Run Vent Push Button Switch Parts
Genuine Bosch part
By: Bosch
Part Number: 00189008
Burner won't spark or ignite? This spark switch signals the ignition module to light gas burners. Common DIY repair with basic tools, 15-30 minutes.
Do-It-Yourself Stories from Customers like You
Ignition spark would not work n one burner Shenton O. • Seattle , WA • September 28, 2017
Took out igniter module and porcelain was cracked. Replaced with ordered part and it worker fine!
Read more
More
$35.95
- Compare At:
-
$42.78
- You Save:
-
$6.83
Genuine Bosch part
By: Bosch
Part Number: 00414825
The Vent Control Button is an OEM component specifically designed for select Bosch downdraft ventilation ranges. Pressable from the countertop, its reliable switch operates the vent position. Precise guidance aligns ductwork airflows.
Symptoms of a faulty control button may include intermittent or unresponsive vent movement. Over-activation degrades contacts requiring change.
Causes of a bad button relate to typical contact wear reducing conductivity. Splashes introduce moisture necessitating replacement over time.
Causes of a bad vent control button involve:
- Vents remaining stuck open exposing grease-laden air
- Closed vents trapping cooking emissions near surfaces
- Failure to change vent direction as needed
This OEM Bosch part is also compatible with some Thermador, Dacor, and Viking downdraft ventilation ranges. Replace to maintain convenient vent management directing smoke and odors safely outdoors.
Do-It-Yourself Stories from Customers like You
Broken downdraft switch James S. • Sunnyvale , CA • May 03, 2018
Found replacing the switch to be doable, but it was quite a delicate operation. This was for a Thermador range with a broken downdraft switch. It required the removal of 5 small screws which could easily be fumbled and dropped down where it would be difficult, if not impossible to retrieve. Two of the screws were facing the back, so it was a blind operation to remove and replace the screws. Required an offset screwdriver, as space was tight. So, be EXTREMELY careful to not drop the screws and...
Read more
More
$9.95
- Compare At:
-
$11.94
- You Save:
-
$1.99
Genuine Whirlpool part
By: Whirlpool
Part Number: 12001514
Washer won't start or fill with water? A faulty lid switch assembly with fuse is often the cause. DIY-friendly repair—most complete it in under an hour.
Do-It-Yourself Stories from Customers like You
Bad lid switch assembly Jim A. • Navarre , FL • March 15, 2014
Removed front and top panels of washer, removed old switch assembly. Then mounted and hooked up new switch assembly, put panels back on, turned on power and unit now works fine. Thanks for the quick delivery on the part...our total machine down time was only 36 hours. Biggest difficulty was getting the machine out of its position to work on it!
Read more
More
$132.95
- Compare At:
-
$158.21
- You Save:
-
$25.26
Genuine Whirlpool part
By: Whirlpool
Part Number: W10339334
Fix a washer that won't fill properly or overfills with this pressure switch. Controls water level sensing. DIY-friendly repair, about 5-10 minutes.
Do-It-Yourself Stories from Customers like You
Switch control water volume from small medium high was not function get stuck and not able to turn Ty L. • Gaithersburg , MD • August 10, 2014
After the part arrives, I was double check to make sure I got the right part. Importantly, unplug the electrical power first before do anything, also turn off the water hose for safety.
Then removed 4 screw out side panel and 2 screw in side to get lose.
After all, replaced a new part and put all panel and screw back together.
Finally, plug in electrical power then a water hose and test a new part just installed.
So far so good, seem like everything was function OK.
Again, thanks for your web...
Read more
More
$130.45
- Compare At:
-
$155.24
- You Save:
-
$24.79
Genuine Ge part
By: Ge
Part Number: WB23K34830
If your cooktop burner is stuck on high or won't adjust temperature, the infinite control switch likely failed. This part controls heat levels.
Do-It-Yourself Stories from Customers like You
We couldn't control the burner temperature. Steven A. • New Carlisle , OH • December 20, 2021
The parts are under the stovetop and the knobs are attached to them. We bought the correct ones from AppliancePartsPros, these were the correct ones. Seems we have an oddball stovetop. It's a GE drop in stove. The parts were easy to change. It was a simple matter of putting the wires on the new switch in the same place there were on the switch. I took phone pics of the wire locations before I took them off and only did one switch at a time. Turn the power off at the breaker panel first of...
Read more
More
$56.34
- Compare At:
-
$66.48
- You Save:
-
$10.14
Genuine Whirlpool part
By: Whirlpool
Part Number: WP74011493
Replacement control knob for range burners. Installs on the control shaft to adjust heat levels. Replace if cracked, broken, markings worn off, or missing.
Do-It-Yourself Stories from Customers like You
Worn over gasket and knobs Thomas M. • Sequim , WA • October 03, 2014
We recently purchased a house with Jenn-Air appliances. The previous owner had used something to clean the knobs on the stove that removed the imprint. Ordering these was easy, they fit with no problem and are manufacture initial product quality. Very Pleased.
The only suggestion I would have is to provide instructions on how to install the oven door gasket. I have not attempted that yet but will soon.
Read more
More
$44.24
- Compare At:
-
$52.65
- You Save:
-
$8.41
Genuine Whirlpool part
By: Whirlpool
Part Number: WP89503
Size: 5 foot long. Rubber fill hose used on most automatic washing machines. Two hoses used per machine.
Do-It-Yourself Stories from Customers like You
Low water flow and fabric softener would dispense immediately when cycle started Bob G. • Sylacauga , AL • January 19, 2019
Replaced flow meter and control valve
Read more
More
$19.31
- Compare At:
-
$22.79
- You Save:
-
$3.48
Genuine Frigidaire part
By: Frigidaire
Part Number: 134813600
This door switch senses whether the appliance door is closed and signals the controls to run only when it's safe. Replacing a worn or intermittent switch restores dependable starts and proper shutoff when the door opens. What it does:
- Detects door position and allows operation only when the door is fully closed
- Interrupts operation when the door opens for safety
- Common symptoms include: won't start, stops when the door is moved, or "door open" message/error
- Intermittent starts due to worn actuator or internal switch contacts
What's included:
Install notes:
- Disconnect power before servicing
- Access the switch from the front or top panel; release mounting screws or tabs
- Move wires to the new switch one at a time to maintain correct positions, then secure the switch
- Test operation before reassembly
More
$51.21
- Compare At:
-
$60.43
- You Save:
-
$9.22
Genuine Frigidaire part
By: Frigidaire
Part Number: 240505801
Fix a refrigerator light that won't turn on or off when the door opens or closes. This door-activated light switch is a simple 5-minute DIY repair.
Do-It-Yourself Stories from Customers like You
Broken ice dispenser actuator, rusty front plate, bad fridge door switch Michael A. • Garnerville , NY • August 06, 2020
My problem started with a rusting condition in the ice bin that spiraled out of hand. I took apart the ice bin and all the hardware thinking I could clean it with the suggested baking powder. Plastic parts cleaned up like new, metal parts were pitted. I wire brushed and sanded the parts put it all back together and gave it a try. All appeared fine then two days later the ice dispenser stopped. I watched a couple of videos and most pointed to the ice auger motor. One video specifically said you...
Read more
More
$58.95
- Compare At:
-
$70.15
- You Save:
-
$11.20
Genuine Frigidaire part
By: Frigidaire
Part Number: 241613501
Humidity control slide for refrigerator crisper drawers. Replace if broken, cracked, or missing to restore adjustable ventilation for fresh produce storage.
Do-It-Yourself Stories from Customers like You
I had several broken items. The two crisper's, the cover and the door rack. Irma C. • Bronx , NY • March 08, 2018
I didn't know the model number of my refrigerator since it has been removed while cleaning. I looked at the models on this site and matched up my refrigerator. I ordered the parts that I needed hoping that they were the right ones. I ordered anyways because of the ability to return if needed (that was important). My majority of my order came the very next day. Thankfully all the items fit perfectly into the refrigerator. I removed one item and put in the new one with ease. I have a new...
Read more
More
$10.45
- Compare At:
-
$12.33
- You Save:
-
$1.88
Genuine Whirlpool part
By: Whirlpool
Part Number: W10911303
Burner won't heat or stuck on one temperature? This infinite switch controls your range surface element heat levels. DIY repair restores precise cooking.
Do-It-Yourself Stories from Customers like You
Oven fan code & all knobs needed to be replaced. Craig L. • Avon , CO • November 08, 2020
I was able to clean the Oven Temp Sensor with 99% alcohol. Then replaced All switches (after breaker was isolated). Put it all back the way I found it. Turned on breaker. Tested all functions and had no reports of Fan Code re-appearing since.
Read more
More
$73.95
- Compare At:
-
$88.00
- You Save:
-
$14.05
Genuine Whirlpool part
By: Whirlpool
Part Number: W11211501
This is a stainless-finish control knob that mounts on the front panel of your range and is used to adjust the flame level on a surface burner. The knob attaches to the valve stem and allows you to turn the burner on, off, and to the desired heat setting. Replace it if the knob is cracked, the markings are worn off, or if it spins freely without engaging the valve stem.
Do-It-Yourself Stories from Customers like You
The knob just broke off. Dana S. • Buffalo , NY • January 07, 2024
Ordered a new knob.
Read more
More
$62.61
- Compare At:
-
$74.51
- You Save:
-
$11.90
Genuine Ge part
By: Ge
Part Number: WB23K10003
Fixes burner stuck on high or no heat issues. This infinite switch regulates cooktop element temperature by cycling power on and off. Simple replacement.
Do-It-Yourself Stories from Customers like You
Control element went out Rita S. • Linton , IN • June 01, 2015
Just a simple install my maintenance man just put it in with no problems.
Read more
More
$47.67
- Compare At:
-
$56.73
- You Save:
-
$9.06
Genuine Ge part
By: Ge
Part Number: WH01X24376
Replacement button tree assembly for washer control panels. Restores reliable button function when selector buttons are missing, cracked, or unresponsive.
Do-It-Yourself Stories from Customers like You
Washer would not run or would not complete cycle Gary B. • Fenton , MO • December 09, 2025
Replaced button tree.
Read more
More
$10.53
- Compare At:
-
$12.64
- You Save:
-
$2.11
Genuine Whirlpool part
By: Whirlpool
Part Number: WP22003993
The Dryer Timer Knob is an OEM replacement part for Whirlpool dryers. It allows users to set the drying time and cycle, providing control over the dryer's operation. This knob fits securely onto the timer shaft, and it allows for the selection of the desired drying cycle and time.
Color: White with Blue Trim
Cap Sold Separately
Over time, wear and tear, excessive force when turning, or accidental impact can cause the timer knob to crack, loosen, or lose its grip on the timer shaft. This makes it difficult to select and maintain accurate drying cycles.
Symptoms of a faulty Dryer Timer Knob include:
- Difficulty turning the knob to select the desired cycle
- Knob slipping or turning loosely
- Cracks, breaks, or missing parts
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
Do-It-Yourself Stories from Customers like You
Not heating dryer ran all night Cheryl R. • Temecula , CA • July 19, 2019
Watched the video and in 5 mins I was all done, very easy.
Read more
More
$29.48
- Compare At:
-
$35.08
- You Save:
-
$5.60
Genuine Whirlpool part
By: Whirlpool
Part Number: WP74011550
Replace your cracked, broken, or worn range control knob. Push-on design installs on the control switch shaft. Restores full functionality to your cooktop.
Do-It-Yourself Stories from Customers like You
Replaced cracked ceramic stove top. Thomas G. • Christiansburg , VA • May 16, 2020
Ordered new cook top, arrived in 2days. Replacement was very easy. Part was perfect fit and had same markings as factory top.
Repair only required a philips head screwdriver. Removed 8 screws holding top on, lifted front up and unplugged two electrical connectors, them removed top. Flipped top over and removed the four burners (8 screws). Moved burners to new top, installed 8 screws, set top on stove, reattach electrical connectors, then reinstall 8 screws to hold the top on.
Only issue I...
Read more
More
$45.30
- Compare At:
-
$54.36
- You Save:
-
$9.06