Rts265tdrs Parts

Replaced the ice tray and motor mount plate. While I was there I replaced the thermostat also. New parts arrived in a day and a half. Read more

I had to cut one bar for the small door shelf since they only come in one size. The bars pop in on plastic clips. Read more

Simply replaced the broken ice stripper with a new one. Read more

Replaced motor, fan and lock-nut. My repair was on a built in Refrigerator-Freezer so most of the time was spent on pulling out and putting back the unit to get to the area I needed to behind the upper top. Read more

It was a relatively easy fix and the video instructions on this site provided were helpful. The one piece that wasn't clear is the alumilastic was already on the replacement part so a separate tube is not required. That wasn't clear on the video and was an unneeded expense. Read more

Replaced the control board after removing the inner door liner, plastice board cover and board itself, by removing screws, working various plastic clips/tabs and unclipping wire harnesses from board. most of time was spent cleaning the black soot from the door, which had a terrible burnt electrical/plastic fire smell. Cleaned mold/scale off of as much of the door as I could while in there as well. Removing parts without breaking plastic tabs to hold the new parts was trickiest part. Read more

• Fridge too cold

Replaced cold control Read more

I read the help guide on the AppliancePartsPros.com web site and then decided to test my defrost heater with a volt/ohm meter. I read an open circuit. I then removed the radiant heater element from the refrigerator and see nothing wrong with the element, but the connection on both sides to it, that resemble a spark plug wire to an automotive plug, was corroded to a powder making no electrical connection. I then searched for the replacement part to find that Amana discontinued the part after... Read more

Watched the video at Appliance Parts Pros. Followed the video. I was fixing the refrigerator door (a little easier then the freezer door). The repair was very simple and took less then 15 minutes. Read more

Ordered a new part. I removed the shelves and drawers to clean and unfortunately the center shelf support was not found. Read more

• Fridge too warm

I replaced the defrost timer. It's a 27 year old Montgomery Wards refrigerator and I couldn't find the correct timer anywhere until I contacted AppliancePartsPros. Great service. Read more

I ordered and replaced the old ignitor and the corroded mounting screws. Read more

Replaced the heater coil and the Thermostat underneath the freezer floor. 1. Unplug the Power, allow the ice build-up to thaw (Use hair-dryer). 2. Remove the heavy duty Plastic Tray (Freezer Floor) very carefully (the left and right side lips of the tray are snapped behind the sides of the freezer frame, un-snap the lips using flat spatula) . Gently pull out the Tray 3 Remove the plastic shroud (cold air diverter) at the back of freezer section (after removing the screw, tuck-up the shroud to... Read more