Parts for Kitchenaid KSB1575PH0: Unit Parts

Connects the blender motor to the blade assembly. Replace if stripped, cracked, or worn from overloading or blending hard ingredients without liquid.

The Lock Jar is an OEM replacement part for Whirlpool Blenders. Securing the blending jar safely during operation, the lock enables smoothie and food preparation.

Causes of a faulty blender locking jar include normal wear of locking tabs and ridges that hold the jar in place through years of use. Exposure to liquid residue over time may potentially compromise lock performance.

Symptoms of a bad locking jar include:

• Potential tipping or detachment of jar during blending posing spill and injury risks
• Inability to achieve proper suction seal jeopardizing blend consistency
• Lock failure releasing sharp blade assembly with attached jar interior

This is a genuine Whirlpool OEM replacement this part is also compatible with Maytag, Jenn-Air and some Kenmore models.

This painted housing replaces the oven backguard panel to restore the exterior finish and support surrounding controls. It gives a clean, factory appearance where the original housing is dented, scratched, or corroded. What it does:

• Provides the finished exterior backguard for the upper rear area of the range/oven
• Restores mounting and alignment for controls and trim pieces
• Helps protect internal components from incidental contact and debris
• Improves appliance appearance when the original housing is damaged or cosmetically worn

• Designed to install with factory fasteners; keep track of screws and brackets during removal
• Disconnect power to the appliance before beginning service to avoid electrical shock
• Use basic hand tools; avoid overtightening fasteners to prevent paint damage
• If retaining trim or control assemblies, support them during housing removal to prevent damage

Seals the motor shaft opening to prevent liquids from entering the housing. Replace if you notice leaks or moisture around the base. Verify fit with your model.

Power cord for blenders. Connects your blender to the electrical outlet. Replace if damaged, frayed, cracked, or showing exposed wires for safe operation.

Replacement mounting screw for various appliances. Secures components and panels in place. Needed when original screws are stripped, missing, or lost.

Replacement base housing for your blender. Restores the main structural component if the original is cracked, damaged, or broken. Direct fit part.

This is an adjustable leveling foot that threads into the base of the dishwasher to support and stabilize the unit. It allows you to raise or lower each corner so the dishwasher sits level on the floor. Replace this foot if it is cracked, stripped, or missing, which can cause the dishwasher to rock, vibrate excessively, or not align properly with the countertop.

Decorative badge emblem for your blender base. Replaces worn, faded, or missing badges. Adhesive-backed emblem restores original appearance.