Power Strike Small Engine Regular Starter Parts

• Takes too long to dry
• Doesn't shut off

I researched the issue on You tube and found out it could be either the "belt broke switch" or the Moisture sensor. A friend who was an appliance mechanic advised "since you have to take it all apart anyways, its best to replace the belt, spring, and Idler wheel" I bought the 5 item for $52. I watched the video on the AppliancePartsPros for changing out the belt and I replace all items on the list. Took 1 1/2 hrs and was fixed on restart!! * Wear gloves, the sheet metal is very sharp edges!* Read more

I tried to buy a new refigerator, but strangely none of the major stores had anything I wanted in stock. The earliest delivery date for a new unit was over a month away. At that I decided to try and keep this one running. I did online research into common refigerator problems. I found the cooling coils in the freezer were covered in a block of ice and frost. The refigerator was not going through a defrost cycle. With a hair dryer I thawed out the coils. The refigerator worked fine for... Read more

After I cleaned out the typical 1.5 pounds of lint from the vent, ( I do it every 2 months), I went searching for a solution. I found 6 possible causes on this site and purchased everything except a new burner; I wasn't going to go that far. Let the fun begin. Since my vacuum was still nearby, I thought I was ready for anything. Wrong. After I watched all the videos again for reassurance, I went in with screwdriver in hand and laptop nearby. I removed the top and looked inside. Don't be fooled,... Read more

• Too hot
• Shuts off too soon

I posted the following on the Facebook page ; SOoooo my 10 year old clothes dryer stopped and like almost everyone else I just figured it's shot, burned up, gotta get a new one. Well, due to a few bumps in the road I cannot afford another problem. My 2 vehicles are not running and with one being in the shop for 3 weeks and not being able to afford a rental car anymore this dryer was another headache. It sat for weeks and laundry started piling up. While looking online for sales somehow I... Read more

• Won't start
• Lid or door will not open
• Lid or door won't close

Video on the appliance pros site was great. Very clear and guided me through every step, I think anyone can feel confident making this lid switch repair. Read more

• No heat or not enough heat

Changed out high limit thernasstat Read more

We watched a YouTube video on how to replace the door latch. Very simple to do. We had to remove the metal band holding the door gasket to be able to access the latch. After removing the band, we pushed aside the gasket and removed the screws to the latch and the connecting cables. To install the new part, we just reversed the process. We reconnected the cables, inserted the new door latch and screwed it in. The hardest part of the process was getting the metal band around the gasket. It... Read more

• Too hot
• No heat or not enough heat
• Shuts off too soon
• Takes too long to dry

This Maytag dryer was bought in 1985 if memory serves. It has worked hard with few repairs done by yours truly over the years. Thanks to the engineering and excellent design by Maytag staff, removing parts are relatively easy. Once I opened the unit, I found it to be full of lint. I cleaned the entire inside and the vent pipe duct work. I found the blower wheel assembly worn. Though it was not cause of my problem, I decided to change it along with the igniter, heater relay and the fan belt. I... Read more

Replaced control board. Did not need Control Thermistor in my case, but I'm keeping it as backup. Got the Drum Belt just in case it breaks on me since the dryer is aging. To replace control board: Disconnect power and pull dryer away from wall. Take 2 black screws on the back off to remove the top lid. Remove 2 screws on top that hold the control interface on. Remove 2 screws on the bottom backside of the control. Pull out control panel and pull off terminal connections and push to remove... Read more

• Won't start
• Door latch failure
• Door won't close

I turned off the power then removed the six or so screws from the back of the top panel. I marked the two front wires on the latch with tape so I would not get them confused. I removed the two screws holding the latch on--these take a six pointed star bit on the screw driver--the bit is in most screw driver sets with interchangeable heads. I then connected the wires to the new latach and put everything back together. The whole process took between ten and fifteen minutes. Read more

Replaced door strike and door latch Read more

First I check with Appliance Part Pros, watch videos how to access the parts I believe to be the problem. I love there videos and parts list of solutions to fix what it wrong. First I removed the washer from the laundry room and but it in the garage for more room to work on it. The next thing I replaced was the door lock which seem to be a possible cheap fix and does get a lot of abuse, however it was not the door lock and people should stop posting it could be this issue when they get a F06... Read more

• Lid or door won't close
• Lid or door will not open

I removed the two screws and all the pieces that were broken. Went online to Appliance parts.com, searched for the part using the model number from the machine and ordered the part . part arrived in 2 days and with a Phillips screwdriver was installed in less than 5 minutes. Read more

• Fridge too warm

Replaced the Thermistor Assembly and also picked up Overload Protection circuit per the comments posted by the "experts" on the web site. Both parts cheap enough. I ordered parts at 3:30 in the afternoon and they showed up the next morning from half way across the country. Outstanding service. It also fixed the 9 year old refrigerator. Replacing the parts took about a half hour most of which was moving the unit from the wall and removing the panel to get at the parts. Read more

I tried to buy a new refigerator, but strangely none of the major stores had anything I wanted in stock. The earliest delivery date for a new unit was over a month away. At that I decided to try and keep this one running. I did online research into common refigerator problems. I found the cooling coils in the freezer were covered in a block of ice and frost. The refigerator was not going through a defrost cycle. With a hair dryer I thawed out the coils. The refigerator worked fine for... Read more

I easily found the replacement part on the Appliance Parts Pros website and ordered (2), one for each end of the handle and yes it is the same part for either side. They showed up a few days later. I had seen a video of how to expose the handle screws behinf the door face. I backed out the appropriate (6) Torx screws and the front of the dishwasher door came right off exposing the handle screws. (Note: This model of dishwasher is well engineered as the door face is completely separated from the... Read more