Slow Clamp Snowblower Engine Foil Parts
Genuine Lg part
By: Lg
Part Number: 4861ER2001P
Secures the door boot gasket in its groove to maintain a watertight seal. Replace if stretched, bent, or broken to stop front-panel leaks. Verify fit.
Do-It-Yourself Stories from Customers like You
Leaking water from bottom of front door. Kirk D. • Gilbert , AZ • February 24, 2020
Turned out that the large gray boot/gasket had finally started to harden and deteriorate right at the bottom where the drain hose is. No surprise it leaked after seeing that. Installing the new gasket (and new clamps which I figured I would replace at the same time) did the trick. Fairly simple install. Do yourself a favor and buy the spring pliers to remove/install the clamps. Well worth the time and hassle they will save you.
Read more
More
Genuine Ge part
By: Ge
Part Number: WH01X10595
Secures components inside your washer to prevent movement, loose connections, and rattling noise. Replace when worn or missing to restore stability.
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10162386
Replace your oven door gasket to restore a heat-tight seal and prevent temperature loss. Fixes doors that won't close fully. Verify fit with your model.
Do-It-Yourself Stories from Customers like You
Door would not remain closed Will S. • Virginia Beach , VA • April 16, 2016
Turns out this kits is specifically designed to correct this known issue. It is covered under Tech Bulletin:TDC-0017B-B.
Very frustrating to not have known this. Suffered with the issue for several years.
Installation was rather easy with the exception of having to pull the unit out of the wall 6 inches to replace the hinge retainer.
Read more
More
Genuine Ge part
By: Ge
Part Number: WB04T10042
Seals the gap around your cooktop control shaft to block spills and debris from entering the control area. Replace if worn or damaged. Verify fit.
More
Genuine Ge part
By: Ge
Part Number: WD01X10104
Secures hoses to fittings for leak-free operation. Replace when worn or corroded to stop drips on fill, drain, or circulation lines. Confirm fit.
More
Genuine Ge part
By: Ge
Part Number: WB04T10039
Seals the gap between your oven door and frame to maintain accurate temperatures. Replace when worn to restore proper heating and prevent heat loss.
Do-It-Yourself Stories from Customers like You
Door gasket on wall oven was bad. John B. • Bethel Park , PA • February 07, 2018
Pulled old one off and installed new.
Read more
More
Genuine Ge part
By: Ge
Part Number: WB35X29722
Seals the gap between your range door and frame to contain heat and steam. Replace when worn or torn to restore efficiency and prevent heat leaks.
More
Genuine Lg part
By: Lg
Part Number: 4930JA3054A
Secures internal components in place to prevent rattling and misalignment. Replace if cracked, broken, or missing. Confirm fit with your model number.
More
Genuine Whirlpool part
By: Whirlpool
Part Number: W10615742
Secures panels and components inside your microwave. Replace if worn, missing, or broken to prevent rattling and loose parts. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
Part was cracked Darryl G. • Lincoln , CA • November 21, 2014
It easily snapped into place
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP71001970
Replacement oven door gasket that creates an airtight seal to prevent heat loss and improve cooking consistency. Replace if worn, cracked, or loose.
Do-It-Yourself Stories from Customers like You
Interior glass broken David K. • North Kansas City , MO • March 24, 2016
Dismantled the door and the part was an exact replacement.
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 154241101
Secures dishwasher thermostat to base for accurate temperature sensing. Replace if loose or broken to prevent overheating. Verify fit by model number.
Do-It-Yourself Stories from Customers like You
My dishwasher was getting overheated several plastic items got melted Pramod M. • Sugar Land , TX • April 04, 2016
So I replaced the hi-temp thermostat and the problem is fixed.
Read more
More
Genuine Ge part
By: Ge
Part Number: WH02X10279
This locking clip secures a mating part—often a control knob—onto its shaft on select laundry appliances. Replacing a worn or missing clip restores a tight fit so controls stay in place and operate as intended during use.
- Locks a knob, lever, or similar component onto its shaft/post to prevent it from slipping off
- Maintains a firm fit to reduce wobble and intermittent control engagement
- Replace if the clip is bent, fatigued, corroded, or missing
- Typical symptoms include a knob that falls off, feels loose, or spins without engaging
What's included: Locking clip only Install notes:
- Disconnect power to the appliance; turn off water supply for washers
- Pull the affected component straight off to access the clip
- Use needle-nose pliers to remove/install the clip; avoid deforming it
- Ensure the clip is fully seated; test for a snug fit before reassembly
Do-It-Yourself Stories from Customers like You
Washer would not spin nor adgitate Jeff A. • Stow , OH • June 28, 2015
Motor control board was flashing 4 times, indicating that the mode shifter had an error. I disconnected the mode shifter's wire from the controller and measured the resistance between the 2 leads with an ohmmeter. Since the reading was infinite, that meant that the mode shifter coil or in-line thermal sensor was electrically open, i.e. bad. As this fix is near a complete tear-down of the washing machine, here are a few tips I discovered. 1) the hub nut is difficult to remove and you need a...
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP486692
The Nut is an OEM replacement part for Whirlpool refrigerators. This small yet essential component is used to secure various parts of the refrigerator, such as shelves, panels, or brackets, ensuring stability and proper alignment. Its durable design ensures reliable performance in the demanding environment of a refrigerator.
Causes of a bad or missing Nut can include wear over time, accidental stripping of threads, or loss during maintenance or repairs. A damaged or missing nut can lead to loose components and reduced functionality.
Symptoms of a bad or missing Nut include:
- Loose or wobbly shelves, brackets, or panels
- Difficulty keeping refrigerator components securely in place
- Rattling or unusual noises during operation
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
Do-It-Yourself Stories from Customers like You
Condenser cooling motor fan was making noise occasionally stopping Jeffrey S. • Montgomery , TX • June 26, 2016
Replaced motor, fan and lock-nut. My repair was on a built in Refrigerator-Freezer so most of the time was spent on pulling out and putting back the unit to get to the area I needed to behind the upper top.
Read more
More
Genuine Ge part
By: Ge
Part Number: WB01T10026
Door pad gasket creates a seal between your oven door and front panel. Replace if worn, cracked, or causing heat loss. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Oven door handle was broken Barry C. • Merritt Island , FL • September 28, 2015
Ordered replacement from appliancepartspro.com and installed. Took maybe 10 minutes to remove old one and instal new.
Read more
More
Genuine Ge part
By: Ge
Part Number: WD1X1392
Secures dishwasher sump to tub, maintaining seal compression to prevent leaks. Replace if corroded or weak. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Leaking pump connector. David M. • Ypsilanti , MI • October 13, 2018
Took the impeller out, removed the pump, replaced connector, put new clamps on, reassembled and checked for leaks. I just followed Arts video, went smooth. Wifes happy, things are good.
Thanks AppliancePartsPros.com
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 5303212828
Quantity of 1 clip.
Note: See kit# 5303922007 and 5304406520.
Do-It-Yourself Stories from Customers like You
The panel was broken and the lid didn't close. Leticia V. • Hidalgo , TX • December 02, 2017
It was relatively easy, we took out the broken lid with the gasket then remove the clips, all of them were ok and we could use them again.
Then we proceed to put the new lid with the gasket and use clips to fasten the lid.
Read more
More