Incoming Power Problem Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8577891
Fix a dryer that overheats or blows thermal fuses with a new high-limit thermostat. This safety part opens the heater circuit at high temps. 30-min repair.
Do-It-Yourself Stories from Customers like You
Well my dryer kept sutting down when warm showing a af code Dominick S. • Modesto , CA • September 11, 2016
Unpluged dryer unscrewed vent hose used nut driver to remove back pannal then took flat head screw driver to bend tab on heating elment caseing and pry carefully the electrical conector away from elment conection to remove thermostat then i placed the new thermostat on tap and pushed elctrical conetion back onto heater element conection till everything was thight and didnt wiggle dryer works well now
Read more
More
$57.39
- Compare At:
-
$68.87
- You Save:
-
$11.48
Genuine Frigidaire part
By: Frigidaire
Part Number: 134711200
Fix a dryer that won't shut off automatically or has temperature control issues. This thermistor sensor monitors heat levels for proper cycle operation.
Do-It-Yourself Stories from Customers like You
It was taking to long to dry Peter H. • Williston , ND • October 22, 2017
I replaced the thermostat. The bearing on the motor was getting loose, so I changed the motor to.
The repair took about 2 hours.
There are some good re[air videos on the parts web site.
Read more
More
$53.95
- Compare At:
-
$63.66
- You Save:
-
$9.71
Genuine Whirlpool part
By: Whirlpool
Part Number: W10853313
Genuine Whirlpool OEM moisture sensor bar for electric and gas dryers. Works with a second sensor strip to detect humity/moisture as clothes tumble past. The control board reads the signal to determine remaining moisture and ends the cycle automatically at the target dryness level — preventing over-drying and reducing energy use.
Common Failures
- Cycle ends too soon — clothes still damp
- Dryer won't shut off — runs continuously
- Error codes F:22 or F:26
- Inconsistent results — unpredictable dryness
- Bent, cracked, or detached bar
- Corrosion from dryer sheet chemicals
Do-It-Yourself Stories from Customers like You
The dryer sensor failure. Jim W. • Yukon , OK • January 08, 2024
Purchased a new sensor from AppliancePartsPros.com. Installed new part - Problem fixed.
Read more
More
$50.57
- Compare At:
-
$60.18
- You Save:
-
$9.61
Genuine Ge part
By: Ge
Part Number: WE4M300
Fix a dryer that won't heat with this outlet backup thermostat. Mounts on exhaust duct for over-temperature protection. DIY repair in under 1 hour.
Do-It-Yourself Stories from Customers like You
Gas dryer was not heating Charles M. • Huron , OH • September 01, 2016
Checked vent first to see if there was a blockage.
Removed top, front and drum of dryer.
Replaced all sensors including flame detection and gas valve coils.
Re-assembled and tested.
Dryer was now heating
Read more
More
$60.39
- Compare At:
-
$71.86
- You Save:
-
$11.47
Genuine Whirlpool part
By: Whirlpool
Part Number: WP35001092
Dryer won't heat or overheats? A faulty thermostat fails to regulate temperature. This common repair restores reliable heating in 30-60 minutes.
This part fixes the following symptoms
-
Takes too long to dry
-
Doesn't shut off
See more...
Do-It-Yourself Stories from Customers like You
Dryer would not get hot William D. • Salem , OR • February 03, 2015
Changed Thermistor, Thermostats and the Thermal Fuse Assembly. I did not remove drum, so squeezing my hands in-between drum and vent hose pipe to remove screws was a tight fit, but doable.
Read more
More
$51.62
- Compare At:
-
$60.91
- You Save:
-
$9.29
Genuine Whirlpool part
By: Whirlpool
Part Number: WP503979
Fix a dryer that overheats, won't dry completely, or stops mid-cycle. This cycling thermostat regulates heat to prevent damage. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
Bad thermal fuse Orville L. • Winneconne , WI • October 02, 2015
I replaced the main parts for the dryer cycle system
Read more
More
$79.95
- Compare At:
-
$95.94
- You Save:
-
$15.99
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8572767
Dryer won't heat? A failed thermal limiter opens the heating circuit when temperatures exceed safe limits. Simple DIY fix restores heat in 15-30 minutes.
Do-It-Yourself Stories from Customers like You
Dryer no heat Everett E. • Portage , MI • November 01, 2015
The thermal cutoff went bad because of lint being trapped in dryer vent and blocked air-flow from dryer. Removed accumilation of lint and installed new thermal -cutoff and thermostat and dryer now works great.
Read more
More
$57.39
- Compare At:
-
$67.72
- You Save:
-
$10.33
Genuine Ge part
By: Ge
Part Number: WE04X25194
Dryer not heating or overheating? This thermostat regulates temperature during the drying cycle. Common DIY repair that restores proper heat control.
Do-It-Yourself Stories from Customers like You
Not getting very hot Gore, R. • Silsbee , TX • November 07, 2025
Did it myself.
Read more
More
$34.55
- Compare At:
-
$41.46
- You Save:
-
$6.91
Genuine Ge part
By: Ge
Part Number: WE4X757
Dryer won't heat or overheats? A faulty safety thermostat fails to regulate temperature. Test for continuity with a multimeter; moderate DIY repair.
Do-It-Yourself Stories from Customers like You
Faulty thermal fuse Phillip D. • Hagerstown , MD • August 23, 2015
Removed lid. Removed switch panel. Suspected open circuit in thermal fuse. Tested it with a multimeter first to confirm it had an open circuit. This part is obsolete. Contacted manufacturer and found part supercedes to a different part number Ordered part. (This website is very efficient. The part arrived with the 1.7 day promise time.) new fuse bracket is slightly larger due to supercession. Marked bolt hole locations and drilled new. Installed fuse. Re-assembled dryer in reverse order....
Read more
More
$67.60
- Compare At:
-
$80.44
- You Save:
-
$12.84
Genuine Frigidaire part
By: Frigidaire
Part Number: 134711300
Fix dryer heating issues with this thermistor temperature sensor. Solves intermittent heat, cycle errors, and poor drying. Easy DIY repair.
Do-It-Yourself Stories from Customers like You
No heat burner running 30 seconds at a time then turning off John G. • Oxford , MI • September 02, 2019
Replaced all sensors, limiters, thermistors, thermostat. Works great now.
Read more
More
$56.95
- Compare At:
-
$68.34
- You Save:
-
$11.39
Genuine Frigidaire part
By: Frigidaire
Part Number: 131298300
Dryer won't heat or overheats? A failed cycling thermostat can't regulate temperature. This direct-fit part takes 15–30 minutes to replace.
Do-It-Yourself Stories from Customers like You
Rubbing blocks and felt that seal the front of the drum are worn drum is sagging and staining clothes with smears of rust Seth W. • Upper Arlington , OH • January 23, 2016
Replaced upper and lower felts. Painted rubbing surface on inside of drum with refrigerator enamel. Took out drum and lubed rear bearing. Replaced 2 of the 3 thermostats, and the belt just on principle.
Spent a lot of time with shop-vac removing lint from drier and exhaust ducts.
Runs great and is no longer cooking or staining clothes.
Read more
More
$52.76
- Compare At:
-
$62.78
- You Save:
-
$10.02
Genuine Whirlpool part
By: Whirlpool
Part Number: WP31001192
If your dryer is overheating, running too hot, or taking extended times to dry clothes, a faulty cycling thermostat is often the cause. Easy DIY fix.
Do-It-Yourself Stories from Customers like You
No heat on dryer low setting insufficient drying even on high extended times to dry Thomas M. • Galax , VA • June 12, 2016
Ended up replacing the cycling thermostat which corrected the problem. Andrew C. was very helpful with considerations and return of unneeded parts as well as very informative technical assistance. Could not have been treated better.
Read more
More
$79.24
- Compare At:
-
$94.30
- You Save:
-
$15.06
Genuine Whirlpool part
By: Whirlpool
Part Number: WP31001590
Fix a dryer that won't heat or overheats with a new thermistor. This temperature sensor ensures accurate heating cycles. DIY repair in 30 minutes.
Do-It-Yourself Stories from Customers like You
Dryer ran but wouldn't heat the only thing i could find was the thremistor only real at 8 ohms instead of a little over 10 Ross M. • Ohiopyle , PA • October 24, 2016
Installed a new thermistor tempiture control and it heats up as it should.
Tools used was a ohlm meter, 1" stiff puty knife, #2 Philips screw driver, neadle nose pliers,1/4 & 5/16 nut drivers.
Read more
More
$59.48
- Compare At:
-
$70.78
- You Save:
-
$11.30
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10131836
Fix dryer underheating or overheating issues with this 140°F fixed thermostat. Restores accurate temperature control and stops erratic cycling. Easy repair.
More
$69.95
- Compare At:
-
$83.24
- You Save:
-
$13.29
Genuine Ge part
By: Ge
Part Number: WE1M1002
This CCMR 30-amp, 120-volt fuse protects the appliance's electrical circuit by opening when current exceeds safe limits. Replace a blown fuse to restore power to the affected circuit and help prevent damage to internal components.
- Provides overcurrent protection for the circuit specified by the manufacturer
- If the fuse is open, the appliance may be dead, won't start, or certain functions won't operate
- Helps prevent wiring and component damage from shorts or overloads
- Repeated fuse failures indicate an underlying electrical issue requiring diagnosis
What's included: 1 CCMR fuse (30A, 120V) Install notes:
- Disconnect power to the appliance before servicing
- Locate the fuse in its holder/block and inspect associated wiring for heat or damage
- Test the old fuse for continuity; replace only with the identical rating specified
- Never bypass or upsize a fuse; correct the root cause of the failure before returning to service
Do-It-Yourself Stories from Customers like You
The dryer would not turn on Roland S. • Richmond , CA • August 02, 2014
First I check the breaker for the dryer then I check the power cord and the ohms to the power cord when all this things were in working order I then check the ohms to the fuse to the control panel.
The fuse had no ohms so I got a pair on needle nose pliers pulled out the fuse and replace it worked just find after that
Read more
More
$53.69
- Compare At:
-
$64.43
- You Save:
-
$10.74
Genuine Whirlpool part
By: Whirlpool
Part Number: W10169881
Dryer not heating? A blown thermal cut-off is a common cause. This safety fuse opens if overheating occurs. Test with a multimeter for continuity.
Do-It-Yourself Stories from Customers like You
Dryer was not heating Donna G. • Warsaw , MO • August 02, 2014
The first part we ordered was the heating element. The dryer still wasn't heating so we ordered the thermostat. We received the thermostat, and got it put in the dryer still wasn't heating so I consulted my dryer manual and found out that even though there was electric to the dryer it still might not heat if the breaker was not all the way on, so I reset the breaker and voilà had heat. Working very well now.
Read more
More
$73.95
- Compare At:
-
$87.26
- You Save:
-
$13.31