill pan drawer that slides into refrigerator shelf rails. Needed when original pan is cracked, broken, melted, or missing. Exact fit.
Replaced it Read more
Fixed freezer shelf for side-by-side refrigerators. Replace a cracked, broken, or missing shelf to restore organized storage and spacing.
Ordered replacement shelves Read more
Base grille kickplate mounts across the lower front of your refrigerator, covering the condenser area. Replace if cracked, broken, or missing.
Ordered part and installed in about 2 minutes. Read more
Refrigerator not cooling or running constantly? This compressor powers your cooling system. Advanced repair, allow 2-4 hours for replacement.
Replacement mounting screw for refrigerator panels, brackets, door handles, and trim. Needed when original hardware is missing, stripped, or corroded.
Supplies electrical power from wall outlet to refrigerator. Replace this cord if cut, frayed, overheated, or damaged to restore safe electrical connection.
Spliced new and old power cord near the connections in the fridge and connected them. Didn't mess with the factory harnesses or connections inside actual fridge. Read more
Black bottom door hinge and pin assembly for side-by-side refrigerators. Replace this load-bearing pivot component if cracked, broken, or worn out.
I replaced the lever asm. and spring Read more
Fix temperature fluctuations and inconsistent cooling. This refrigerator control board regulates defrost and temperature. DIY-friendly replacement.
In the past the temperature would change from one day to the next, remain constant for weeks then start rising again. Would unplug for 5 – 10 min and adjust temp and would work fine. Now Refrigerator compressor will not shut off (has been running for the last 3 days) temps are 26F on freezer side and 43F on food compartment side. Checked evaporator and it has a great deal of frost on it but not frozen. Checked for continuity on the defroster heater and thermostat by going through the... Read more
Fix a warm Custom Cool drawer or knocking noise from the bottom compartment. This fan assembly restores proper airflow for faster chilling. DIY repair.
I replaced the fan and heater element. The replacement was not an exact match. I had to adjust the parts to get the harness to fit the plug was not the correct size. I cut it off and used the existing plug. Not a big deal and everything else fit. Pretty good for a twenty year old replacement. Also the heater element was a different shape but it fit as is. Read more
This is a grommet and it is intended for use on refrigerators and freezers. This is a genuine replacement part made by General Electric. A new grommet might be needed if the current one is visibly worn out or damaged in any way. If there are noises fro
Installed new stainless steel pan replacing broken original plastic pan and installed new rubber grommets for the compressor Read more