Procom Heater Parts

• Will not drain

Removed upper frig & lower freezer back evaporator covers to get to the frost buildup on the evaporator assembly. I then used a paint stripper heat gun to melt the ice build up caution should be used to keep the gun moving around as not to damage Wires,Eva,Sensor's. After 15 to 20 min of clearing frost I was ready to replace Drain Plate's & Thermal fuse's. When I had removed the old Defrost Thermal fuse's in the refrigerator & the freezer they looked different! They had an insulating foam... Read more

• Little to no heat when broiling

Used sites videos to determine element was bad Read more

• No heat or not enough heat

First, let me tell you that this is the fifth appliance I've fixed with parts and help from AppliancePartsPros.com -- At this rate I'll never get to upgrade to nice new appliances. :-( When my wife said the dryer wasn't heating up, I looked online for common causes before I even headed to the basement. A lot of people talk about the fuses going bad, so I figured that's what it was. Next, I watched the videos on how to get to the internals of the dryer. (I hate it when I try to figure it out... Read more

Ordered the replacement part the recommended by your parts department. I then watched a video so I knew what was in Store. The part arrived in less than 2 days & 15 minutes later I was baking brownies!!!!! Voila!!! Done deal!!! Now I am going to order a second one to replace the lower oven's element since it's been 'off' for over a year. The local appliance repair had informed us that it would charge $125 for the initial 30 minute service call to come in to inspect the appliance,... Read more

• No heat or not enough heat
• Takes too long to dry

Replaced the heating element following a video online, went great and fixed the problem. Read more

Need to open because no parts’ numbers can be identified through their website. But the rest “order and put in” are very easy steps. Will come back if I do need other parts Read more

• Little to no heat when baking

Turned off 40 Amp breaker. Removed shelves from oven. Removed two screws in back panel holding element in place. Slowly pulled element free making sure wires stayed attached and not lost in oven insulation. Removed two wires from old element. Attached wires to new element. Pushed wires back into oven rear wall. Reinstalled the previously removed two screws. Turned on breaker. Total time less than 10 minutes. Read more

• Little to no heat when baking

I removed two screws at rear of oven, disconnected electrical connectors, and removed old element. When the new element arrived (on time), I connected the new element and replaced the two screws. The oven worked perfectly! The repair was extremely easy and cost effective. Read more

Simply removed the old heater and replaced it with the new one. Took 10 minutes Read more

Ordered the closest part you had. Replaced the whole unit and it is working fine. Read more

Simple replacement of the heating element. Found multiple videos on youtube that show how to to do this repair. The cooktop is easily opened by removing 3 screws, but I recommend having a second set of hands when performing the repair because you will have to hold up the glass stove top and unscrew the components. The heating element is attached to a bracket that comes off easy as well. Also have to detach 5 wires that mate by sliding together. We took a picture before removing to make... Read more

So I ordered the burner and Ithe switch because I wasn't sure what part was defective. I pulled the oven out and I removed the 6 1/4 inch screws on each side of the glass top as well as the 2 Phillips head screws on the back, removing the 2 1/4 screws on the shield on the back gIves you easier access to them, then lifted the glass top up on the front to access the switch and burners. Make sure you turn the power off before beginning this process. When lifted up the wires connected to the... Read more