Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Factory black screw that secures panels, trim, or brackets on your oven. Replace missing, stripped, or damaged fasteners to restore secure fit.
Turned off breaker,unscrewed (2 screws) element,pulled element out from back of oven,unplugged 2 wires, attached wires to new element, pushed back in, installed retaining screws Read more
Fix ice dispenser frost buildup and warm air leaks with a new ice chute hinge. Restores smooth door movement and seal. DIY-friendly, about 1 hour.
I have a Jenn-air Refrig/Freezer, manufactured by Whirlpool. Since there was no repair video @ApplianceProsPros for my specific job, I searched YouTube and found something similar. It gave me a good idea of what I was up against. I ordered the needed parts, which arrive in a short amount of time. I turned off the power/circuit-breaker then removed the dispenser cover, which was held onto the freezer door by two screws at the bottom of the tray. I disconnected the power plug to the printed... Read more
Rear roller that helps move your refrigerator smoothly. Replace if broken, cracked, or wobbling to restore easy mobility. Confirm fit by model number.
Removed all the food from the freezer and most from the fridge before starting. Tipped fridge back until I could place a 2 x 4 a couple of inches behind the front rollers. With the front of the fridge now approximately 3 to 4" off the ground you can remove the adjusting bolt and the roller assembly can be pulled out of the brackets. Slide out of the notches where that hold it into the bracket. Same to install. Read more
Replaces worn or broken pump solenoid springs in your dishwasher. Restore smooth operation when original springs are damaged, missing, or weakened.
Detergent cup not opening during wash cycle? This actuator lever connects the timer to the dispenser lid. Moderate DIY repair, about 35 minutes.
This happened after a repair man came out and replaced the timer. Not my doing landlord had a service contract. Once inspected I found when the timer was swapped he did not swap the cam over. Ordered the correct parts and repaired myself. Hard to find good help anymore. Read more
Fix dishwasher overflows or underfilling with a new water level float. This part regulates filling by rising with water to signal the switch.
1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve. Parts $220 for Dishwasher Estimated Labor $400.00 Labor $0.00 Parts $100.00 for Pullout Faucet Estimated Labor $175.00 Labor $0.00 Read more
Dishwasher overflowing or not filling? This float switch detects water levels to prevent overflow and control filling. DIY-friendly repair part.
1. Removed the water inlet/shut off valve, removed and cleaned the screen. while the valve was removed applied electrical power to the valve and it worked just fine. 2. replaced the broken float switch. Read more
Covers the lower front service opening on your dishwasher. Replace if cracked, dented, scratched, or missing to restore a clean appearance.
Simple fix unscrewed old panels and screwed in news ones Read more
Fixes frost buildup on evaporator coils and inconsistent cooling. This refrigerator defrost heater melts ice during defrost cycles. 20-minute repair.
I removed the shelves and the shelf holders, took the back panel off, loosened the evaporator. Removed the heater element and the thermostat. Re-installed the evaporator the back panel, shelve holders and shelves. Then I located the defrost timer in the refrigerator. Read more
Secures dishwasher sump to tub, maintaining seal compression to prevent leaks. Replace if corroded or weak. Confirm fit with your model number.
Took the impeller out, removed the pump, replaced connector, put new clamps on, reassembled and checked for leaks. I just followed Arts video, went smooth. Wifes happy, things are good. Thanks AppliancePartsPros.com Read more
Replaces a worn or heat-damaged refrigerator light socket to restore interior lighting. Install when bulbs won't light despite replacement. Confirm fit by model number.
I bought a new bulb but it did not work. Then the super looked at it and realized the socket was not good. Read more
Protective seal grommet for hoses, tubes, or wires passing through refrigerator cabinet. Replaces cracked, worn, or missing grommets to prevent leaks.
Fixes clicking noise from compressor and fridge not cooling. Includes relay, overload protector, and capacitor. Most DIYers complete in 20-30 minutes.
Thawed out the evap/heat exchanger assembly, replaced the overload/relay kit as well as the defrost control board and the fridge was back in business, everything working fine. I'm kicking myself for not ordering these parts earlier. there was a clicking sound coming from the compressor that I ignored which was a huge mistake. Read more
Refrigerator making clicking sounds and not cooling? This overload relay kit fixes compressor start problems. Easy DIY repair—pull off old relay and install.
I was able to pull off the old relay and swap out with the new relay. Everything went together perfectly. Read more
Secures covers, brackets, and internal panels in your refrigerator. Replace missing, stripped, or corroded screws to restore tight mounting.
I ordered the part from you which arrived much sooner than expected. I replaced the Rail-Mulln. It was so easy to fix, next time I'll let my wife do it. Read more
Fix a refrigerator that won't cool or has a buzzing compressor. This overload relay provides start assist and protection. DIY repair in under an hour.
Unplug the fridge and slide it out from the wall. Remove the lower back cover. CLEAN EVERYTHING. We used compressed air, a vacuum, and a damp rag. The compressor was really hot because the unit was still limping along, so I set up a vortex fan to cool everything down. I removed the support wire, gently wiggled the capacitor off, then removed the relay. EASY! The overload relay was the problem. It rattled. I took it apart and found the insulator inside was shattered. It's hard to believe it was... Read more