Jbp85tod1ww Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

• Little to no heat when baking
• Oven not heating evenly
• Won't start
• Element will not heat

Watched AppliancePartsPros.com instruction video. Ordered new oven bake element, which arrived a couple days later. Removed old oven bake elelment. Installed new oven bake element. I am very appreciative of the instructional video. It's a very handy way for me to figure out if it's a do-it-yourself repair or not. In this case, another key thing it pointed out was the fact that the two wires that attach to the oven bake element have a tendency to slip back into the insulation behind the... Read more

• Oven is too hot
• Won't start
• Little to no heat when baking

My mother's GE range was not coming up to full heat (very far from it), and I was hearing a lot of relay-clicking coming from the control board. The heating elements seemed good. I suspected the control board was faulty, but there was a chance that it might be the (*much* less expensive) temperature sensor, so I ordered both from AppliancePartsPros.com (which got the parts to me very fast) so I could try the T-sensor first. After removing the doors and the back panel of the oven, and taking out... Read more

VERY simple fix- you do not even have to pull the range out.. I ordered a new cooktop from Appliance parts Pros. The customer sales rep Alphonso was great and walked me through the general process. I could find no explicit instructions for the repair but I muddled my way through. The fix is simple on Kitchenaid/Whirpool slide in ranges. 1. Open the oven door and remove the two phillips head screws directly below the control panel that hold the panel down.2. Lift the control panel upward and... Read more

Stove is a GE Adora Model JBP63HH2bb. It took me forever to figure out how the burner was attached to the rails. My glass top was different than any instructions found on the internet for changing out a burner. The burners on this one are held to the bottom of the glass cook top by two rails that cross the bottom of the burner assemblies. In order to get too the burners you must remove 4 Phillips screws to lower the rails and burners from the cooktop. I suggest two people do this because... Read more

Looked at YouTube, took it off and figured out which one it was and ordered one from AppliancePartsPros.com. It was very easy. Just tucked the ends in with a screwdriver. Delivery from Appliance Parts was easy and fast. Read more

Tested the power to the unit by turning on the cooktop portion and saw that I had power to all of the burners. Turned the selector knob to broil and saw that the top element would heat up. I then turned off the breaker to the unit. I then decided to take out the baking element to do a continuity test. When I touched it, a 1.5 inch section fell out. Since that concluded my continuity test, I assumed I needed a baking element. After receiving the parts the NEXT DAY (amazingly great service... Read more

With the help of Ms.Kelly Hunt, AppliancePartsPros.com, I was able to locate the correct parts. It took approx. 30 minutes to remove the door and replace the shattered glass and bottom door trim. I wouldn`t hesitate to use this service for future use.The staff is friendly, helpful , knowledgeable and delivery is very fast. Thank you Martin Dobbins Read more

So, in the process of a kitchen remodel my GC managed to lose *both* of the rear plastic supports for my GE stove! The drawer was totally unsupported without the brackets. I managed to find them on your site and see that they were a new and better design (rear mount with screw vs side mount and no firm mounting). The install was a snap and the brackets work excellent. I wish I knew that there was a new design years ago or I would have bought them much sooner! Thanks!! Read more

I ordered the infinite switch control from Appliance Parts Pro on a Wednesday afternoon and it arrived well packaged the next day even though I selected standard shipping. Thank you for the easy ordering and fast delivery! Replacing the old switch was easy: 1. Disconnect the power to the stove 2. Make sure the power is off to the stove 3. Pull 4 burner control knobs off and remove 4 large nuts attached to the 4 burner switches 4. Lift the face plate off and clean previously hidden cooking... Read more

• Little to no heat when baking

I visited Appliance Pros website and indicated the problem we were having etc. Found the suspected part (heating element), went on YouTube and found out how to remove the part from the oven and test it with a multi-meter. Keep in mind I have never used a multi-meter before or made repairs to an oven before. However, I have used Appliance Pros before to fix a refrigerator problem just a month earlier and after watching their video it was a very easy repair. Anyway, I tested the old convection... Read more

• Element will not heat

Ordered recommended part for GE appliance. Change was very simple. Followed instructions on video and removed one wire at a time. Very easy to change 5 to 10 minutes. Read more

The glass was easily replaced. Just a few screws to remove cover then remove bad glass then i dropped in the replacement glass then reinstalled cover. Ithen put the door back in the stove. 15 minute job!!! I was so surprised to see how easy it was!!! Thanks! Part fit perfectly!!! Read more

• Element will not heat

Unplug range. Open oven door to gain access to the cook top lock-down screws, located under the front edge of the cook top. Tip the cook top up and carefully remove it by pulling forward. Set aside in a safe place. Remove old, burned-out, element by removing the single lock tab, located on one of the three mounting posts, then lift up. Leave the wiring attached. Flip the element over and remove the three mounting tabs, making note of their numbered locations. Transfer the mounting tabs to... Read more

Called Appliance Parts - service agent was extremely helpful. Tried to find an assembled piece was unable to do so. Send me the individual parts which were very easy to assemble. Was able to replace entire light assembly, reconnect wire with new terminal end. Light works find just now. Would definitely call again if I needed assistance. Read more

We ordered a new elimate, which was shipped the same day. Very good. Read more