Tappan Bumper, Bushing, Grommet Parts

White plastic spacer that mounts between the oven handle and door. Replace if cracked, broken, or missing to restore proper handle alignment and appearance.

Replace your worn or missing range spacer to restore proper component alignment and spacing. This small plastic part maintains correct clearances inside the unit.

Push-in plug button that covers openings in the oven bottom panel. Replace if cracked, missing, or broken to keep debris out and maintain a clean finish.

This snap bushing is a push-in grommet that secures and protects wiring where it passes through sheet metal openings, helping prevent wire chafing and wear. It's a simple replacement that restores proper wire routing and protection. What it does:

• Holds wiring or harnesses in place at panel openings to prevent rubbing and abrasion
• Cushions wires against sharp edges to reduce the risk of wire damage and shorts
• Maintains correct wire routing to prevent pinching when panels are reassembled
• Common symptom: visible chafed insulation or loose wiring at an opening

• One snap bushing (quantity: 1)

• Disconnect power to the appliance before beginning any work to avoid shock or injury
• Access the panel or opening where the wiring passes through; remove any retaining screws or clips as needed
• Press the bushing into the hole until it snaps fully into place, then route the wire through the center
• Inspect surrounding wire insulation and replace or repair any damaged wiring before reassembly

Shaft bushing for ranges. Installs on moving shafts to reduce friction and provide smooth operation. Replace if worn, cracked, or missing.