Control Board Parts

Replaced new motherboard and face plate. Read more

It's very easy fix. If your unit flashing e2 f2. It's your relay board take screw if on door couple latched s on the gray relay box pull wires harness of slow. Re install the same way it came of Just remember to cut the power off first . Leave your door open when re powering unit. Read more

I contacted Appliance Parts Pros, and told them what the problem was and what it was doing. They sent me an email with the parts number needed to complete the repair. This was a built in a cabinet unit and I required help removing it and reinstalling it. The repair was relative easy once I had the parts and it took approximately four hours,. It took longer getting to the defective parts than replacing them. ... Read more

Easy. Opened the front panel, removed the timer, went on line with the part number. Part arrived the next day and I installed it in 2 minutes. FIXED. Read more

The basin would fill but would not agitate, there was no sound, no grinding noises, no sound of a motor running without agitation due to a broken belt. The basin full of water was able to drain if I advanced the timer to Spin. By playing around with the timer dial further, I could get every function of the washer to operate, at least partially. So, that said electrical problem to me. I assumed the trouble was either the safety switch at the back of the lid or the timer mechanism. Tested... Read more

I replaced the main control unit Read more

• Freezer not defrosting

I had had the same problem 4 or 5 years ago and spent close to $200 to repair it. I did have the slip from that repair with part #'s so I went ahead and ordered a defrost timer and thermostat. You-tube had plenty of videos on replacing those parts and even before they arrived I was able to add a switch and bypass the broken thermostat and start a cycle manually with the timer. (which it seems was was still functional). Between that and cycling some ice packs up from the still working... Read more

• Freezer not defrosting

I took the bottom tray out of the freezer and found the coils iced up severely. I was reasonably sure the defrost timer was the problem and your tech said that was a good possibility. Ordered and replaced timer. (15 minutes) Problem fixed!!! Saved purchasing a new fridge at big bucks. We live over 40 miles from a service center so the cost of having a tech come out is astronomical. Thanks!!! Read more

• Touchpad does not respond

I ORDERED A NEW CONTROLLER BOARD. THE DIRECTIONS SHOWED HOW TO UNCLIP THE OLD BOARD BUT THE FASTENERS WERE ON THE LEFT SIDE NOT THE BOTTOM AS INDICATED ON THE REPAIR INSTRUCTIONS. AFTER REASSEMBLY THE DISHWASHER FUNCTIONED AS NEW. THNKS FOR THE INSIGHT. Read more

Ordered the part from Appliance Part Pros. It came in one day! Had to disconnect the gas line and wrestle the unit out of the wall cabinet, but the repair was easy and straightforward. The job took less than an hour Read more

I replaced the control board. Repair company wanted $395.00. I ordered the board for 140ish, 5 days later, 9 screws, 6 moduler plugs....working oven. The hardest part was pulling out the stove. Read more

Checked circuit breaker to d/w first. Good. Went to website to see no power issues. Most all of them mentioned the noise filter being the problem. Removed filter from machine and found the corner melted where fuse is located. Ordered new filter, installed, and now have power to switches. All the information I found on the website really made this a easy job to get done. Read more

• Timer will not advance

Just as the folks in the comments section said, I tested everything to make sure the timer had power which it did. I then tested with the OHM tester and saw that the switch was open when the timer was set to any drying cycle. So i changed the timer and voila! timer is functioning again. It was a very easy fix. Just pop the four screws out of the back of my timer panel on the dryer, detach all the wires, lift up on the little bracket that is holding the timer in place and twist it, and it... Read more

My experience could not have been smoother. I called the repair guy just to see how much money I saved and I was shocked! I saved $123.00, thanks to appliance parts pro. Thank you so very much for your professional help, great prices & super fast shipping! From now on, when another appliance needs repair I'm going to you guys first. I'm spreading the word to every single person I know and posting it on social media as well. Thanks again, Jeremy Read more