Water Flow Sensor Parts

Replaced hose that came with the new washer with this longer one. Read more

Replaced the thermst-fix and the thermal fuse oven now works great Read more

Replaced filter with plug. Read more

Removed exterior panels, cleaned all venting, replaced outlet thermistor and thermostat. Pressure washed all removable parts. Reassembled. Now working as it should. Read more

Replaced filter. Read more

• Won't start
• No heat or not enough heat

Did some dryer repair research (dryer not heating) on the internet. Bought an ohm meter, opened up the dryer and tested the cut-off-T, high limit thermostat, dryer igniter, flame sensor, cycling thermostat for continuity. The igniter was bad, the other parts tested ok. Went online to AppliancePartsPros.com searched for a new igniter for my specific dryer model, found the right replacement igniter and watched the video on how to replace the igniter. Because my dryer is old (15+ years) and I... Read more

• Leaking
• Not dispensing water

Turned off water behind the fridge. Unscrewed housing that covered water lines behind the filter base with a 1/4" socket. Pulled out the water hoses by pulling forward on the blue ring holding the hose while pulling the hose backward. Unscrewed the two screws below the filter base. Used the 1/4" socket to remove four additional 1/4" nuts holding the front housing until it partially dropped. I kept the housing propped on a jar. Unscrewed two additional screws holding the filter release rod in... Read more

Replaced fuse. It took much longer to get the oven out of the wall to access the fuse and replace the front panel than to do the repair. This fuse failed at the end of the cleaning cycle for the bottom oven and left the door locked because the open fuse removed the 120v power from the control board. The locked door made it impossible to remove one of the screws holding the wall oven in place. However, after I ground off the head of the screw behind the edge of the locked door I was able to... Read more

• Frost buildup
• Doesn't shut off
• Fridge too warm

I removed the defrost sensor assembly, installed a new one, it worked. Because of a shipping problem with FEDEX, Appliancepartspros resent the parts not once but twice. Needless to say, they are my go-to source for parts from now on. Read more

Found the correct USA made OEM part from Appliance Pros, and installed it on my new Dishwasher. The use of this correctly manufactured Adapter prevented any damage to the threads of the dishwashers inlet solenoid valve which is made of a plastic material. If I had forced the after market adapter onto the solenoid valve instead of ordering the OEM adapter; it would have ruined the threads on the plastic solenoid valve resulting in the need to purchase a very expensive replacement valve. ... Read more

Checked vent first to see if there was a blockage. Removed top, front and drum of dryer. Replaced all sensors including flame detection and gas valve coils. Re-assembled and tested. Dryer was now heating Read more

Used vids on youtube for steps on how to disassemble and install the pump; search "Bosch dishwasher circulation pump replacement". Also on AppliancePartsPro forums, a poster put up the Bosch "Dishwasher Service Training Manual" in .pdf. Search "Bosch dishwasher low pressure" on the forum. It's one of the post with the longest thread. Six pointers. 1. In another forum post, the poster noted that some hoses were brittle with age - and cracked when reinstalling. I had same issue (my washer is... Read more

Ordered a bypass and installed it. Read more

So I replaced the hi-temp thermostat and the problem is fixed. Read more

• Doesn't shut off

Looked online. Others said to start with the thermostat because its cheap and easy to fix, so I did. The thermostat is located at the rear of the oven on the back. You need to remove a total of 3 panels to get to it. Do not confuse it with the thermal sensor at the rear of the oven on top. My thermostat was clearly deformed, and I had never run a self clean like other with testify to. Simply replace it - easy. Oven worked like new. Read more