Water Temperature Sensor Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP31001192
If your dryer is overheating, running too hot, or taking extended times to dry clothes, a faulty cycling thermostat is often the cause. Easy DIY fix.
Do-It-Yourself Stories from Customers like You
No heat on dryer low setting insufficient drying even on high extended times to dry Thomas M. • Galax , VA • June 12, 2016
Ended up replacing the cycling thermostat which corrected the problem. Andrew C. was very helpful with considerations and return of unneeded parts as well as very informative technical assistance. Could not have been treated better.
Read more
More
$79.24
- Compare At:
-
$95.09
- You Save:
-
$15.85
Genuine Whirlpool part
By: Whirlpool
Part Number: WP31001590
Fix a dryer that won't heat or overheats with a new thermistor. This temperature sensor ensures accurate heating cycles. DIY repair in 30 minutes.
Do-It-Yourself Stories from Customers like You
Dryer ran but wouldn't heat the only thing i could find was the thremistor only real at 8 ohms instead of a little over 10 Ross M. • Ohiopyle , PA • October 24, 2016
Installed a new thermistor tempiture control and it heats up as it should.
Tools used was a ohlm meter, 1" stiff puty knife, #2 Philips screw driver, neadle nose pliers,1/4 & 5/16 nut drivers.
Read more
More
$59.48
- Compare At:
-
$71.38
- You Save:
-
$11.90
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3378144
This tube connects the water supply to the middle wash arm of the dishwasher, delivering pressurized water so the spray arm can spin and clean dishes on the upper rack. It runs vertically from the lower area of the tub up to the mid-level spray arm assembly. Replace this tube if the middle spray arm is not spinning, dishes on the upper rack are not getting clean, or if you notice leaks or cracks in the tube.
Do-It-Yourself Stories from Customers like You
Rotted manifold tube Joseph L. • Hermantown , MN • December 26, 2015
Part was updated from original equipment (3 pieces) to a one piece tube.
Snip the top of hanger loop then install. Just a couple minute job.
Updated tube is much better than the original design.
Read more
More
$49.51
- Compare At:
-
$58.42
- You Save:
-
$8.91
Genuine Frigidaire part
By: Frigidaire
Part Number: 131298300
Dryer won't heat or overheats? A failed cycling thermostat can't regulate temperature. This direct-fit part takes 15–30 minutes to replace.
Do-It-Yourself Stories from Customers like You
Rubbing blocks and felt that seal the front of the drum are worn drum is sagging and staining clothes with smears of rust Seth W. • Upper Arlington , OH • January 23, 2016
Replaced upper and lower felts. Painted rubbing surface on inside of drum with refrigerator enamel. Took out drum and lubed rear bearing. Replaced 2 of the 3 thermostats, and the belt just on principle.
Spent a lot of time with shop-vac removing lint from drier and exhaust ducts.
Runs great and is no longer cooking or staining clothes.
Read more
More
$52.76
- Compare At:
-
$63.31
- You Save:
-
$10.55
Genuine Lg part
By: Lg
Part Number: EBG32952202
THERMISTOR ASSEMBLY,PTC
Do-It-Yourself Stories from Customers like You
Lg refrigerator wound not start Steve S. • Peoria , AZ • May 28, 2016
For an emergency fix I installed a 3 in1 kit disabling the original start cap and wiring in the original run cap to the run winding.
Ordered the proper PTC and overload from Appliance Parts Pros and installed them 2 weeks later.
The original start and run capacitor were good, rewired back to design specs.
The original PTC had pins 1,2 and 3, the replacement had 2,3 and 4.
Only wiring change was to install the red wire from pin 1 on the original PTC to pin 4 on the new PTC.
Read more
More
$37.95
- Compare At:
-
$44.78
- You Save:
-
$6.83
Genuine Bosch part
By: Bosch
Part Number: 00088403
2 clamps included.
Do-It-Yourself Stories from Customers like You
Missing part to reinstall dishwasher to disposal James I. • Rochester , NY • October 07, 2014
ORDERED TUBE AND CLAMPS
Read more
More
$19.21
- Compare At:
-
$23.05
- You Save:
-
$3.84
Genuine Frigidaire part
By: Frigidaire
Part Number: 240434401
Replace your refrigerator's water filter cup if cracked, leaking, or frozen. Protects the filter and prevents leaks. Verify fit with your model number.
Do-It-Yourself Stories from Customers like You
Water cup frozen & cracked do to - 35 Mike T. • Greensburg , IN • March 12, 2014
Replaced cup & housing
Read more
More
$62.61
- Compare At:
-
$73.88
- You Save:
-
$11.27
Genuine Frigidaire part
By: Frigidaire
Part Number: 5303918638
Freezer coils icing up or not defrosting properly? This defrost thermostat monitors evaporator temperature to control defrost cycles. Moderate DIY repair.
More
$85.76
- Compare At:
-
$102.05
- You Save:
-
$16.29
Genuine Whirlpool part
By: Whirlpool
Part Number: W10120840A
Carbon filter for range hoods and over-the-range microwaves. Dimensions: 5-5/8" x 11-9/16" x 3/8" (5.625 x 11.5625 x 0.375). Rectangle shape. Removes cooking odors from cooking air. Replace when clogged, discolored, or every 6-12 months.
Do-It-Yourself Stories from Customers like You
Just annual replacement Nathaniel M. • Virginia Beach , VA • December 13, 2014
Replaced it.
Read more
More
$22.53
- Compare At:
-
$27.04
- You Save:
-
$4.51
Genuine Whirlpool part
By: Whirlpool
Part Number: EDRARXD1
Vessel water filter that replaces the refrigerator's vessel-style cartridge to restore filtered water delivery and reduce visible particles, off tastes and odors at the dispenser and ice maker for clearer, better-tasting water. What it does:
- Filters water flowing through the vessel cartridge to reduce sediment and visible particulate in dispenser output.
- Helps improve taste and odor commonly noticed when a filter is aged or clogged.
- Addresses symptoms such as discolored water, stray particles in dispensed water, or unpleasant dispenser/ice taste.
- Restores expected filtration performance when an old or saturated vessel cartridge is the source of water-quality complaints.
What's included: One vessel water filter. Install notes:
- Turn off the refrigerator water supply and before beginning replacement.
- Remove the old vessel cartridge per OEM instructions and install the new filter in the same orientation.
- After installation, run the water dispenser until the water runs clear to purge air and any loose media.
- If you see leaks or continue to have water-quality or flow issues after replacement, shut off the water.
More
$65.08
- Compare At:
-
$76.11
- You Save:
-
$11.03
Genuine Whirlpool part
By: Whirlpool
Part Number: W10169881
Dryer not heating? A blown thermal cut-off is a common cause. This safety fuse opens if overheating occurs. Test with a multimeter for continuity.
Do-It-Yourself Stories from Customers like You
Dryer not heating (f31 error code Andrew D. • Kennewick , WA • April 17, 2015
Checked the heating element and found that it was shot so I bought a new one with out checking the thermostat and the cutoff-tml. I received the new element and it still wasn't heating so I had to wait another week for the cutoff-tml to be delivered. If your dryer isn't heating, make sure you check all parts of the heating system with a multimeter before you order new parts.
Read more
More
$73.95
- Compare At:
-
$88.74
- You Save:
-
$14.79
Genuine Ge part
By: Ge
Part Number: WE4X857
The Thermal Fuse is an OEM part for GE dryers. This part prevents the dryer from overheating by cutting off the power if the dryer exceeds a certain temperature.
Causes of a bad thermal fuse can include regular wear and tear, lint build-up, restricted airflow, or a malfunctioning thermostat.
Symptoms of a bad thermal fuse include:
- The dryer not starting
- The dryer shutting off unexpectedly during a cycle
- No heat production during drying
- The dryer running but not heating
This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.
This part fixes the following symptoms
-
No heat or not enough heat
See more...
Do-It-Yourself Stories from Customers like You
No heat Mitchell T. • Issaquah , WA • September 29, 2014
Very easy to replace the fuse. Unplug the unit. Take off the back and swap it out. Only two wires.
Read more
More
$63.95
- Compare At:
-
$76.74
- You Save:
-
$12.79
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3368928
Dishwasher won't heat or dry dishes? A blown thermal fuse cuts power to the heating circuit. Easy plug-and-play fix—most DIYers replace in minutes.
Do-It-Yourself Stories from Customers like You
Heated dry wouldn't work Steven L. • Fenton , MI • June 13, 2014
I took a multimeter and found out that the old fuse was open. I ordered this new one and popped it in. Pretty easy fix and it's still going strong.
Read more
More
$52.44
- Compare At:
-
$62.40
- You Save:
-
$9.96
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10178809
Fix a dryer that won't heat or overheats with this cycling thermostat. Regulates heating element temperature for consistent drying. Simple DIY repair.
Do-It-Yourself Stories from Customers like You
Worn or broken thermostat. Nicholas R. • Canyon Lake , TX • March 14, 2024
It’s a simple fix. Unplug the wires and remove the two screws and replace it with the new one.
Read more
More
$58.43
- Compare At:
-
$69.53
- You Save:
-
$11.10
Genuine Bosch part
By: Bosch
Part Number: 00636459
This is an active carbon filter designed to remove odors from inside the refrigerator compartment. It absorbs and neutralizes food smells to keep the interior air fresh. Replace this filter if you notice persistent unpleasant odors inside the refrigerator despite cleaning, or on a regular maintenance schedule as recommended.
Do-It-Yourself Stories from Customers like You
Active carbon odor filter needed replacing Ray C. • Beaverton , OR • January 03, 2016
Ordered 2 to optimize shipping cost. Pulled used one and replaced it with a new one.
Completely satisfied with World Class service.
Read more
More
$30.26
- Compare At:
-
$36.01
- You Save:
-
$5.75
Genuine Lg part
By: Lg
Part Number: 6323EL2001C
This NTC thermistor is the dryer's temperature sensor. It monitors exhaust air temperature and signals the control to cycle the heat, restoring accurate drying performance and helping prevent overheating, underheating, and inconsistent results.
- Monitors exhaust air temperature by changing resistance as heat rises (NTC behavior)
- Sends temperature feedback to the control to regulate the heater or gas valve
- Failure can cause no heat, overheating, or erratic temperatures
- May lead to long dry times, short cycles, or temperature-related error codes
What's included: 1 thermistor Install notes:
- Disconnect power and, for gas models, shut off the gas supply before servicing
- Access the sensor on the blower housing or exhaust duct; location varies by model
- Note wire routing; unplug the harness connector; remove the mounting fastener/clip; install the new sensor fully seated and reconnect
- Reassemble, restore power, and run a test cycle; check and clean venting to ensure proper airflow
More
$31.32
- Compare At:
-
$37.27
- You Save:
-
$5.95