Yard Machine Small Engine Start Switch Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: W11036551
This is a small electrical switch mounted near the dryer door opening that detects whether the door is open or closed. It completes the circuit that allows the dryer to run when the door is shut. Replace this switch if your dryer won't start, stops mid-cycle, or runs with the door open.
Do-It-Yourself Stories from Customers like You
Problem started with dryer not getting hot and eventually shutting off within 5 minutes of operation. Meynardo G. • Orange Park , FL • March 22, 2022
I used Google and YouTube to search for troubleshooting videos and ordered the parts through AppliancePartsPros.com. I watched the repair videos on parts replacement and found it very helpful. Got it done in about an hour and tested it. It works!!!!!
Read more
More
$48.46
- Compare At:
-
$58.15
- You Save:
-
$9.69
Genuine Whirlpool part
By: Whirlpool
Part Number: WP74009254
The fan control switch is the panel-mounted switch that sends power to the appliance's fan motor. Replacing a worn switch restores reliable on/off control and proper airflow so the fan starts and stops when it should.
- Provides user-operated on/off power to the fan/blower motor
- Helps regulate airflow for cooling, venting, or convection depending on model
- Typical symptoms: fan won't run, runs continuously, intermittent operation, or a loose/broken switch shaft
- Mounts behind the control panel and is actuated by the exterior knob/lever
What's included: One fan control switch Install notes:
- Disconnect power at the breaker before servicing
- Remove the control knob/actuator and panel trim to access the switch
- Note wire positions or take a photo; transfer wires one at a time to the new switch
- Secure with the original hardware, restore power, and test operation
Do-It-Yourself Stories from Customers like You
The fan switch on our jenn air cooktop broke Jonathan B. • Bend , OR • March 29, 2015
After looking at several YouTube videos that were only moderately helpful for my particular model, I disconnected the power at the breaker, disconnected the wires below the cooktop to the junction boxed lifted the whole unit out, including the fan assembly. I flipped it upside down and took off the screws holding the unit to the glass top. Although the new fan switch did not look the same as the original switch, the new switch does fit. The new switch did not come with a hex nut. The old hex...
Read more
More
$135.31
- Compare At:
-
$161.02
- You Save:
-
$25.71
Genuine Whirlpool part
By: Whirlpool
Part Number: 12002792
Burner won't spark or ignite? This surface burner ignition switch triggers the spark module when you turn the knob. 45-minute DIY repair for ranges.
Do-It-Yourself Stories from Customers like You
Igniter switch shorted out Jeff J. • Hoffman Estates , IL • October 11, 2016
Replaced switch assembly
Read more
More
$102.32
- Compare At:
-
$121.76
- You Save:
-
$19.44
Genuine Ge part
By: Ge
Part Number: WH12X10510
Washer won't respond to cycle selections? This selector switch mounts behind the control knob to restore reliable setting changes. Easy DIY fix.
More
$27.79
- Compare At:
-
$33.35
- You Save:
-
$5.56
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304482236
If your hood won't turn on or respond to controls, this switch may have failed. Requires removing the grease filter and lower pan to access and replace.
More
$125.95
- Compare At:
-
$151.14
- You Save:
-
$25.19
Genuine Whirlpool part
By: Whirlpool
Part Number: 4387535
Fridge not cooling but lights work? This compressor overload stops overheating and prevents startup damage. DIY-friendly repair in about 1 hour.
This part fixes the following symptoms
-
Won't start
-
Fridge too warm
See more...
Do-It-Yourself Stories from Customers like You
Overload switch stopped working turning off the refrigerator compressor J Michael L. • Waxahachie , TX • August 06, 2016
Replaced overload switch and start relay with convenient repair set.Video available on website that gave step by step instructions. Followed the video steps for removal and installation.... plugged in the refrigerator compressor started up everything cool in minutes
Read more
More
$87.27
- Compare At:
-
$104.72
- You Save:
-
$17.45
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304491944
This kit includes the electrical components needed to start your refrigerator's compressor motor, including both the start relay and overload protector. These parts work together to provide the initial electrical boost needed to start the compressor and protect it from electrical overload. Replace this kit if your refrigerator isn't cooling, makes clicking noises, or if the compressor won't start.
Do-It-Yourself Stories from Customers like You
Smelled bad all of a sudden Austin K. • Chowchilla , CA • May 10, 2014
The smell was bad. Burnt wires but smelled like it could be a critter. Saw that the starter relay smoked after a cycle. Ordered the part.(sunday). Part recieved on Monday. Installed in less than ten minutes. Wife was happy. Also the website had a video of how to replace the part. Very satisfied??
Read more
More
$114.95
- Compare At:
-
$136.79
- You Save:
-
$21.84
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304524331
Interior light stays on or won't turn on? This upright freezer door switch controls lighting when the door opens and closes. Simple fix for most DIYers.
More
$57.39
- Compare At:
-
$68.29
- You Save:
-
$10.90
Genuine Broan part
By: Broan
Part Number: S97011238
Fan or light not responding? Intermittent operation or loose controls? This range hood switch restores reliable on/off control. Simple DIY fix.
Do-It-Yourself Stories from Customers like You
Kitchen downdraft unit not functioning Melvin S. • Spring Valley , CA • June 24, 2014
Called a close friend, does all or most repairs around home for years. Dismantled downdraft unit and discovered a bad switch. Was able to ascertain part number and manufacturer. One phone call managed to locate part in stock. Ordered and part arrived in express time!. Friend came yesterday, installed part and put assembly back together. Unit works like new. Great thanks for all the help from Appliance Parts Pros.
Read more
More
$50.26
- Compare At:
-
$60.31
- You Save:
-
$10.05
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10295048
If your electric range burner won't heat properly or won't turn off, this infinite switch controls power to the surface element. Moderate DIY repair.
More
$84.95
- Compare At:
-
$100.24
- You Save:
-
$15.29
Genuine Bosch part
By: Bosch
Part Number: 00166635
Wax motor for detergent/rinse-aid dispenser.
Do-It-Yourself Stories from Customers like You
Soap dispenser door wouldn't open David H. • San Francisco , CA • May 15, 2015
Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks.
Read more
More
$29.68
- Compare At:
-
$35.02
- You Save:
-
$5.34
Genuine Ge part
By: Ge
Part Number: WE4M407
Fix a dryer that overheats or won't heat properly with a new temperature switch. Controls heat settings across multiple cycles. DIY-friendly repair.
More
$112.45
- Compare At:
-
$132.69
- You Save:
-
$20.24
Genuine Lg part
By: Lg
Part Number: 0CZZJB2014G
This capacitor stores and releases electrical energy to support the appliance's circuit during startup and operation. Replacing a weakened capacitor can restore reliable performance and reduce humming, hard starting, or stalling in the affected component.
- Provides a power boost at startup and helps stabilize voltage during operation
- Helps the connected component start promptly and operate smoothly under load
- Common failure signs include humming, slow or no start, or intermittent operation
- Contribute to overheating or a tripped breaker/fuse when the component tries to start
What's included: One capacitor. Install notes:
- Disconnect power at the breaker or unplug the appliance. Before handling, safely discharge the old capacitor using a proper resistor-rated tool.
- Photograph or note wire positions; move each lead to the same-labeled terminal on the new capacitor and ensure snug connections.
- Mount the capacitor securely in its bracket; keep terminals covered and clear of metal surfaces.
Do-It-Yourself Stories from Customers like You
Loud clicking from the back of my refrigerator Randy W. • Granbury , TX • March 04, 2015
Research question lead to others that had the same issue. Consensus lead to a common repair. Compressor overload switch going bad. After ordering the correct parts, I changed out both the switch and the motor start capacitor just in case. After cleaning the equipment, I then put everything back together. Results were, clicking gone, seems to be quieter operation because of cleaning, more efficient cooling and nerves calmed.
Read more
More
$43.79
- Compare At:
-
$52.11
- You Save:
-
$8.32
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304491942
Refrigerator not cooling but running? This compressor start relay and overload kit fixes weak or failed start components. DIY repair in 20 minutes.
Do-It-Yourself Stories from Customers like You
Bad start relay David S. • Knoxville , TN • July 12, 2015
Wake up the morning after a big fourth-of-July cookout to find the refrigerator is running, but not cooling any more. Wife is mad, food is spoiling, and the kitchen is littered with every cooler in the house. No repair person can come by to look at the refrigerator for at least five days. I narrow down the problem to the start relay and I was able to find the exact part on AppliancePartsPros.
With two-day shipping, I get the part fast, and the kit came with everything I need (and then...
Read more
More
$97.61
- Compare At:
-
$116.16
- You Save:
-
$18.55
Genuine Broan part
By: Broan
Part Number: S97009972
Restore dependable control with this replacement switch. It replaces a worn or unresponsive control so your unit responds consistently when operated, helping eliminate intermittent operation and no-response issues caused by fatigued contacts or mechanical wear. What it does
- Controls electrical power to the selected function within the unit
- Can resolve symptoms like no response, intermittent operation, or a switch that sticks or feels loose
- Installs in the original control location for a straightforward replacement
What's included
Install notes
- Disconnect power at the breaker before servicing
- Access the control area and note wire locations or take a clear photo
- Move wires one at a time to the new switch; ensure spade terminals are fully seated
- Test operation before reassembling covers or panels
More
$84.95
- Compare At:
-
$101.09
- You Save:
-
$16.14
Genuine Ge part
By: Ge
Part Number: WR07X10097
Fix clicking sounds and warm temps with this start relay and overload protector. Controls compressor start-up and prevents overheating. 15-minute DIY fix.
Do-It-Yourself Stories from Customers like You
Would not run led dimmed condenser fan would not run Pete M. • Santa Fe , NM • May 16, 2015
We replaced the main circuit board and the LED started to work and the condenser fan worked, but all we had were relay clicking sounds, but no cooling. The compressor had become so hot trying to work when the main circuit board was amiss, that it had popped the over temperature sensor on its side. As some one point out, if you remove the PTC+OLP assembly with the capacitor on it, and shake it, you will hear a rattle inside---and that is bad. We ordered a second round of parts from...
Read more
More
$113.95
- Compare At:
-
$135.60
- You Save:
-
$21.65