Mover Filter Parts

Ordered a new one thru you. Read more

The video was very helpful, but my KitchenAid model required slightly more steps. Only the two screws in front held the filter housing, same as the video shows, but it has to be removed from the rear. My model did not have the wire brace, only the two front screws held the housing. Shut the water off and pull the electrical plug. Remove the two screws holding the filter housing in the front. Remove the lower panel in the rear at the bottom of the refrigerator. Remove the two screws holding the... Read more

Replace the parts of water filter housing and tube assembly. Read more

Replaced Read more

Took the old one off and put the new one on Read more

Just replaced it. I was amazed to find this website that had the part readily available. Read more

Dishes were 'gritty' with an almost invisible coating of specks smaller than grains of salt. Prior to ordering parts, I had to determine which part(s) needed replaced and which could benefit from a good cleaning. After viewing Appliance Parts Pros YouTube Videos, I removed the Main Manifold (snaps right off) including the Top Spray Arm. I discovered the Flappers of the Docking Station (AP6009888) were worn out and/or missing. I removed the Docking Station simply by popping the old one off... Read more

Replaced housing. That was simple but finding directions in how it I remove top of cabinet was time consuming. After two hours of searching I finally found one article that explained why there were no screws to remove. Read more

Simple fix, just replaced the screen with the new one I ordered from you Read more

Slid in new ones Read more

Ordered a new one Read more

I removed the plastic plate at the top of the microwave (behind the door) by unscrewing two screws with a screwdriver. I then pulled out the old filter, and placed the new one in the designated area. No tools are needed to insert the filter....just a screwdriver to remove/replace the plastic plate. Very simple. Read more

It's bit of a chore in that on my Whirlpool Refrig you need to remove the grill on bottom front and the Utility Panel on bottom rear. Then unscrew the original filter housing and pull it out through the back of utility opening. Remove the two water hoses and put them into new filter house. Reverse the disassembly process to reinstall new filter housing. I'm old and slow so the process took me about 45 minutes. (Note: Unplug electric and turn off water inlet before starting.) Read more

Since the filter can't be disassembled, I had to buy a new replacement. Just removed it from the box & installed it. Read more

Just installed it to the wall & presto... Read more