Power Small Engine Start Switch Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10411937
Dryer won't start or run? A faulty belt switch often causes this when the belt snaps or slips. This switch monitors belt tension and is a fairly easy fix.
Do-It-Yourself Stories from Customers like You
Drum wouldnt turn power to control panel but wouldnt start Andy S. • Arlington , VA • November 03, 2016
Replaced motor "triple switch" Part Number: AP6021090 and the thermal fuse
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304493153
The Door Switch is an OEM replacement part for Frigidaire wall ovens. It is a component located on the oven door that detects when the door is opened and closed. The door switch works alongside the control board to regulate oven operations based on door position.
Symptoms of a bad door switch can include:
- Oven failing to automatically go into bake or warm modes after door closure
- Interior lights not turning on when the door is opened
- Control buttons/display remaining constantly lit instead of dimming
- Oven not heating or functioning properly in different modes
Causes relate to normal wear over extended use as the door switch mechanism cycles with frequent door openings and closings. Moisture exposure or impacts could also degrade switch performance.
This OEM Frigidaire switch is compatible with Amana, Jenn-Air, KitchenAid, and some Electrolux wall oven models as well.
Do-It-Yourself Stories from Customers like You
Frigidaire microwave oven lights and timer work but oven doesn't heat Reese F. • Essex Junction , VT • August 16, 2015
I diagnosed this problem via the web and the advice was spot on. The problem was a failure of the bottom door switch. I used a multimeter to verify that the switched never closed properly. It took me a minute to figure out how to remove the old switch (press a release tab under the switch while simultaneously rotating counter-clockwise). That was about the most difficult part of the repair.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: W11050715
This replacement switch restores reliable on/off signaling to the circuit it controls, helping your appliance start, stop, and respond correctly. A worn switch can cause intermittent operation, no response, or lights and functions that don't activate. What it does:
- Provides an electrical open/closed signal to enable functions like starting a cycle, powering a motor or light, or shutting a feature off
- Acts as a safety/position interlock (such as door, lid, float, or hood) depending on the model
- Typical symptoms include won't start, won't stop, light won't turn on/off, or intermittent operation
- Can be checked with a multimeter for continuity when actuated
What's included:
Install notes:
- Disconnect power before servicing; turn off gas or water supply if applicable
- Access the switch, note wire locations, and transfer leads one at a time to the new switch
- Mount securely, ensure the actuator aligns and wires aren't pinched
- Reassemble and test operation before finalizing
More
Genuine Ge part
By: Ge
Part Number: WB24T10147
This is a high-amp SPDT (single pole, double throw) switch used in the oven door mechanism. It detects whether the oven door is open or closed and signals the control to enable or disable certain functions such as the oven light or broil element. Replace this switch if the oven light does not turn on or off when the door is opened or closed, or if the oven does not operate correctly in relation to door position.
Do-It-Yourself Stories from Customers like You
Faulty self cleaning latch Gregory K. • Bel Air , MD • December 28, 2016
Replaced faulty latch with new latch. New latch was different configuration, but the fit was okay. The only issue was that the wires to the electric motor were just barely long enough.
Overall easy repair if you have a T15 Torx bit, phillips screwdriver, and 1/4" nut driver. Hardest part is removing the gas cooktop to gain access to the cleaning latch. 0. Turn off electric to stove; remove the cast iron grates, center caps/orifices, and catch pans from the stovetop. 1. Disconnect the...
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10131836
Fix dryer underheating or overheating issues with this 140°F fixed thermostat. Restores accurate temperature control and stops erratic cycling. Easy repair.
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 131298300
Dryer won't heat or overheats? A failed cycling thermostat can't regulate temperature. This direct-fit part takes 15–30 minutes to replace.
Do-It-Yourself Stories from Customers like You
Rubbing blocks and felt that seal the front of the drum are worn drum is sagging and staining clothes with smears of rust Seth W. • Upper Arlington , OH • January 23, 2016
Replaced upper and lower felts. Painted rubbing surface on inside of drum with refrigerator enamel. Took out drum and lubed rear bearing. Replaced 2 of the 3 thermostats, and the belt just on principle.
Spent a lot of time with shop-vac removing lint from drier and exhaust ducts.
Runs great and is no longer cooking or staining clothes.
Read more
More
Genuine Ge part
By: Ge
Part Number: WE1M1002
This CCMR 30-amp, 120-volt fuse protects the appliance's electrical circuit by opening when current exceeds safe limits. Replace a blown fuse to restore power to the affected circuit and help prevent damage to internal components.
- Provides overcurrent protection for the circuit specified by the manufacturer
- If the fuse is open, the appliance may be dead, won't start, or certain functions won't operate
- Helps prevent wiring and component damage from shorts or overloads
- Repeated fuse failures indicate an underlying electrical issue requiring diagnosis
What's included: 1 CCMR fuse (30A, 120V) Install notes:
- Disconnect power to the appliance before servicing
- Locate the fuse in its holder/block and inspect associated wiring for heat or damage
- Test the old fuse for continuity; replace only with the identical rating specified
- Never bypass or upsize a fuse; correct the root cause of the failure before returning to service
Do-It-Yourself Stories from Customers like You
The dryer would not turn on Roland S. • Richmond , CA • August 02, 2014
First I check the breaker for the dryer then I check the power cord and the ohms to the power cord when all this things were in working order I then check the ohms to the fuse to the control panel.
The fuse had no ohms so I got a pair on needle nose pliers pulled out the fuse and replace it worked just find after that
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP22002162
Washer won't spin or door won't lock? This door lock spin enable switch signals the control to start high-speed spin. Moderate DIY repair, 30-60 minutes.
Do-It-Yourself Stories from Customers like You
Washer would not spin in high speed at end of wash Joe Ray S. • Albuquerque , NM • January 19, 2015
Replaced the motor wax door lock switch and the door lock spin enable switch.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP31001590
Fix a dryer that won't heat or overheats with a new thermistor. This temperature sensor ensures accurate heating cycles. DIY repair in 30 minutes.
Do-It-Yourself Stories from Customers like You
Dryer ran but wouldn't heat the only thing i could find was the thremistor only real at 8 ohms instead of a little over 10 Ross M. • Ohiopyle , PA • October 24, 2016
Installed a new thermistor tempiture control and it heats up as it should.
Tools used was a ohlm meter, 1" stiff puty knife, #2 Philips screw driver, neadle nose pliers,1/4 & 5/16 nut drivers.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00611312
This switch is mounted on the dishwasher frame and detects when the door is properly closed to allow the wash cycle to begin. Replace it if your dishwasher won't start even with the door firmly closed, or if it stops mid-cycle unexpectedly.
Do-It-Yourself Stories from Customers like You
Dishwasher would not start. Jason M. • Florence , SC • November 30, 2020
REPLACED DOOR LATCH AND DOOR LATCH ASSEMBLY. EVERYTHING WORKS AGAIN.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: W11162115
Burner stuck on high or won't regulate temperature? The infinite switch controls heat levels. Common DIY repair, typically 10 minutes to install.
Do-It-Yourself Stories from Customers like You
Burner stayed on high when moved to lower heat setting David L. • Melrose , MA • December 27, 2019
I watched an 8-minute video on YouTube. Identified and ordered the part from AppliancePartsPros that a $12 shipping fee was received in 2 days. Took 10 minutes or less to install. Years ago without next-day parts and YouTube, this $60 repair would have cost me $200+.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP31001192
If your dryer is overheating, running too hot, or taking extended times to dry clothes, a faulty cycling thermostat is often the cause. Easy DIY fix.
Do-It-Yourself Stories from Customers like You
No heat on dryer low setting insufficient drying even on high extended times to dry Thomas M. • Galax , VA • June 12, 2016
Ended up replacing the cycling thermostat which corrected the problem. Andrew C. was very helpful with considerations and return of unneeded parts as well as very informative technical assistance. Could not have been treated better.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10178809
Fix a dryer that won't heat or overheats with this cycling thermostat. Regulates heating element temperature for consistent drying. Simple DIY repair.
Do-It-Yourself Stories from Customers like You
Worn or broken thermostat. Nicholas R. • Canyon Lake , TX • March 14, 2024
It’s a simple fix. Unplug the wires and remove the two screws and replace it with the new one.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00629722
This is a spark ignition switch used on a range or cooktop that controls the electric spark to ignite the surface burners when the control knob is turned. It connects to the burner igniter circuit and signals when to fire the spark module. Replace this switch if your burners won't ignite, the spark clicks continuously even after the flame is lit, or the igniter fails to spark when the knob is engaged.
Do-It-Yourself Stories from Customers like You
My dryer started showing error codes. I had the repair company come to look at the oven, they told me that the oven was not repairable. Dominick M. • Tinton Falls , NJ • December 12, 2021
I ordered all the parts from AppliancePartsPros.com and in two days I had every new part that was. Ordered. After being told from the appliance repair company that I wouldn’t get parts for months. I received all parts within 4 days, 19 different parts!
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 318191000
Burner won't heat, stuck on high, or works intermittently? This cooktop burner control switch restores reliable on/off control. Easy DIY repair.
Do-It-Yourself Stories from Customers like You
I am buying a few new replacement parts for my frigidaire 40' range before the need arises they no longer make that size and i had my kitchen changed to fit this range e just iare William M. • Fishers , IN • January 23, 2016
I worked with Bud and he was most helpful. I was very happy with the service that was offered. I liked the quick shipment, good packing and only paying ONE time for shipping.
I would recommend your company again and would ask to deal with Bud again.
Thanks for you service.
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304511344
The Switch is an OEM component specifically designed for Frigidaire washing machines. It controls various cycle options like water temperature levels, spin speeds, and additional settings like stain removal cycles.
Causes of a bad switch can include water or chemical damage leading to component failure over time, or loose wiring connections causing intermittent issues.
Symptoms of a bad switch include:
- Inability to select wash cycles or adjust settings
- Unresponsive or inaccurate temperature levels
- Lights/displays not functioning as normal
- Error codes indicating switch problems
This OEM Frigidaire replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models. Replace yours today to avoid expensive repairs down the road.
Do-It-Yourself Stories from Customers like You
Damaged switch during Raymond J. • Gretna , LA • October 19, 2026
Replacement
Read more
More